Nano-tribological study on a super-hydrophobic film formed on rough aluminium substrates

A novel super-hydrophobic stearic acid (STA) film with a water contact angle of 166^o was prepared by chemical adsorption on aluminum wafer coated with polyethyleneimine (PEI) film. The micro-tribological behavior of the super-hydrophobic STA monolayer was compared with that of the polished and PEI-coated Al surfaces. The effect of relative humidity on the adhesion and friction was investigated as well. It was found that the STA monolayer showed decreased friction, while the adhesive force was greatly decreased by increasing the surface roughness of the Al wafer to reduce the contact area between the atomic force microscope (AFM) tip and the sample surface to be tested. Thus the friction and adhesion of the Al wafer was effectively decreased by generating the STA monolayer, which indicated that it could be feasible and rational to prepare a surface with good adhesion resistance and lubricity by properly controlling the surface morphology and the chemical composition. Both the adhesion and friction decreased as the relative humidity was lowered from 65% to 10%, though the decrease extent became insignificant for the STA monolayer. The project supported by the National Natural Science Foundation of China (50375151, 50323007, 10225209) and the Chinese Academy of Sciences (KJCX-SW-L2)     

Photorefractive Four-Wave Mixing Switches Utilizing Pockels Effect -Longitudinal and Lateral Switches-

We carried out detailed calculations for photorefractive wave-mixing switches based on one of three crystals with high electro-optic coefficients, namely, BaTiO₃, Strontium Barium Niobate (SBN (0.75)), and Potasium Sodium Strontium Barium Niobate (KNSBN). A comparison of results for the three crystals shows that a 0_-cut BaTiO³ crystal is suitable for a longitudinal switch and requires a voltage of about 80 for a 2-mm-thick crystal to induce sufficient phase mismatch. The electrodes must be transparent for the incident and diffracted beams. A 45_-cut SBN (0.75) crystal, however, is suitable for a lateral switch and requires a voltage of about 150 for a 1-mm-wide crystal. The electrodes do not need to be transparent.     

Color Zone Map in Peripheral Vision at Various Illuminance Levels

We measured the entire region of mesopic and photopic vision to determine the color zone covering the visual field with unique red, yellow, green, and blue hue components. Eight kinds of test stimuli in the natural color system (NCS) color notation system were used. These stimuli were presented at horizontal and vertical meridians, and at meridians inclined at 45° angles. The illuminance level was set at six levels: 0.01 lx-1000 lx. The evaluation method measured chromatic, white, and black components as well as the hue component of the stimuli. Results show that the color zone of the retina extended further into the periphery with increasing illuminance; the response of opponent colors y-b was shown to be greater than that of the opponent colors r-g.     

A realistic coronary artery phantom for particle image velocimetry

Myocardial infarction results from the rupture of an atherosclerotic plaque, which occurs in response to both mechanical stress and inflammatory processes. In order experimentally observe flow into atherosclerotic coronary artery morphologies, a novel technique for molding realistic compliant phantom featuring injection-molded inclusions and multiple layers has been developed. This transparent phantom allows for particle image velocimetry (PIV) flow analysis and can supply experimental data to validate computational fluid dynamics algorithms and hypothesis.     

Real-time color holographic interferometry devoted to 2D unsteady wake flows

A new optical technique based on real time holographic interferometry in true colors has been implemented around the transonic wind tunnel of the ONERA-Lille center to analyze 2D unsteady wake flows. Tests realized in color interferometry, real time and double exposure, use simultaneously three wavelengths of a continuous waves laser (argon and krypton mixed) and holograms are recorded on silver-halide single-layer panchromatic Slavich PFG03c plates. The very principle of real-time true color holographic interferometry uses three primary wavelengths (red, green and blue) to record, under no-flow conditions, the interference among the three measurement beams and the three reference beams simultaneously on a single reference hologram. After the holographic plate is developed, it is placed on the test setup again in the position it occupied during exposure and the hologram is illuminated again by the three reference beams and three measurement beams. A flat, uniform color can then be observed behind the hologram. So a horizontal, vertical, or even circular fringe pattern can be formed and the achromatic central fringe can be made out very clearly. The single color is used to determine the path difference zero on the interferograms. The flow studied was the unsteady flow downstream of a cylinder placed crosswise in the test section. A sequence of hundred interferograms was recorded on the flow around the cylinder at Mach 0.37. The vortex formation and dissipation phases can be seen very clearly, along with the fringe beat to either side of the cylinder.     

Biosorption of Chromium(III) by Biomass of Seaweed Sargassum sp. in a Fixed-Bed Column

This work aimed at modeling chromium biosorption using the biomass of seaweed Sargassum sp. in a fixed-bed column. The mathematical model used was obtained from the mass balance of the component in the liquid phase and in the biosorbent material. The effects of both axial dispersion in the column and the resistance to mass transfer in the solid were considered for the solution of the partial differential equations of the model, using the Galerkin method on finite elements. To represent the equilibrium data of the batch system the Langmuir isotherm were used. The chromium ion adsorption capacity of the seaweed Sargassum sp., at a temperature of 30°C and pH 3.5, was 2.61 mmol/g. The model performance was evaluated from experimental data obtained at 30°C for flow rates of 2, 6 and 8 mL/min. The parameters of the model, mass transfer and axial dispersion coefficients, were adjusted from these experimental data. The model proved adequate to describe chromium biosorption dynamics in fixed-bed columns.     

On division rings with algebraic commutators of bounded degree

We shall answer several questions concerning additive or multiplicative commutators in a division ring which are algebraic of bounded degree over its center.     

Seizure warning algorithm based on optimization and nonlinear dynamics

There is growing evidence that temporal lobe seizures are preceded by a preictal transition, characterized by a gradual dynamical change from asymptomatic interictal state to seizure. We herein report the first prospective analysis of the online automated algorithm for detecting the preictal transition in ongoing EEG signals. Such, the algorithm constitutes a seizure warning system. The algorithm estimates STL_max, a measure of the order or disorder of the signal, of EEG signals recorded from individual electrode sites. The optimization techniques were employed to select critical brain electrode sites that exhibit the preictal transition for the warning of epileptic seizures. Specifically, a quadratically constrained quadratic 0-1 programming problem is formulated to identify critical electrode sites. The automated seizure warning algorithm was tested in continuous, long-term EEG recordings obtained from 5 patients with temporal lobe epilepsy. For individual patient, we use the first half of seizures to train the parameter settings, which is evaluated by ROC (Receiver Operating Characteristic) curve analysis. With the best parameter setting, the algorithm applied to all cases predicted an average of 91.7% of seizures with an average false prediction rate of 0.196 per hour. These results indicate that it may be possible to develop automated seizure warning devices for diagnostic and therapeutic purposes.Mathematics Subject Classification (1991):20E28, 20G40, 20C20     

On Einstein four-manifolds with <Emphasis Type="Italic">S</Emphasis><Superscript>1</Superscript>-actions

We study closed Einstein 4-manifolds which admit S¹ actions of a certain type, i.e., warped products. In particular, we classify them up to isometry when the fixed point of the S¹ action satisfies certain natural geometric conditions. The proof uses the Bochner-Weitzenböck formula for 1-forms and the theory of minimal surfaces in 3-manifolds.in final form: 22 January 2003