Determination of inorganic cations in brine solutions by ion chromatography

The method for analysis of inorganic cations in brine solutions was developed. Ion chromatography is a well-established and accepted technique in the determination of a variety of inorganic ions. However, there are significant complications when ion chromatography is used to determine trace concentrations of inorganic ions in brine matrices. The brine solution in our study was made to simulate the solution from the Waste Isolation Pilot Plant. Instrumental parameters such as eluent composition, flow-rates, and sample loop volumes were investigated to arrive at the optimum condition for the determination of the cations with minimal dilution. Separation was carried out in a Dionex CG12A/CS12A with 8.25 mM H2SO4 as eluent at 1.2 ml/min flow-rate. Our results indicated that ion chromatography is an accurate and a good alternative method for the analysis of cations in brine solution.     

Direct detection of renal function markers using microchip CE with pulsed electrochemical detection

Creatinine, creatine, and uric acid are three important compounds that are measured in a variety of clinical assays, most notably for renal function. Traditional clinical assays for these compounds have focused on the use of enzymes or chemical reactions. Electrophoretic microchips have the potential to integrate separation power of capillary electrophoresis with devices that are small, portable, and have the speed of conventional sensors. The development of a microchip CE system for the direct detection of creatinine, creatine, and uric acid is presented. The device uses pulsed amperometric detection (PAD) to detect the nitrogen-containing compounds as well as the easily oxidizable uric acid. Baseline separation of creatinine, creatine and uric acid was achieved using 30 mM borate buffer (pH = 9.4) in less than 200 s. Linear calibration curves were obtained with limits of detection of 80 microM, 250 microM and 270 microM for creatinine, creatine and uric acid respectively. An optimization of the separation conditions and a comparison of PAD with other amperometric detection modes is also shown. Finally, analysis of a real urine sample is presented with validation of creatinine concentrations using a clinical assay kit based on the Jaffé reaction.     

AlPO4?ZrO2 catalysts, II. Synthesis, textural properties and crystal structure of systems obtained in ethylene oxide

The effects of surface dehydration on textural properties, crystallinity and the structure of AlPO₄–ZrO₂ (weight ratio AlPO₄/ZrO₂=3) systems precipitated with ethylene oxide have been studied by N₂ adsorption and XRD measurements. The increase in calcination temperature in the range 773–1273 K decreases the textural parameters as a consequence of AlPO₄ crystallization to the tridymite form.

---

, AlPO₄–ZrO₂ ( AlPO₄/ZrO₂=3), , N₂ - . 773 1273 , AlPO₄ .

     

Use of dynamically coated capillaries with added cyclodextrins for the analysis of opium using capillary electrophoresis

A rapid, precise, accurate, and robust method using capillary electrophoresis (CE) with dynamically coated capillaries for the analysis of the major opium alkaloids in opium is presented. Dynamic coating of the capillary surface is accomplished using a commercially available reagent kit (polycation coating followed by polyanion coating). The addition of dual cyclodextrins (hydroxypropyl-beta-cyclodextrin and dimethyl-beta-cyclodextrin) to the run buffer imparts excellent selectivity for the opium alkaloids. For the determination of morphine, papaverine, codeine, noscapine and thebaine in opium gum and opium latex samples (using tetracaine as an internal standard) good agreement with values obtained by gradient high-performance liquid chromatography is obtained. Compared to the latter technique, CE affords better resolution with significantly faster analysis time (12 min versus 29 min). Dynamically coated capillaries, which give rise to a relatively high and robust electroosmotic flow (EOF) at the background electrolyte pH of 2.5, allow for rapid analysis and excellent migration time and peak area precision (RSDs < or = 0.12% and < or = 1.2%, respectively). Reproducible separations (relative migration times) for over 500 samples have been obtained on a single capillary. The nature of the injection solvent, the injection time and the contents of the waste vials have a profound effect on the pressure injection precision of the relatively hydrophobic solutes. The CE conditions reported in this study are also applicable to the analysis of lysergic acid diethylamide (LSD) exhibits.     

Simultaneous determination of iron, cobalt, nickel and copper by UV-visible spectrophotometry with multivariate calibration

A method for the simultaneous spectrophotometric determination of the divalent ions of iron, cobalt, nickel and copper based on the formation of their complexes with 1,5-bis(di-2-pyridylmethylene) thiocarbonohydrazide (DPTH) is proposed. The resolution of quaternary mixtures of these metallic ions was accomplished by several chemometric approaches. A comparative study of the results obtained for simultaneous determinations in mixture by using principal component regression (PCR) and partial least-squares regression (PLS-1 and PLS-2) for absorbance, first-derivative and second-derivative data is presented. In general, the best recovery values are obtained by the PLS-2 method for absorbance data. This procedure allows the simultaneous determination of the cited ions in alloys and biological materials Good reliability of the determination was proved.     

