Base-mediated reactions of N-alkyl-O-acyl hydroxamic acids: synthesis of 3-oxo-2,3-dihydro-4-isoxazole carboxylic ester derivatives

Treatment of malonyl derived O-acyl hydroxamic acid derivatives 10a-h with the phosphazene super base P-2-t-Bu 7 gives 2,3-dihydro-4-isoxazole carboxylic ester derivatives 11a-h. The rate and yield of the reaction is dependent upon the O-acyl substituent.     

Transparent conducting oxides: texture and microstructure effects on charge carrier mobility in MOCVD-derived CdO thin films grown with a thermally stable, low-melting precursor

A series of low-melting, thermally stable cadmium metal-organic chemical vapor deposition (MOCVD) precursors have been synthesized, structurally and spectroscopically characterized, and implemented in growth of highly conductive and transparent CdO thin films. One member of the series, bis(1,1,1,5,5,5-hexafluoro-2,4-pentanedionato)(N,N-diethyl-N',N'-dimethyl-ethylenediamine)cadmium(II), Cd(hfa)(2)()(N,N-DE-N',N'-DMEDA), represents a particularly significant improvement over previously available Cd precursors, owing to the low melting point and robust thermal stability. High-quality CdO films were grown by MOCVD on glass and single-crystal MgO(100) between 300 and 412 degrees C. Film growth parameters and substrate surface have large effects on microstructure and electron carrier transport properties. Enhanced mobilities observed for highly biaxially textured films grown on MgO(100) vs glass are attributed, on the basis of DC charge transport and microstructure analysis, to a reduction in neutral impurity scattering and/or to a more densely packed grain microstructure. Although single-grained films grown on MgO(100) exhibit greater mobilities than analogues with discrete approximately 100 nm grains and similar texture, this effect is attributed, on the basis of charge transport and Hall effect measurements as well as optical reflectivity analysis, to differences in carrier concentration rather than to reduced grain boundary scattering. Unprecedented conductivities and mobilities as high as 11,000 S/cm and 307 cm(2)/V.s, respectively, are obtained for epitaxial single-grained films (X-ray diffraction parameters: fwhm(omega) = 0.30 degrees, fwhm(phi) = 0.27 degrees ) grown in situ on MgO(100) at a relatively low temperature (400 degrees C).     

Synthesis and structural characterization of acetatobis(triphenylphosphine)dicarbonylmanganese(I), (CH3CO2)Mn(CO)2[P(C6H5)3]2: An organometallic complex containing a chelating acetate ligand

The accidental but intriguing synthesis of acetatobis(triphenylphosphine)dicarbonylmanganese(I), (CH₃CO₂)Mn(CO)₂[P(C₆H₅)₃]₂, has been accomplished by the reaction of NaMn(CO)₅ with (CH₃)₃SiCl followed by the addition of triphenylphosphine and acetic acid. A three-dimensional single-crystal X-ray diffraction analysis has shown an octahedral-like molecule containing a symmetrically oxygen-chelating acetate group, the first such group to be reported in a metal carbonyl complex. The two triphenylphosphine ligands occupy mutually trans positions with the two carbonyl ligands possessing the remaining cis sites in the octahedral complex. The compound crystallizes with four molecules in a monoclinic unit cell of space group symmetry $\text{P}\text{2}{}_1\text{c}$ and of dimensions a = 17.744(2) Å, b = 9.692(1) Å, c = 20.004(2) Å, and β = 106.195(4)°. The relatively long MnO(acetate) bond lengths [2.066(6) and 2.069(7) Å] and the relatively short MnCO bond lengths [1.701(12) and 1.760(13) Å] and the relatively short MnP(C₆H₅)₃ bond lengths [2.260(3) and 2.275(3) Å], compared to the corresponding MnCO and MnP(C₆H₅)₃ bond lengths in other manganese carbonyl triphenylphosphine complexes, are rationalized on the basis that the acetate ligand in this molecule functions primarily as a σ-donor.     

An investigation into the construction of molecular models by the template joining method

Summary The results of a wide-ranging investigation into some of the different methods available for performing the joining of templates to build molecular models show that the choice of algorithm can significantly affect the quality of the results obtained, and different algorithms are most suited to particular categories of join.     

