A comparative study of heavy-atom effects on the room-temperature phosphorescence of biologically important purines

Room-temperature phosphorescence (r.t.p.) of nine biologically important purines on filter paper is studied. The heavy-atom effect leads to a significant enhancement of r.t.p. signals, with the trend being Tl⁺ > Pb²⁺ ? I — ? Sm³⁺ for most purines. Absolute limits of detection range from 40 pg (purine) to 19 ng (theophylline).     

Synthesis and formulation of vinyl-containing polyacids for improved light-cured glass-ionomer cements

Vinyl-containing poly(acrylic acid-co-itaconic acid) copolymers were synthesized and used to formulate light-curable cements containing reactive glass fillers (Fuji II LC). The conditions for light curing were studied and optimized. Effects of molecular weight (MW), grafting ratio, comonomer, liquid composition, powder/liquid (P/L) ratio, glass powder and aging were evaluated. The results show that the vinyl-containing glass-ionomer cements (GICs) prepared in this study exhibit higher compressive strength (CS, 225.6 MPa), diametral tensile strength (DTS, 28.4 MPa) and much higher flexural strength (FS, 116.4 MPa), as compared to commercial Fuji II LC GIC (186.6 in CS, 19.1 in DTS and 57.1 in FS). The optimal light-exposure time was found to be around 10 min, and concentrations of CQ and DC were 0.5% (by weight) and 1.0%, respectively. Effects of MW, grafting ratio, P/L ratio and content of polymer in the liquid formulation were significant. The highest strengths were found for the optimal formulations where the MW was 15,000 (weight average), grafting ratio 25 mol%, P/L ratio 2.7 and liquid composition 50:20:30. During aging, the cement showed an increase of strength over the first week and then no change for a month. SEM analysis suggests that more integrated microstructures and smaller glass particles can lead to higher FS and higher polymer content in GICs leads to tough fracture surface and plastic deformation.     

An Investigation of Inclusion Complexes of Cyclodextrins with Phenylurea Herbicides by Photochemically-Induced Fluorescence. Analytical Applications

The effect of -cyclodextrin (-CD) and hydroxypropyl--cyclodextrin (HP--CD) upon the photochemically-induced fluorescence (PIF) properties of four phenylurea herbicides, including linuron, diuron, isoproturon and neburon has been studied. Photochemical conversion of these nonfluorescent herbicides into strongly fluorescent photoproducts was shown to occur in -CD and HP--CD aqueous media. The influence of pH, UV irradiation time and photoproduct stability on the fluorescence intensity was also investigated. In addition, the stoichiometry and formation constants of the complexes formed between herbicides and -cyclodextrin (-CD) or 2-hydroxypropyl--cyclodextrin (HP--CD) were determined. The formation constant values, ranging from 184 ± 40 to 1498 ± 245 M^-1, were calculated by applying the iterative nonlinear regression (NLR) approach to the PIF data. Linear calibrations graphs were established in the interval 1–12 g/mL, for diuron, linuron and neburon. The IUPAC limits of detection ranged between 580 and 700 ng/mL, according to the compound. Application to the analysis of phenylurea herbicides in spiked river water was also described.     

Molecular ordering and 2D conductivity in ultrathin poly(3-hexylthiophene)/gold nanoparticle composite films

This paper reports the first comparison of the structure and electrical conductivity properties of spin cast (SC) and Langmuir-Schaeffer (LS) films of regioregular poly(3-hexylthiophene) (P3HT). In addition, the effect of incorporating highly monodisperse Au nanoparticles (NPs), with a core diameter of approximately 5 nm, into SC and LS P3HT films is described. A detailed picture of molecular organization in the films has been obtained using ultraviolet-visible absorption spectroscopy, atomic force microscopy, field-emission scanning electron microscopy, X-ray diffraction, and X-ray reflectivity. Film morphology was correlated with pseudo-two-dimensional conductivity measured using scanning electrochemical microscopy, with P3HT in the semiconducting regime. It was found that SC films, which were slightly thicker than those formed with the LS technique, exhibited greater organization. This resulted in an order of magnitude higher lateral conductivity for the SC films. Inclusion of Au NPs (50 wt %) into both SC and LS films resulted in the formation of uniform and relatively flat (rms roughness approximately 1 nm) composite films. Surprisingly, the addition of NPs did not disrupt the characteristic crystal structure found for the native P3HT films. The effect of Au NPs on film lateral conductivity was found to be determined by the distribution of Au NPs within the polymer, which varied significantly between SC and LS films. Whereas Au NPs aggregated into hexagonally packed clusters in SC films, NPs in LS films were predominantly uniformly distributed between the lamella bilayer. It was found that, while the inclusion of Au NPs caused the lateral conductivity to decrease in SC films, in LS films, the lateral conductivity increased by a factor of 2.     

