Research on performance of multicasting in optical packet switched networks

Different multicasting schemes in optical packet switched networks are discussed, including the parallel mode, serial mode, and hybrid mode multicasting schemes. Simulated modeling technique is applied to compare the network-level performance of the three multicasting schemes. A conclusion can be drawn from the results that since the hybrid-mode multicasting scheme can increase the multicast success ratio and reduce the packet retransmission times compared with the other two schemes, it is the best choice for delivering multicasting sessions in the optical packet switched networks.     

Precise measurement of the line width of the photoassociation spectra of ultracold molecules by using a frequency shifter

We propose a technique to precisely measure the line width of the photoassociation spectra of the excited cesium molecule by using a frequency shifter to generate two laser beams with a precise frequency difference. A series of photoassociation (PA) spectra are recorded with two laser beam induced molecular lines, whose peak separation serves as an accurate frequency ruler to measure the line width of the PA spectra. The full width half maximum line width was studied as a function of PA laser intensity. The extrapolated value at zero laser intensity is (34.84 ± 0.22) MHz. By analyzing other broadening mechanisms, a value of (32.02 ± 0.70) MHz was deduced. It is shown that this scheme is inexpensive, simple, robust, and is promising for applications in a variety of other atomic species.     

Effects of hydroxyls on the structural and room temperature ferromagnetic properties of Co doped SnO2 nanoparticles

Co doped SnO₂ nanoparticles have been prepared via a wet chemical method with different precipitation processes. The structure and morphology of Co doped SnO₂ nanoparticles demonstrate that the nanoparticles are in a rutile single phase and uniform, respectively. X-ray photoelectron spectroscopy shows that the Co dopants are in 2+ oxidation valence state and doped ∼2 atm% in SnO₂ nanoparticles. Moreover, Raman spectroscopy further confirms that Co doped SnO₂ nanoparticles have single phase crystallinity without forming any extra modes related to secondary phases. The magnetic measurements reveal that all nanoparticles exhibit room temperature ferromagnetism (RTFM) due to the presence of disorders and defects introduced by hydroxyls in the crystal structure. In addition, it has been clearly observed that the saturated magnetic moments are strongly affected by the precipitation processes which control the incorporation of hydroxyls into the lattice.     

Teleportation of three-dimensional single particle state in noninertial frames

Considering the spin degree of freedom of the Dirac field, we study the entanglement behavior of a different class of communication channel and teleportation of three-dimensional single particle state in noninertial frames. Numerical analysis shows that the communication channel in our scheme can offer enough distillable entanglement for the teleportation protocol. Moreover, the teleportation protocol could work well if Rob＇s acceleration is not very big, but the fidelity of the teleportation is still reduced due to the Unruh effect.     

一种中药荧光指纹图谱的光谱图像构建方法

利用液晶光谱仪通过光谱成像法对黄柏和人参总皂甙进行了荧光光谱图像检测,采用滤波器与像素点定位联用的方法提取有效像素点,获取它们的荧光光谱图像,绘制了相应的中药荧光指纹图谱.结合欧氏距离的判定方法,将滤波器与像素点定位联用法、像素点优选法和背景差分算法所得的荧光指纹图谱进行比较,三种方法的差异由小到大的排序为滤波器与像素点定位联用法,背景差分算法,像素点优选法.说明滤波器与像素点定位联用法所得荧光指纹图谱稳定性最好,谱线最优.实验结果表明该方法可以用于构建中药荧光指纹图谱,从而提出了一种新的用于中药指纹图谱构建中提取有效像素点的可行方法.     

Fabrication of widely tunable ridge waveguide DBR lasers for WDM-PON

We report the fabrication of widely tunable ridge waveguide distributed Bragg reflector(DBR) lasers with InGaAsP butt-joint as grating material. The shape of the butt–joint interface is found to have significant effect on the properties of the lasers. It is shown that irregular mode jumps during wavelength tuning can be avoided by a V-shaped butt–joint interface. From the fabricated device, 23 channels with 0.8 nm spacing and greater than 35 dB side mode suppression ratios are obtained. The different tuning characteristics of the ridge waveguide and the previously reported buried ridge stripe DBR lasers are discussed. Combined with the wide tuning range and the simple structure, the ridge waveguide DBR lasers are promising for use in wavelength division multiplexing passive optical networks(WDM-PONs).     

Model study on steady heat capacity in driven stochastic systems

We explore two- and three-state Markov models driven out of thermal equilibrium by non-potential forces, to demonstrate basic properties of the steady heat capacity based on the concept of quasistatic excess heat. It is shown that large enough driving forces can make the steady heat capacity negative. For both the low- and high-temperature regimes we propose an approximative thermodynamic scheme in terms of “dynamically renormalized” effective energy levels.     

多孔脆性介质冲击波压缩破坏的细观机理和图像

本文采用一种具有良好定量性质的离散元模型研究了带孔洞的各向同性脆性介质在细观尺度上的压缩破坏特征. 通过对孤立孔洞、三种简单的孔洞排布方式和大量孔洞随机排布等几种情况的模拟, 认识到了剪切破坏和局域拉伸破坏是冲击波压缩下多孔介质的基本破坏模式; 孔洞之间的损伤贯通会促进孔洞在较低应力下发生塌缩, 但损伤区的应力松弛过程却会对一定范围内的介质起到损伤屏蔽作用; 不同区域中损伤促进和损伤屏蔽的综合效果是在多孔脆性介质中形成一种高损伤区与低损伤区间错排布的奇特损伤分布. 本文的研究结果为深入理解脆性材料冲击波压缩破坏的演化过程和机理提供了细观尺度上的初步物理图像.     

Sequential over-barrier ionization of multi-electron atoms in the tens-to-hundreds keV/u energy range

Our previous work on the classical over-barrier ionization model for helium double ionization is extended to the complex multi-electron system of Ne.The total and q-fold ionization cross sections are calculated at energies ranging from a few tens to several hundred keV/u.The calculation results are in good agreement with the experimental data,and the energy dependence of the cross sections suggests that the multi-ionization of a strong perturbated complex atom is probably the sequential over-barrier ionization process.     

基于动态溶胀法制备中空聚合物微球

以表面带正电荷的m级聚苯乙烯微球为种子,经过甲苯、二乙烯基苯溶胀,聚合与包覆等过程制备了直径约5 m的中空聚合物微球。研究了溶剂类型、溶剂用量对动态溶胀法制备的中空聚合物微球粒径、分布和结构的影响,讨论了中空聚合物微球的形成机理。结果表明:添加一定量甲苯、二甲苯等挥发性溶剂是动态溶胀法形成中空聚合物微球的前提;甲苯用量越多,溶胀后形成的中空结构越明显,孔径越大;选择低溶解性的二甲苯溶剂更有利于中空结构的形成。