De novo synthesis of 4'-ethoxy nucleoside analogues

Butenolides 5a and 13 were used as optically active templates in the de novo synthesis of 4'-disubstituted nucleoside analogues. The butenolides were reduced and acylated in situ to give acetates 10 and 14. Vorbrüggen coupling gave the protected nucleoside analogues 11 and 15. Reduction of 11 gave 4'-ethoxy-2',3'-dideoxythymidine (6) and deprotection of 15 gave 4'-ethoxy-2',3'-dideoxydidehydrothymidine (7). The cis-dihydroxylation of a variety of butenolides occurred with the major product formed from oxidation of the beta-face.     

Dynamic behaviour of river colloidal and dissolved organic matter through cross-flow ultrafiltration system

Through cross-flow filtration (CFF) with a 1-kDa regenerated cellulose Pellicon 2 module, the ultrafiltration characteristics of river organic matter from Longford Stream, UK, were investigated. The concentration of organic carbon (OC) in the retentate in the Longford Stream samples increased substantially with the concentration factor (cf), reaching approximately 40 mg/L at cf 15. The results of dissolved organic carbon (DOC) and colloidal organic carbon (COC) analysis, tracking the isolation of colloids from river waters, show that 2 mg/L of COC was present in those samples and good OC mass balance (77-101%) was achieved. Fluorescence measurements were carried out for the investigation of retentate and permeate behaviour of coloured dissolved organic materials (CDOM). The concentrations of CDOM in both the retentate and permeate increased with increasing cf, although CDOM were significantly more concentrated in the retentate. The permeation model expressing the correlation between log[CDOM] in the permeate and logcf was able to describe the permeation behaviour of CDOM in the river water with regression coefficients (r(2)) of 0.94 and 0.98. Dry weight analysis indicated that the levels of organic colloidal particles were from 49 to 71%, and between 29 and 51% of colloidal particles present were inorganic. COC as a percentage of DOC was found to be 10-16% for Longford Stream samples.     

Intermolecular rhodium-catalyzed [2+2+2] carbocyclization reactions of 1,6-enynes with symmetrical and unsymmetrical alkynes

The crossed intermolecular rhodium-catalyzed [2+2+2] carbocyclization of carbon and heteroatom tethered 1,6-enynes can be accomplished with symmetrical and unsymmetrical alkynes, to afford the corresponding bicyclohexadienes in an efficient and highly selective manner.     

High-resolution electron microscopy of montmorillonite and montmorillonite/epoxy nanocomposites

With the use of high-resolution transmission electron microscopy the structure and morphology of montmorillonite (MMT), a material of current interest for use in polymer nanocomposites, was characterized. Using both imaging theory and experiment, the procedures needed to generate lattice images from MMT were established. These procedures involve careful control of the microscope's objective lens defocus to maximize contrast from features of a certain size, as well as limiting the total dose of electrons received by the sample. Direct images of the MMT lattice were obtained from neat Na+ MMT, organically modified MMT, and organically modified MMT/epoxy nanocomposites. The degree of crystallinity and turbostratic disorder were characterized using electron diffraction and high-resolution electron microscopy (HREM). Also, the extent of the MMT sheets to bend when processed into an epoxy matrix was directly visualized. A minimum radius of curvature tolerable for a single MMT sheet during bending deformation was estimated to be 15 nm, and from this value a critical failure strain of 0.033 was calculated. HREM can be used to improve the understanding of the structure of polymer nanocomposites at the nanometer-length scale.     

Quantum dot nanocrystals for in vivo molecular and cellular imaging

Semiconductor quantum dots (QD) are nanometer-sized crystals with unique photochemical and photophysical properties that are not available from either isolated molecules or bulk solids. In comparison with organic dyes and fluorescent proteins, QD are emerging as a new class of fluorescent labels with improved brightness, resistance against photobleaching and multicolor fluorescence emission. These properties could improve the sensitivity of biological detection and imaging by at least 10- to 100-fold. Further development in high-quality near-infrared-emitting QD should allow ultrasensitive and multicolor imaging of molecular targets in deep tissue and living animals. Here, we discuss recent developments in QD synthesis and bioconjugation, applications in molecular and cellular imaging as well as promising directions for future research.     

Studies into the Diels-Alder reactions of 5-trimethylsilylthebaine

The introduction of a 5-trimethylsilyl group on the least hindered face of the diene thebaine was anticipated to favor attack by dienophiles from the alternate face, but only gave rise to a rearrangement product when treated with 3-butene-2-one at 110 °C. Reaction with the more reactive benzoquinone at lower temperature gave rise to a very slow reaction from the same face as the silyl group, indicating that a trimethylsilyl group does not sufficiently hinder this face to achieve reaction at the other face.