Effect of short glass fiber on structure and viscoelastic behavior of olefinic polymers synthesized with metallocene catalyst

Several composites were prepared on the basis of an ethylene homopolymer and different copolymers of ethylene and 1‐hexene, synthesized with a metallocene catalyst, as matrices and a content of a 5 wt % of short glass fiber. The effect of the fiber incorporation on the structure and mechanical and viscoelastic behaviors was analyzed for the different samples. The glass fibers induced a slightly higher crystallinity, and the crystallite morphology significantly changed (long spacings and crystal orientation). The incorporation of fibers did not reinforce the different matrices under study at this low content; consequently, the mechanical parameters, such as Young's modulus, yielding stress, and microhardness, were lower in the composites as compared with those values found in the neat polyolefins. The location and apparent activation energies of distinct relaxation processes are also discussed. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1244–1255, 2003     

Optimal entropic uncertainty relation for successive measurements in quantum information theory

We derive an optimal bound on the sum of entropic uncertainties of two or more observables when they are sequentially measured on the same ensemble of systems. This optimal bound is shown to be greater than or equal to the bounds derived in the literature on the sum of entropie uncertainties of two observables which are measured on distinct but identically prepared ensembles of systems. In the case of a two-dimensional Hilbert space, the optimum bound for successive measurements of two-spin components, is seen to be strictly greater than the optimal bound for the case when they are measured on distinct ensembles, except when the spin components are mutually parallel or perpendicular     

Diffusion Structural Analysis Study of Titania Films Deposited by Sol-Gel Technique on Silica Glass

The diffusion structural analysis (DSA) was used to characterize microstructure changes of hydrous titania gel films under in situ conditions of heating. TG and DTA were used in order to elucidate the processes controlling the formation of anatase film during heating of hydrous titania gel film. The annealing of porosity and near surface structure defects of the dehydrated titania films was indicated by DSA in the temperature range 255–700°C as the decrease of radon release rate. It was demonstrated that the annealing was enhanced on heating in oxygen in comparison with heating in argon. The DSA experimental results were compared with model curves describing the radon diffusion mobility and the annealing of radon diffusion paths.     

Mechanisms for the SAR Imaging of the Ocean

We perform a comparative analysis of two mechanisms for the formation of a synthetic aperture radar (SAR) image of the ocean, which are related to orbital velocities on the surface. It is shown that the mechanism of fluctuations of the effective density of scatterers, which is commonly accepted at present as the physical basis for the SAR diagnostics of roughness, actually works only in the case of a sufficiently flat swell. In the presence of wind roughness, the dominant role is played by another mechanism, namely, fluctuations of the number of surface elements whose images are randomly shifted and superimposed in the image plane due to orbital velocities. In the case of a developed wind roughness propagated in the azimuthal direction, the power contributions of two above-mentioned mechanisms to the SAR imaging of the ocean differ by about two orders of magnitude.     

Angular correlations in the decays of two unstable identical particles with close momenta

For the decay of two identical particles with close momenta, the angular correlations between the directions of emission of decay products are considered on the basis of the model of independent single-particle sources emitting unstable unpolarized particles of nonzero spin. These correlations reflect spin correlations that are caused by quantum-statistics and final-state-interaction effects. A general theory of angular correlations in the decays of two arbitrarily polarized particles (resonances) is constructed.     

Measurement of the differential cross section and of the tensor and vector analyzing powers for the fragmentation of 4.5-GeV/c deuterons on beryllium in the reaction involving proton emission at an angle of 80 mrad

The invariant differential cross section, the tensor analyzing power A _yy , and the vector analyzing power A _y for the reaction ⁹Be(d, p)X are measured at an initial deuteron momentum of 4.5 GeV/c and a proton detection angle of about 80 mrad. The data obtained for the differential cross section are consistent with the results of measurements at 3.5 and 5.78 GeV/c and a proton emission angle of 2.5°. The values found for the tensor analyzing power A _yy are compared with similar data obtained previously for the deuteron-fragmentation process occurring on a carbon target at various values of the initial deuteron momentum and leading to proton emission at zero angle. The data on the differential cross section for the reaction ⁹Be(d, p)X can be satisfactorily described within the relativistic impulse approximation by using standard deuteron wave functions; however, the approach based on this conceptual framework proves to be inadequate in dealing with data on the tensor analyzing power. These results indicate that it is necessary either to change the method for describing the relativistic deuteron or to take into account additional mechanisms.     

Unforeseen formation of 2-bromo-3-hydroxybenzaldehyde by bromination of 3-hydroxybenzaldehyde

Contrary to literature reports, bromination of 3-hydroxybenzaldehyde can afford both 2-bromo-5-hydroxybenzaldehyde and 2-bromo-3-hydroxybenzaldehyde, but 4-bromo-3-hydroxybenzaldehyde was not detected. 2-Bromo-3-hydroxybenzaldehyde was converted into 2-(benzyloxy)-1-bromo-5-methoxy-7-methylnaphthalene. X-ray crystallographic analysis supports the identity of 2-bromo-3-hydroxybenzaldehyde.     

Sensitivity analysis of an optimized bar-spring model with hill-top branching

Summary Characteristics of optimal solutions under nonlinear buckling constraints are investigated by using a bar-spring model. It is demonstrated that optimization under buckling constraints of a symmetric system often leads to a structure with hill-top branching, where a limit point and bifurcation points coincide. A general formulation is derived for imperfection sensitivity of the critical load factor corresponding to a hill-top branching point. It is shown that the critical load is not imperfection-sensitive even for the case where an asymmetric bifurcation point exists at the limit point.