Temperature dependence of the Mössbauer spectra of amorphous and nanocrystallized Fe86Zr7Cu1B6

Mössbauer measurements have been performed on amorphous and nanocrystalline alloy ribbons of nominal composition Fe₈₆Zr₇Cu₁B₆. The nanocrystalline samples were obtained by annealing the as-quenched alloy at different temperatures in the range between 650 and 870 K. Mössbauer spectra of the as-quenched amorphous sample have been recorded at 77 K, room temperature and above the Curie temperature (330 K) at 360 K. We have also performed Mössbauer measurements at room temperature in the nanocrystalline alloys to characterize the phases that appear after the annealing and their relative concentration. The as-quenched sample spectra reveal the existence of two inequivalent sites for Fe. Such a feature is also observed in the remaining amorphous phase of the annealed samples. In the first steps of crystallization, -Fe precipitates and its concentration increases with the annealing temperature. The experimental results suggest that the composition of the whole amorphous phase does not suffer large changes during crystallization.     

Sample stacking with matrix removal for the determination of paraquat, diquat and difenzoquat in water by capillary electrophoresis

Conditions for the simultaneous determination of paraquat, diquat and difenzoquat by capillary zone electrophoresis using a stacking technique in a chemically modified capillary have been established. To apply the stacking method with sample matrix removal for the analysis of cations, an anodic electroosmotic flow is mandatory. For quats, 50 mM acetic acid-ammonium acetate (pH 4.0) with 5% (v/v) methanol as electrophoretic buffer and the addition of 0.8 mM cetyltrimethylammonium bromide as wall capillary organic modifier was proposed. Field polarity reversal time was optimised for several sample matrices. Detection was carried out at 220 and 255 nm. Detection limits, based on a signal-to-noise ratio of 3:1, were lower than 15 microg l(-1) for standards in Milli-Q water and two to ten times higher for drinking water samples. Run-to-run and day-to-day reproducibility have been established. The method was successfully applied to the determination of the three herbicides in spiked drinking water.     

Silicon determination in milk by electrothermal atomic absorption spectrometry using palladium as chemical modifier

A direct method for silicon determination in milk samples by Electrothermal Atomic Absorption Spectrometry was developed. Palladium was used as chemical modifier at a concentration of 610 mg L(-1); with this modifier, silicon was stable up to 1800 degrees C. The precision and accuracy of the method were investigated. The detection limit was 16.2, 2.7 and 7.2 micro g L(-1) for cows' milk, human milk and infant formula, respectively. The method was applied to silicon determination in 17 infant formula samples, 13 human milk samples and 12 cows' milk samples.     

Conformation of glycomimetics in the free and protein-bound state: structural and binding features of the C-glycosyl analogue of the core trisaccharide alpha-D-Man-(1 --> 3)-[alpha-D-Man-(1 --> 6)]-D-Man

The conformational properties of the C-glycosyl analogue of the core trisaccharide alpha-D-Man-(1 --> 3)-[alpha-D-Man-(1 --> 6)]-D-Man in solution have been carefully analyzed by a combination of NMR spectroscopy and time-averaged restrained molecular dynamics. It has been found that both the alpha-1,3- and the alpha-1,6-glycosidic linkages show a major conformational averaging. Unusual Phi ca. 60 degrees orientations for both Phi torsion angles are found. Moreover, a major conformational distinction between the natural compound and the glycomimetic affects to the behavior of the omega(16) torsion angle around the alpha-1 --> 6-linkage. Despite this increased flexibility, the C-glycosyl analogue is recognized by three mannose binding lectins, as shown by NMR (line broadening, TR-NOE, and STD) and surface plasmon resonance (SPR) methods. Moreover, a process of conformational selection takes place, so that these lectins probably bind the glycomimetic similarly to the way they recognize the natural analogue. Depending upon the architecture and extension of the binding site of the lectin, loss or gain of binding affinity with respect to the natural analogue is found.     

Determination of salicylate in blood serum using an amperometric biosensor based on salicylate hydroxylase immobilized in a polypyrrole-glutaraldehyde matrix

The use of an amperometric biosensor for the salicylate determination in blood serum is described. The biosensor is based on salicylate hydroxylase (EC 1.14.13.1) electropolymerized onto a glassy carbon-working electrode with polypyrrole and glutaraldehyde, to improve the biosensor lifetime. The hexacyanoferrate (II) was also incorporated to work as a redox mediator to minimize possible interferences. The salicylate is enzymatically converted to catechol, which is monitored amperometrically by its electrooxidation at+0.170 V versus SCE (saturated calomel electrode). Salicylate determination was carried out maintaining the ratio between beta-NADH and salicylate at 4:1 (30 degrees C). The amperometric response of the biosensor was linearly proportional to the salicylate concentration between 2.3x10(-6) and 1.4x10(-5) mol l(-1), in 0.1 mol l(-1) phosphate buffer (pH 7.8), containing 0.1 mol l(-1) KCl and 5.0x10(-4) mol l(-1) Na(2)H(2)EDTA, as supporting electrolyte. The recovery studies, in the presence of several interfering compounds, showed recoveries between 96.4 and 104.8%. The useful lifetime of the biosensor in the concentration range evaluated was at least 40 days, in continuous use. Blood serum samples analyzed by this biosensor showed a good correlation compared to the spectrophotometric method (Trinder) used as reference, presenting relative deviations lower than 7.0%.