Quantification of several atmospheric gases from high resolution infrared solar spectra obtained at the south pole in 1980 and 1986

Simultaneous total column amounts of a number of minor and trace atmospheric gases above the South Pole in December 1980 and December 1986 have been deduced from analysis of high resolution solar absorption spectra recorded (by F. J. M. and F. H. M.) from Amundsen-Scott South Pole Station. These spectra also contain some limited information on the vertical profiles of the observed atmospheric gases.The data sets were recorded with a Bomem Michelson-type interferometer and analyzed with a spectral least-squares fitting procedure, utilizing the best available spectroscopic line parameters and absorption cross sections. Because the same instrument, line parameters, and analysis method have been used in analyzing the December 1980 and December 1986 data sets, the precision in comparing the column amounts from these two dates is rather high, about 10–20% for the stronger absorbing gases. For this reason, it has been possible to quantify or determine upper limits for differences between the December 1980 and December 1986 total column amounts, of a number of atmospheric gases including O₃, N₂O, HNO₃, CO₂, CH₄, and CF₂C_{1 2} (CFC 12). In addition, vertical column amounts for a number of atmospheric gases covered only in the December 1986 observations have been derived, including HC1, NO, NO₂, and C₂H₆. Some of these results will be discussed here. The HC1 measurements are especially interesting since the observed amounts are higher than expected from observations made at lower latitudes in the northern and southern hemispheres.     

Photochemically-induced fluorescence determination of sulfonylurea herbicides using micellar media

An analytical method based on the use of UV irradiation to produce fluorescent derivatives from four non-fluorescent sulfonylurea herbicides, including chlorsulfuron, metsulfuron methyl, 3-rimsulfuron and sulfometuron methyl is described. Their photochemically-induced fluorescence (PIF) properties in several solvents (water, dimethyl sulfoxide (DMSO), dimethyl formamide (DMF), acetonitrile, methanol, ethanol, propan-2-ol and their binary mixtures with water) and micellar solutions of sodium dodecyl sulfate (SDS), and cetyltrimethylammonium chloride (CTAC) are reported. Physicochemical variable influencing the sensitivity of the method have been optimized. A PIF method is developed for the determination of the four herbicides under study. Micellar media are found to provide the best analytical figures of merits. Linear dynamic ranges are established over about two orders of magnitude. The limit of detection (LOD) range from 0.2 to 6 ng ml(-1) according to the compound, with relative standard deviation (RSD) between 1.2 and 3.9%. Examples of applications to the analysis of these herbicides in spiked river water samples are given. The mean recoveries range from 80 to 104%.     

Thermodynamic study of the three isomers of bromo and iodobenzoic acids. Part II

Using our technique of combustion of small amount of a substance, we determined by calorimetry the standard molar enthalpy of formation in the condensed state and atT=298.15 K of the three isomers of bromo and iodobenzoic acids. Associating to these values their standard molar enthalpies of sublimation previously measured, it was possible to determine their standard molar enthalpies of formation in the gaseous state and atT=298.15 K. The experimental values of the thermodynamic properties _f H _m ^o (cr, 298.15 K), _f H _m ^o (cr, 298.15 K), _sub H _m ^o (298.15 K), and _f H _m ^o (g, 298.15 K) are given for the two series. From the experimental value of the standard molar enthalpy of atomization, it was possible to determine an enthalpy value for the C_b-Br and C_b-I bonds. The experimental and theoretical values of the resonance energy of bromo and iodobenzoic acids are compatible. The relative stability of some monosubstituted derivatives of benzoic acid studied in our laboratory is also discussed.Part I is concerned with Ref. 22 (for bromobenzoic acids) and with Ref. 23 (for iodobenzoic acids).