Development of a rapid and specific assay for detection of busulfan in human plasma by high-performance liquid chromatography/electrospray ionization tandem mass spectrometry

A sensitive and specific assay for detection of busulfan in human plasma was developed. The assay is based on rapid isolation of busulfan by liquid-liquid extraction with ethyl acetate, and detection by high-performance liquid chromatography with electrospray ionization and tandem mass spectrometry. 1,6-Bis(methanesulfonyloxy)hexane, a synthesized analogue of busulfan, was used as the internal standard (IS). The acquisition was performed in the multiple reaction monitoring mode; busulfan and the IS were detected with no interferences from plasma matrix. The method was linear over the range 5-2500 ng mL(-1), with r2 > 0.99 and a run time of only 3.5 min. The intra- and inter-assay precisions were in the ranges 2.1-11.9% and 3.2-10.1%, respectively, and the intra- and inter-assay accuracies were 92.2-107.6% and 94.7-104.1%, respectively. The absolute recoveries were 82.0% (20 ng mL(-1)), 90.6% (1000 ng mL(-1)) and 80.0% (2000 ng mL(-1)) for busulfan, and 89.1% for the IS (1000 ng mL(-1)). The limits of detection and quantification were 2 and 5 ng mL(-1), respectively. The validated method was successfully applied to analyze plasma samples obtained from six adults receiving doses of 1 mg kg(-1) in a conditioning regimen prior to bone marrow transplantation. A marked intra-patient variation in busulfan concentrations during the steady state was observed, which limits the application of pharmacokinetic modeling and suggests that continuous therapeutic monitoring is necessary for adequate individualized dosing. In this regard, the present assay brings important advantages relative to other methods described in the literature, i.e., it is highly specific and simple to perform, with a rapid chromatographic run time (3.5 min), and the whole procedure can be completed in 4-5 h, which would permit dose corrections after the third dose allowing earlier and better dosing adjustments towards the target level of busulfan.     

A mild and efficient method for halogenation of 3,5-dimethyl pyrazoles by ultrasound irradiation using N-halosuccinimides

The 4-halo-3,5-dimethyl pyrazoles have been synthetisized in good yields in short reaction times in the absence of a catalyst by reaction of 3,5-dimethyl pyrazoles with N-halosuccinimides (NBS, NCS and NIS) under ultrasound irradiation. Finally, the halogenation of pyrazoles with Br₂, ICl and I₂ was showed in similar conditions.     

An easy and stereoselective synthesis of N-Boc-dolaproine via the Baylis-Hillman reaction

In this communication we report a stereoselective total synthesis of N-Boc-dolaproine (Dap), an amino acid residue of the antineoplastic pentapeptide Dolastatin 10. Our strategy is based on a Baylis-Hillman reaction between N-Boc-prolinal and methyl acrylate, followed by a diastereoselective double bond hydrogenation and hydrolysis of the ester function.     

NMR Conformational Analysis and Theoretical Calculations for 2‐Aryl‐ 1,3‐dihydroxy‐4,4,5,5‐tetramethylimidazolidines

Conformational studies of 1,3‐dihydroxy‐4,4,5,5‐tetramethyl‐2‐(pyridin‐1‐yl)imidazolidine ( 1a ) and 1,3‐dihydroxy‐4,4,5,5‐tetramethyl‐2‐(pyridin‐3‐yl)imidazolidine ( 1b ), carried out by using 1D ¹H‐ and ¹³C‐NMR and 2D HMQC, HMBC, and NOESY experiments and with the aid of theoretical calculations, indicate that the OH groups are trans to the pyridinyl substituent. Because the two ¹H‐NMR signals of the Me groups are distinguishable and do not change between 290 and 380 K, it is proposed that 1a and 1b have each only one conformation in this temperature range. This behavior was not found with 1,3‐dihydroxy‐4,4,5,5‐tetramethyl‐2‐(pyridin‐2‐yl)imidazolidine ( 1c ) because its Me ¹H‐NMR signals cross over at 300 K. Hence, more than one conformation must be present, beyond those produced by simple inversions. Theoretical calculations including temperature and solvent effects were performed to provide further information on the conformational analysis and to help to assign the NMR data. The combination of NMR measurements and quantum‐chemical calculations is shown to be a very promising strategy for conformational analysis studies in solution.     

2,2,4,4‐Tetra‐tert‐butyl‐1,3,5,2,4‐benzotrioxadisilepine‐7‐carbaldehyde

The mol­ecule of the title compound, C₂₃H₄₀O₄Si₂, features an approximate non‐crystallographic C₂ symmetry axis. The aldehyde group is disordered over two positions with similar occupancies. The geometry of the isolated mol­ecule was studied by ab initio quantum mechanical calculations employing a mol­ecular orbital Hartree–Fock method. The calculations reproduce well the equilibrium geometry but slightly overestimate the value of the Si—O bond lengths of the trioxadisilepine ring.     

A multineuron interaction model for neural networks

A multineuron interaction model (RS model) with an energy function given by the product of the squared distances in phase space between the state of the net and the stored patterns is studied in detail within a mean-field approach. Two limits are considered: when the patterns and antipatterns are stored (as in the Hopfield model), PAS case, and when only the patterns are taken into account, OPS case. TheT=0 solutions for the proper memories are exactly obtained for all finite values of, as a consequence of the energy function: whenever one of the overlaps is exactly one the corresponding equations decouple and no configuration average is required. Special interest is focused on the OPS situation, which presents a peculiar phase space topology. On the other hand, the PAS configuration recovers the Hopfield model in the appropriate limit, while keeping associative memory abilities far beyond the critical values of other models when the full Hamiltonian is considered.     

Online preconcentration system for determining ultratrace amounts of Cd in vegetal samples using thermospray flame furnace atomic absorption spectrometry

A system has been developed for online preconcentration and determination of Cd using thermospray flame furnace atomic absorption spectrometry (TS-FF-AAS). It is based on the solid-phase extraction of Cd in an Amberlite XAD-2 minicolumn loaded with 2-(2-thiazolylazo)-5-dimethylaminophenol (TAM), and the metal ion is eluted with 1 mol L⁻¹ hydrochloridric acid, followed by its determination. The online system allows determining Cd with a detection limit of 8.0 ng L⁻¹ and a quantification limit of 25.0 ng L⁻¹. The precision (repeatability), calculated as the relative standard deviation (% RSD) in sample solutions containing 0.5 and 3.0 μg L⁻¹ of Cd, was 6.1 and 4.5%, respectively. The preconcentration factor obtained was 24. The system’s accuracy was confirmed by analyzing the following certified reference materials (CRMs): Rice flour NIES 10b, Apple leaves NIST 1515 and Orchard leaves NBS 1571. This procedure was applied to the determination of Cd in cabbage and powdered guarana samples.