Stereochemically controlled synthesis of unsaturated acids via diphenylphosphinoyl (Ph2PO) -ketoacids

Acylation of phosphine oxide anions with derivatives of cyclic anhydrides or oxidative cleavage of cyclic allyl phosphine oxides gives Ph₂PO-ketoacids: reduction, separation of diastereoisomers, and completion of the Horner-Wittig reaction gives single isomers ($\text{E}$) or ($\text{Z}$) of unsaturated acids.     

Inelastic incoherent neutron scattering measurements of intact cells and tissues and detection of interfacial water

We have previously used inelastic incoherent neutron scattering spectroscopy to investigate the properties of aqueous suspensions of biomolecules as a function of hydration. These experiments led to the identification of signals corresponding to interfacial (hydration) water at low water content. A prediction from these studies was that in the crowded environment inside living cells, a significant proportion of the water would be interfacial, with profound implications for biological function. Here we describe the first inelastic incoherent neutron scattering spectroscopy studies of living cells and tissues. We find that the interfacial water signal is similar to that observed for water interacting with purified biomolecules and other solutes, i.e., it is strongly perturbed in the librational and translational intermolecular optical regions of the spectrum at 20-150 meV. The ratio of interfacial water compared to total water in cells (approximately 30%) is in line with previous experimental data for hydration water and calculations based on simple assumptions.     

New routes to beta-cycloalkylalanine derivatives using serine-derived organozinc reagents

Two distinct routes to beta-cycloalkylalanine derivatives have been developed. The first route employs the reaction of the iodoalanine-derived zinc-copper reagent 2 with cycloalk-1-en-3-yl phosphates, and the second uses the palladium-catalysed coupling of the iodoalanine-derived zinc reagent 1 with cycloalkenyl triflates; in each case, catalytic hydrogenation of the unsaturated product leads to the protected beta-cycloalkylalanine. The latter route allows access to a range of cycloalkyl derivatives, with ring sizes of 5-8. beta-(1-Methyl-1-cyclohexyl)alanine may be prepared using reaction of the zinc-copper reagent 2 with 3-methyl-2-cyclohexenyl chloride, followed by hydrogenation. The corresponding cyclopentyl derivative may be prepared by reaction of the same zinc-copper reagent 2 with diethyl geranylphosphate, followed by ring-closing metathesis and hydrogenation.     

Modeling the gel electrophoresis of short duplex DNA by Brownian dynamics: cubic gel lattice with direct interaction

The technique of Brownian dynamics is used to model the electrophoretic mobility of spherical and rod-like particles in a three-dimensional cubic gel lattice. In addition to excluded volume interactions between the migrating particle and the gel, direct interactions are also included. The methodology is first applied to spherical particles in the absence of direct interactions and the resulting mobilities are shown to agree with independent studies. The methodology is then applied to rod-like models of short duplex DNA fragments 10-50 base pairs in length. In the absence of direct interactions between gel and DNA, calculated mobilities show a much weaker dependence on gel concentration than observed in experiments of DNA in Tris-acetate buffer and polyacrylamide gels. When an attractive interaction between gel and DNA of approximately -0.3 k(B)T per base pair at contact is included, good agreement between calculated and experimental mobilities is achieved.     

From solution-phase to solid-phase enyne metathesis: crossover in the relative performance of two commonly used ruthenium pre-catalysts

A crossover in the ability of two distinct ruthenium-based metathesis pre-catalysts to effect the synthesis of dialkenylboronic esters in solution and on the solid-phase was observed. Specifically, while the Grubbs 2nd generation pre-catalyst 3 affords a greater degree of conversion to product than the Hoveyda-Grubbs pre-catalyst 2 in a solution-phase enyne-metathesis reaction, this trend is reversed in the solid-phase variant. Systematic investigation showed this trend to be general, regardless of variations in the homoallylic alcohol and alkynylboronic ester components of the reaction, as well as in the type of solid support employed. Experiments to determine a mechanistic hypothesis for this trend highlighted the significance of the ruthenium remaining bound to the substrate after metathetic rearrangement and found the presence of phosphine ligand to be detrimental to the success of the solid-phase reaction. Therefore, these results suggest an expanded role for phosphine-free pre-catalysts, such as 2, in challenging solid-phase metathesis reactions.     

