A distance-controlled oligopeptide linker as a novel photo-induced energy transfer switch by secondary structural transition

By using an oligopeptide chain as a functional linker and introducing coumarin 2 and coumarin 343 at the chain ends, an effective photo-induced energy transfer system was constructed and energy transfer from coumarin 2 to coumarin 343 was switched on and off by a solvent-induced helix-coil secondary transition of the oligopeptide chain.     

Investigation of the crystal structure and the structural and magnetic properties of SrCu2(PO4)2

SrCu2(PO4)2 was prepared by the solid-state method at 1153 K. Its structure was solved by direct methods in the space group Pccn (No. 56) with Z = 8 from synchrotron X-ray powder diffraction data measured at room temperature. Structure parameters were then refined by the Rietveld method to obtain the lattice parameters, a = 7.94217(8) A, b = 15.36918(14) A, and c = 10.37036(10) A. SrCu2(PO4)2 presents a new structure type and is built up from Sr2O16 and Cu1Cu2O8 units with Cu1...Cu2 = 3.256 A. The magnetic properties of SrCu2(PO4)2 were investigated by magnetic susceptibility, magnetization up to 65 T, Cu nuclear quadrupole resonance (NQR), electron-spin resonance, and specific heat measurements. With spin-dimer analysis, it was shown that the two strongest spin-exchange interactions between Cu sites result from the Cu1-O...O-Cu2 and Cu2-O...O-Cu2 super-superexchange paths with Cu1...Cu2 = 5.861 A and Cu2...Cu2 = 5.251 A, and the superexchange associated with the structural dimer Cu1Cu2O8 is negligible. The magnetic susceptibility data were analyzed in terms of a linear four-spin cluster model, Cu1-Cu2-Cu2-Cu1 with -2J(1)/kB = 82.4 K for Cu1-Cu2 and -2J(2)/k(B) = 59 K for Cu2-Cu2. A spin gap deduced from this model (Delta/kB = 63 K) is in agreement with that obtained from the Cu NQR data (Delta/kB = 65 K). A one-half magnetization plateau was observed between approximately 50 and 63 T at 1.3 K. Specific heat data show that SrCu2(PO4)2 does not undergo a long-range magnetic ordering down to 0.45 K. SrCu2(PO4)2 melts incongruently at 1189 K. We also report its vibrational properties studied with Raman spectroscopy.     

Dynamic coordination polymers with 4,4'-oxybis(benzoate): reversible transformations of nano- and nonporous coordination frameworks responding to present solvents

Reversible construction of a nanoporous framework from a nonporous framework has been found in the zinc(II) coordination polymer with 4,4'-oxybis(benzoate) (oba). [Zn(2)(oba)(2)(dmf)(2)].2DMF (1), which has 1 nm scale channels, transforms to the nonporous coordination polymer [Zn(oba)(H(2)O)] (2) with the loss of the open framework. Compound 2 on treatment with DMF reversibly yields nanoporous compound 1.     

Effect of amount of monomer on radiation-induced polymerization of styrene adsorbed on silica gel

The effect of amount of monomer on radiation-induced polymerization of styrene adsorbed on silica gel was investigated with the monomer amounting from less than monolayer adsorption to more than the equilibrium adsorption. The rate of graft polymerization and the molecular weight of the polymer changed with the amount of monomer adsorbed on silica gel. Maximum grafting efficiency was obtained at monolayer adsorption. The molecular weight of graft polymer was higher than that of homopolymer in both radical and cationic polymerizations, and the ratio in molecular weight of graft polymer to that of homopolymer tends to be unity with increasing amount of adsorbed monomer. These results can mainly be explained in terms of the number of initiating species (radical and cation) that change in relation to the amount of adsorbed monomer. Propagation and termination change with amount of adsorbed monomer in relation to the molecular mobility of adsorbed monomer. A very high-molecular-weight graft polymer is formed only with a small amount of adsorbed monomer in the initial stage. The grafting percent with a large amount of adsorbed monomer increased after most of the monomer has been polymerized. Secondary effect of radiation on the graft and homopolymers due to energy transfer from silica gel is suggested from the complicated phenomena in the later stage of the reaction.     

Reactivity of hydroperoxide bound to a mononuclear non-heme iron site

The first isolation and spectroscopic characterization of the mononuclear hydroperoxo-iron(III) complex [Fe(H(2)bppa)(OOH)](2+) (2) and the stoichiometric oxidation of substrates by the mononuclear iron-oxo intermediate generated by its decomposition have been described. The purple species 2 obtained from reaction of [Fe(H(2)bppa)(HCOO)](ClO(4))(2) with H(2)O(2) in acetone at -50 degrees C gave characteristic UV-vis (lambda(max) = 568 nm, epsilon = 1200 M(-1) cm(-1)), ESR (g = 7.54, 5.78, and 4.25, S = (5)/(2)), and ESI mass spectra (m/z 288.5 corresponding to the ion, [Fe(bppa)(OOH)](2+)), which revealed that 2 is a high-spin mononuclear iron(III) complex with a hydroperoxide in an end-on fashion. The resonance Raman spectrum of 2 in d(6)-acetone revealed two intense bands at 621 and 830 cm(-1), which shifted to 599 and 813 cm(-1), respectively, when reacted with (18)O-labeled H(2)O(2). Reactions of the isolated (bppa)Fe(III)-OOH (2) with various substrates (single turnover oxidations) exhibited that the iron-oxo intermediate generated by decomposition of 2 is a nucleophilic species formulated as [(H(2)bppa)Fe(III)-O*].     

