Lead sulfate used as the positive active material of lead acid batteries

Lead sulfate is produced when a lead acid battery discharges, and it is also known that big PbSO₄ crystals are less active than the smaller ones because they dissolve slower, thus result in failure of the battery. However, little is known if chemically prepared PbSO₄ can be used as active material of lead acid batteries. Here, we report the preparation of PbSO₄ by facile chemical precipitation of aqueous lead acetate with sodium sulfate and its utilization as the positive active material. The results show that the PbSO₄ alone is not good enough for the purpose, but its mixtures with Pb₃O₄ are as excellent as the industrial leady oxide. For example, the mixtures containing 5, 10, 20, and 30 wt.% of Pb₃O₄ discharge 78.2, 92.9, 88.0, and 91.5 mAh g^?1 at a current density of 100 mA g^?1, respectively. Also, the one with 10 % Pb₃O₄ remains 93 % capacity in 150, 100 % DOD cycles.     

Pressure anisotropy effects on nonlinear electrostatic excitations in magnetized electron-positron-ion plasmas

The propagation of linear and nonlinear electrostatic waves is investigated in a magnetized anisotropic electron-positron-ion (e-p-i) plasma with superthermal electrons and positrons. A two-dimensional plasma geometry is assumed. The ions are assumed to be warm and anisotropic due to an external magnetic field. The anisotropic ion pressure is defined using the double adiabatic Chew-Golberger-Low (CGL) theory. In the linear regime, two normal modes are predicted, whose characteristics are investigated parametrically, focusing on the effect of superthermality of electrons and positrons, ion pressure anisotropy, positron concentration and magnetic field strength. A Zakharov-Kuznetsov (ZK) type equation is derived for the electrostatic potential (disturbance) via a reductive perturbation method. The parametric role of superthermality, positron content, ion pressure anisotropy and magnetic field strength on the characteristics of solitary wave structures is investigated. Following Allen and Rowlands [J. Plasma Phys. 53, 63 (1995)], we have shown that the pulse soliton solution of the ZK equation is unstable to oblique perturbations, and have analytically traced the dependence of the instability growth rate on superthermality and ion pressure anisotropy.     

Heat transfer augmentation of a car radiator using nanofluids

The car radiator heat transfer enhancement by using TiO₂ and SiO₂ nanoparticles dispersed in water as a base fluid was studied experimentally. The test rig is setup as a car radiator with tubes and container. The range of Reynolds number and volume fraction are (250–1,750) and (1.0–2.5 %) respectively. Results showed that the heat transfer increases with increasing of nanofluid volume fraction. The experimental data is agreed with other investigator.     

Low-cost low-threshold diode end-pumped Tm:YAG laser at 2.016?μm

We report a low-threshold continuous-wave Tm:YAG laser that can be excited near 785?nm with low-cost, single-mode AlGaAs laser diodes. Low-threshold operation was achieved using a tightly focused, astigmatically compensated x-cavity containing a 2-mm-thick Tm:YAG crystal with 5?% Tm³⁺ concentration. Two linearly polarized single-mode diodes operating at 785.8?nm were polarization coupled to end pump the resonator. With a 6?% output coupler, as high as 32?mW of output power could be obtained at 2016?nm with 184?mW of incident pump power. The output could be further tuned in the 1935?C2035?nm range. Slope efficiency measurements indicated that cross-relaxation was very effective at this doping level. With a 2?% output coupler, lasing could be obtained with as low as 32.3?mW of pump power. In the limit of vanishing output coupling, the incident threshold pump power could be reduced to as low as 25?mW. To our knowledge, this is among the lowest lasing thresholds reported to date for continuous-wave, room-temperature thulium lasers.     

A Structural Study of Epoxidized Natural Rubber (ENR-50) and Its Cyclic Dithiocarbonate Derivative Using NMR Spectroscopy Techniques

A structural study of epoxidized natural rubber (ENR-50) and its cyclic dithiocarbonate derivative was carried out using NMR spectroscopy techniques. The overlapping ¹H-NMR signals of ENR-50 at δ 1.56, 1.68-1.70, 2.06, 2.15-2.17 ppm were successfully assigned. In this work, the ¹³C-NMR chemical shift assignments of ENR-50 were consistent to the previously reported work. A cyclic dithiocarbonate derivative of ENR-50 was synthesized from the reaction of purified ENR-50 with carbon disulfide (CS₂), in the presence of 4-dimethylaminopyridine (DMAP) as catalyst at reflux temperature. The cyclic dithiocarbonate formation involved the epoxide ring opening of the ENR-50. This was followed by insertion of the C-S moiety of CS₂ at the oxygen attached to the quaternary carbon and methine carbon of epoxidized isoprene unit, respectively. The bands due to the C=S and C-O were clearly observed in the FTIR spectrum while the ¹H-NMR spectrum of the derivative revealed the peak attributed to the methylene protons had split. The ¹³C-NMR spectrum of the derivative further indicates two new carbon peaks arising from the >C=S and quaternary carbon of cyclic dithiocarbonate. All other ¹H- and ¹³C-NMR chemical shifts of the derivative remain unchanged with respect to the ENR-50.     

Preparation and characterization of zinc oxide nanoflakes using anodization method and their photodegradation activity on methylene blue

In this work, we report the formation of leaf-like ZnO nanoflakes by anodization of zinc foil in a mixture of ammonium sulfate and sodium hydroxide electrolytes under various applied voltage and concentration of sodium hydroxide. The morphology and structure of ZnO nanoflakes were investigated by field emission scanning electron microscopy, energy-dispersive X-ray spectroscopy and X-ray diffraction analysis. In addition, the photocatalytic activity of the prepared nanoflakes zinc oxide was evaluated in the photodegradation of organic dye methylene blue (MB) solution under UV irradiation. It was found that zinc oxide prepared under high concentration of sodium hydroxide and high voltage showed better performance in the photodegradation of methylene blue.     

Synthesis of D-mannitol substituted ether-linked bis-1,2,3-triazoles as models of gemini surfactants

Readily available and low cost D-mannitol was converted into 1,2,5,6-di-O-isopropylidene-D-mannitol (1) in the presence of acetone and zinc chloride. Williamson etherfication of 1 with propargyl bromide afforded the bisalkyne 2 in a very good yield. 1,3-Dipolar cycloaddition of 2 with four different alkyl azides using click conditions gave four novel bistriazoles 3a-d. Removal of the acetal groups of 3a-d afforded the deprotected bistriazoles 4a-d in excellent yields. Products 3 and 4 represent models of gemini surfactants.     

An alkyl–palladium(II) complex with a bidentate phosphine ligand: [1,3‐bis(di­phenyl­phosphino)­propane‐P,P′]­dimethyl­palladium(II) toluene hemi­solvate

In the title compound, [Pd(CH₃)₂(C₂₇H₂₆P₂)]·0.5C₇H₈, the Pd atom is at the centre of an approximately square‐planar arrangement of two P atoms and two methyl groups. The P—Pd—P angle [93.19 (3)°] is significantly larger than that in the corresponding dichloride complex [Pd(dppp)Cl₂]. The toluene mol­ecule is disordered across an inversion centre.     

Generalized contraction mapping principle in intuitionistic Menger spaces and application to differential equations

Using the idea of Atanassov, we define the notion of intuitionistic Menger spaces as a netural generalizations of Menger spaces due to Menger. We also obtain a new generalized contraction mapping and utilize this contraction mapping to prove the existance theorems of solutions to differential equations in intuitionistic Menger spaces.