Molecular ordering and 2D conductivity in ultrathin poly(3-hexylthiophene)/gold nanoparticle composite films

This paper reports the first comparison of the structure and electrical conductivity properties of spin cast (SC) and Langmuir-Schaeffer (LS) films of regioregular poly(3-hexylthiophene) (P3HT). In addition, the effect of incorporating highly monodisperse Au nanoparticles (NPs), with a core diameter of approximately 5 nm, into SC and LS P3HT films is described. A detailed picture of molecular organization in the films has been obtained using ultraviolet-visible absorption spectroscopy, atomic force microscopy, field-emission scanning electron microscopy, X-ray diffraction, and X-ray reflectivity. Film morphology was correlated with pseudo-two-dimensional conductivity measured using scanning electrochemical microscopy, with P3HT in the semiconducting regime. It was found that SC films, which were slightly thicker than those formed with the LS technique, exhibited greater organization. This resulted in an order of magnitude higher lateral conductivity for the SC films. Inclusion of Au NPs (50 wt %) into both SC and LS films resulted in the formation of uniform and relatively flat (rms roughness approximately 1 nm) composite films. Surprisingly, the addition of NPs did not disrupt the characteristic crystal structure found for the native P3HT films. The effect of Au NPs on film lateral conductivity was found to be determined by the distribution of Au NPs within the polymer, which varied significantly between SC and LS films. Whereas Au NPs aggregated into hexagonally packed clusters in SC films, NPs in LS films were predominantly uniformly distributed between the lamella bilayer. It was found that, while the inclusion of Au NPs caused the lateral conductivity to decrease in SC films, in LS films, the lateral conductivity increased by a factor of 2.     

Solid-state synthesis of a conducting polythiophene via an unprecedented heterocyclic coupling reaction

Prolonged storage ( approximately 2 years) or gentle heating (50-80 degrees C) of crystalline 2,5-dibromo-3,4-ethylenedioxythiophene (DBEDOT) affords a highly conducting, bromine-doped poly(3,4-ethylenedioxythiophene) (PEDOT), as confirmed by solid-state NMR, FTIR, CV, and vis-NIR spectroscopies. The novel solid-state polymerization (SSP) does not occur for 2,5-dichloro-3,4-ethylenedioxythiophene (DCEDOT), and requires a much higher temperature (>130 degrees C) for 2,5-diiodo-3,4-ethylenedioxythiophene (DIEDOT). X-ray structural analysis of the above dihalothiophenes reveals short Hal.Hal distances between adjacent molecules in DBEDOT and DIEDOT, but not in DCEDOT. The polymerization may also occur in the melt but is significantly slower and leads to poorly conductive material. Detailed studies of the reaction were performed using ESR, DSC, microscopy, and gravimetric analyses. SSP starts on crystal defect sites; it is exothermic by 14 kcal/mol and requires activation energy of approximately 26 kcal/mol (for DBEDOT). The temperature dependence of the conductivity of SSP-PEDOT (sigma(rt) = 20-80 S/cm) reveals a slight thermal activation. It can be further increased by a factor of 2 by doping with iodine. Using this approach, thin films of PEDOT with conductivity as high as 20 S/cm were fabricated on insulating flexible plastic surfaces.     

Nanoscale borromeates

[Structure: See text] In addition to a parent zinc(II) Borromean ring (BR) complex, the preparation and characterization of two hexasubstituted BR complexes with either 4-acetoxymethylphenyl or 4-methylthiophenyl substituents associated in turn with all six pyridyl rings has been achieved convergently in good yields by appealing to the dynamic features of the reactions between primary amino groups in a preformed acyclic ligand and 2,6-diformylpyridine. Two molecules of the acyclic ligands react with two molecules of 2,6-diformylpyridine to form a cyclic [2 + 2] tetraimine in the presence of Zn(II) ions as templates in 2-propanol at 70 degrees C. The successful preparation of the two derivatives by convergent template-directed syntheses opens up opportunities to self-assemble, under equilibrium control, numerous nanoscale metallo-organic particles with potentially useful properties.