Magnetic circular dichroism of theA andB bands in KI:Ga+, KI:In+, and KI:Sn2+

Magnetic circular dichroism (MCD) of theA- andB-absorption band region has been obtained at 4.2 K and 50 kG in KI:Ga⁺, KI:In⁺, and KI:Sn²⁺. The MCD spectra indicate the complex nature of these bands more clearly than the absorption spectra themselves do. TheA-band MCD consists in all cases of a positive and a negative part reflecting the structure of the absorption band. TheB-band MCD shows three peaks, two positive peaks at 4.34 and 4.41₅ eV (4.09 and 4.17₅ eV) and a negative peak at 4.38 eV (4.12₅ eV) in KI:Ga⁺ (KI:In⁺). TheB-band in KI:Sn²⁺ consists of a shoulder (b ₀) at 3.76 eV and a main band which has at least 5 sub-peaks (b ₁~b ₅) at 3.82₁, 3.84₁, 3.86₁, 3.88₀, and 3.89₅ eV; each of the subpeaks (b ₁~b ₅) gives a derivative-like MCD.The MCD shape functionf() for the transitiona _1g ² a _1g t _1u has been obtained for one set of parameter values by using the classical Franck-Condon approximation and the Monte Carlo integration method. The result can explain the observed salient features of theB- as well asA-band MCD's, indicating the validity of the Franck-Condon approximation and the interaction mode coordinates.     

N,N-Diethyl-3-toluamide Formulation Based on Ethanol Containing 0.1% 2-Hydroxypropyl-β-cyclodextrin Attenuates the Drug’s Skin Penetration and Prolongs the Repellent Effect without Stickiness

N,N-diethyl-3-toluamide (DEET) is one of the most widely used insect repellents in the world. It was reported that a solution containing 6–30% cyclodextrin (CD) as a solvent instead of ethanol (EtOH) provided an enhancement of the repellent action time duration of the DEET formulation, although the high-dose CD caused stickiness. In order to overcome this shortcoming, we attempted to prepare a 10% DEET formulation using EtOH containing low-dose CDs (β-CD, 2-hydroxypropyl-β-CD (HPβCD), methyl-β-CD, and sulfobutylether-β-CD) as solvents (DEET/EtOH/CD formulations). We determined the CD concentration to be 0.1% in the DEET/EtOH/CD formulations, since the stickiness of 0.1% CDs was not felt (approximately 8 × 10⁻³ N). The DEET residue on the skin superficial layers was prolonged, and the drug penetration into the skin tissue was decreased by the addition of 0.1% CD. In particular, the retention time and attenuated penetration of DEET on the rat skin treated with the DEET/EtOH/HPβCD formulation was significantly higher in comparison with that of the DEET/EtOH formulation without CD. Moreover, the repellent effect of DEET was more sustained by the addition of 0.1% HPβCD in the study using Aedes albopictus. In conclusion, we found that the DEET/EtOH/HPβCD formulations reduced the skin penetration of DEET and prolonged the repellent action without stickiness.     

Surface viscous flattening kinetics of soda-lime silicate glass by sinusoidal profile decay method

The kinetics of the flattening of surface corrugations of float glasses were investigated in dry nitrogen at 610 to 670°C. The amplitude of the sinusoidal surface profile decayed exponentially with time while its wavelength remained constant. The dependence of decay rate on wavelength indicated that the process is controlled by the viscous flow. From the obtained rate constant the viscosity was calculated using the surface energy value determined independently by the zero-creep method. The viscosity thus obtained reflects the mass transport property in the vicinity of the glass surface. It was several times larger than that determined by the fibre elongation or intrusion method which should reflect the bulk properties. No difference in the decay rate was observed on both the surfaces of float glass of which only one side had been exposed to molten tin during the glass manufacturing process.     

Fraunhofer Diffraction Pattern by a Slit Aperture between a Knife Edge and a Metal Cylinder

The Fraunhofer diffraction pattern of an aperture formed between a knife edge and a smooth surface of a turned metal cylinder or half cylinder is different from the diffraction pattern of an ideal slit aperture. The diffraction pattern is simulated by adding the light reflected by the cylinder surface to the pattern formed by a slit, and is measured using a cylinder that has been partly cut away so that it can represent either a full or half cylinder. The theoretical and measured patterns agree well with each other.     

Oligosaccharide-Carrying Styrene-Type Macromers. Polymerization and Specific Interactions Between the Polymers and Liver Cells

Polystyrene derivatives with lactose, glucose, maltose, maltotriose, maltopentaose, and maltoheptaose on each benzene ring were prepared by the radical polymerization of a new class of macromers synthesized by coupling the corresponding oligosaccharide lactones with p-vinylbenzylamine. These polymers consisting of amphiphilic structural units were water-soluble, and organic solutes were bound to hydrophobic microenvironments of the polymers in water. α-D-Glucopyranose-carrying polymers were recognized and precipitated by concanavalin A. Cultivation of liver cells (hepatocytes) was attempted using culture dishes whose surface was coated with lactose-, glucose-, maltose-, and maltotriose-carrying polystyrenes. It has been found that a lactose-carrying polystyrene (PVLA) is a useful surface material for hepatocyte culture. 1) Highly specific adhesion of hepatocytes was attained for PVLA-coated dishes with or without serum supplement. 2) The cell adhesion was a threshold phenomenon with respect to the PVLA concentration on the dish. 3) The cell adhesion was effectively inhibited when hepatocytes were treated with PVLA molecules in the medium prior to culture. 4) The adhesion was not inhibited by albumin, an adhesion-inhibitory protein in serum. These findings suggest that pendent galactose residues of a PLVA molecule functioned as a strong recognition determinant for hepatocytes. We assume that multi-antennary, high-density galactose residues of PVLA are attributed to the specific adhesion of hepatocytes.