Selection of the cis and trans phosph(III)azane macrocycles [{P(mu-NtBu)}2(1-Y-2-NH-C6H4)]2(Y=O, S)

The 1 : 1 reactions of [ClP(mu-NtBu)]2 with the difunctional aromatic amines 1,2-1-YH-2-NH2-C6H4 in the presence of Et3N give the dimeric phosph(III)azane macrocycles [{P(mu-NtBu)2(1-Y-2-HN-C6H4)]2, predominantly as the cis isomer in the case of Y=O (1.cis) and as the trans isomer for Y=S (2.trans). Model M.O. calculations suggest that the selection of the cis and trans isomers is not thermodynamically controlled. The alternative isomers 1.trans and 2.cis are generated exclusively by the deprotonation of the model intermediates [(1-Y-2-NH2-C6H4)P(mu-NtBu)]2[Y=O (3), S (4)] with nBuLi followed by cyclisation with [ClP(mu-NtBu)]2. The solid-state structures of 1.cis/trans(50 : 50), 2.cis, 3 and 4 are reported.     

The reactivity of 2-vinylindoles with dimethyl acetylenedicarboxylate

The overall rates of reaction of 1-substltuted-1- (1-methyl-2-indolyl)ethenes with dimethyl acetylenedicarboxylate are considerably lower than those of the corresponding 2-vinyl- pyrroles. Steric interaction between the N-methyl group on the indole ring and the 1-substituent on the ethenyl group prevents the diene system adopting a coplanar $\text{cisoid}$ configuration and, thereby, inhibits the _π4 + _π2 cycloaddition reaction of the system with dimethyl acetylenedicarboxylate. Under such conditions, the indolylethene preferentially undergoes a Michael addition reaction at the 3-position. The _π4 + _π2 cycloaddition reaction is promoted at elevated temperatures. No evidence was found for a Cope rearrangement of the Michael adducts to give the dihydrocarbazole.     

Asymmetric Induction in the Synthesis of 3,4,5-Trisubstituted Ferrocenyl-4,5-dihydropyrazoles

The asymmetric induction in the synthesis of 3,4,5-trisubstituted 4,5-dihydropyrazoles with ferrocenyl substituents, starting from the E and Z isomers of ,-unsaturated ketones was studied. A high diastereoselectivity was revealed at the 1,2 chiral center chiral center induction, which is independent of the configuration of the starting chalcones.     

(Z)-3-p-tolylsulfinylacrylonitrile as a chiral dienophile: diels-alder reactions with furan and acyclic dienes

The behavior of (Z)-3-p-tolylsulfinylacrylonitrile (1) as a chiral dienophile has been evaluated from its reactions with furan and acyclic dienes. Electrostatic interactions of the cyano group with the sulfinyl one restrict the conformational mobility around the C-S bond, thus controlling the pi-facial selectivity, which is almost complete in all cases, the approach of the diene from the less-hindered face of the dienophile (that bearing the lone electron pair) in the predominant rotamer being the favored one. The regioselectivity is also completely controlled by the cyano group. Additionally, the reactivity of compound 1 as well as its endo-selectivity are both higher than those observed for the corresponding (Z)-3-sulfinylacrylates, thus proving the potential of sulfinylnitriles as chiral dienophiles.     

Separation of proteins with a molecular mass difference of 2 kDa utilizing preparative double-inverted gradient polyacrylamide gel electrophoresis under nonreducing conditions: application to the isolation of 24 kDa human growth hormone

A method for separating proteins with a molecular mass difference of 2 kDa using SDS-PAGE under nonreducing conditions is presented. A sample mixture containing several human growth hormone (hGH) isoforms was initially separated on a weak anion-exchange column. Fractions rich in 24 kDa hGH as determined by analytical SDS-PAGE were pooled and further separated by cation-exchange chromatography. The fractions pooled from the cation-exchange chromatography contained two hGH isoforms with a 2 kDa molecular mass difference according to SDS-PAGE analysis, 22 and 24 kDa hGH. The 22 and 24 kDa hGH were separated using continuous-elution preparative double-inverted gradient PAGE (PDG-PAGE) under nonreducing conditions. The preparative electrophoresis gel was composed of three stacked tubular polyacrylamide matrices, a 4% stacking gel, a 13-18% linear gradient gel, and a 15-10% linear inverted gradient gel. Fractions containing purified 24 kDa hGH were pooled and Western blot analysis displayed immunoreactivity to antihGH antibodies. PDG-PAGE provides researchers with an electrophoretic technique to preparatively purify proteins under nonreducing conditions with molecular mass differences of 2 kDa.