Fe-Cr-V-Ni-Si-C系多元合金的原子间互作用势的构建及应用

使用第一性原理赝势方法及量子化学从头算方法计算的物理量以及最小二乘法拟合的数据构建了多元合金Fe-Cr-V-Ni-Si-C系的原子间互作用势,并利用该原子间互作用势计算了实验合金N5(Fe9.07Cr7.56V0.8Ni0.49 Mo0.96Mn1.52Si3.3C),N6(Fe9.65Cr7.72V1.17Ni0.50Mo0.91Mn1.42Si3.3C),N7(Fe9.81Cr7.65V1.58Ni0.46Mo0.86Mn1.35Si3.3C),N8(Fe10.05Cr7.59V2.24Ni0.40M 关键词： F-S多体势 多元合金 第一性原理     

Design of a higher harmonic cavity for the SSRF storage ring

Higher harmonic cavity used in the third generation synchrotron light source increases the Touschek lifetime. The higher harmonic cavity of Shanghai Synchrotron Radiation Facility (SSRF) is a 1.5GHz passive superconducting cavity. Its higher order modes (HOM) are extracted by a ferrite HOM damper out of the cryostat. Multi-cell cavity is chosen concerning the voltage. The harmonic cavity dynamics, beam dynamics with passive harmonic cavity and the design of single cell cavity are included in this paper.     

Studies on high order mode of bell-shaped prototype cavities

Aluminium and copper prototype cavities were designed to study higher order modes (HOM). An automatic field mapping system was developed with LabVIEW to measure the radiofrequency (RF) characteristics, such as resonant frequency, Q-value, shunt impedance and electromagnetic field distribution of the higher-order modes in a model RF cavity. Two kinds of the bell-shaped cavities were measured using the field mapping system, their frequencies are 1.5GHz and 800~MHz respectively. The fields' distributions of the monopole modes and dipole modes, as well the R/Q values, were measured.     

含双圆柱亚表面缺陷板条材料的表面温度分布

基于非傅里叶热传导方程,采用复变函数法和镜像法,研究了含双圆柱亚表面缺陷板条材料热波散射的温度场,并给出了热波散射温度场的解析解。分析了入射波波数、热扩散长度、缺陷的埋藏深度以及板条材料的厚度等对板条表面温度分布的影响。温度波由调制光束在材料表面激发,缺陷表面的边界条件为绝热。该分析方法和数值结果可为工程材料结构的传热分析、热波成像和材料内部缺陷评估,以及热物理反问题研究提供参考。     

Electrical Characteristics of Copper Phthalocyanine Thin-Film Transistors with Polyamide-6/Polytetrafluoroethylene Gate Insulator

Polyamide-6（PA 6）/polytetrafluoroethylene is studied as a potential gate dielectric for flexible organic thin film transistors. The same method used for the formation of organic semiconductor and gate dielectric films greatly simplifies the fabrication process of devices. The fabricated transistors show good electrical characteristics. Ambipolar behaviour is observed even when the device is operated in air.     

Synthesis of N-type semiconductor diamonds with sulfur,boron co-doping in FeNiMnCo-C system at high pressure and high temperature

A series of diamonds with boron and sulfur co-doping were synthesized in the Fe Ni Mn Co-C system by temperature gradient growth(TGG) under high pressure and high temperature(HPHT). Because of differences in additives, the resulting diamond crystals were colorless, blue-black, or yellow. Their morphologies were slab, tower, or minaret-like. Analysis of the x-ray photoelectron spectra(XPS) of these diamonds shows the presence of B, S, and N in samples from which N was not eliminated. But only the B dopant was assuredly incorporated in the samples from which N was eliminated. Resistivity and Hall mobility were 8.510 ?·cm and 760.870 cm~2/V·s, respectively, for a P-type diamond sample from which nitrogen was eliminated. Correspondingly, resistivity and Hall mobility were 4.211×10~5 ?·cm and 76.300 cm~2/V·s for an N-type diamond sample from which nitrogen was not eliminated. Large N-type diamonds of type Ib with B–S doping were acquired.     

Effects of multiple interruptions with trimethylindium-treatment in the InGaN/GaN quantum well on green light emitting diodes

In this study, the influence of multiple interruptions with trimethylindium(TMIn)-treatment in InGaN/GaN multiple quantum wells(MQWs) on green light-emitting diode(LED) is investigated. A comparison of conventional LEDs with the one fabricated with our method shows that the latter has better optical properties. Photoluminescence(PL) full-width at half maximum(FWHM) is reduced, light output power is much higher and the blue shift of electroluminescence(EL) dominant wavelength becomes smaller with current increasing. These improvements should be attributed to the reduced interface roughness of MQW and more uniformity of indium distribution in MQWs by the interruptions with TMIn-treatment.     

Large single crystal diamond grown in FeNiMnCo-S-C system under high pressure and high temperature conditions

Large diamonds have successfully been synthesized from FeNiMnCo-S-C system at temperatures of 1255-1393 ℃and pressures of 5.3-5.5 GPa.Because of the presence of sulfur additive,the morphology and color of the large diamond crystals change obviously.The content and shape of inclusions change with increasing sulfur additive.It is found that the pressure and temperature conditions required for the synthesis decrease to some extent with the increase of S additive,which results in left down of the V-shape region.The Raman spectra show that the introduction of additive sulfur reduces the quality of the large diamond crystals.The x-ray photoelectron spectroscopy(XPS) spectra show the presence of S in the diamonds.Furthermore,the electrical properties of the large diamond crystals are tested by a four-point probe and the Hall effect method.When sulfur in the cell of diamond is up to 4.0 wt.%,the resistance of the diamond is 9.628×10~5 Ω·cm.It is shown that the large single crystal samples are n type semiconductors.This work is helpful for the further research and application of sulfur-doped semiconductor large diamond.     

Coexistence of unipolar and bipolar modes in Ag/ZnO/Pt resistive switching memory with oxygen-vacancy and metal-Ag filaments

In this study, the unipolar resistive switching(URS) and bipolar resistive switching(BRS) are demonstrated to be coexistent in the Ag/Zn O/Pt memory device, and both modes are observed to strongly depend on the polarity of forming voltage. The mechanisms of the URS and BRS behaviors could be attributed to the electric-field-induced migration of oxygen vacancies(VO) and metal-Ag conducting filaments(CFs) respectively, which are confirmed by investigating the temperature dependences of low resistance states in both modes. Furthermore, we compare the resistive switching(RS)characteristics(e.g., forming and switching voltages, reset current and resistance states) between these two modes based on VO- and Ag-CFs. The BRS mode shows better switching uniformity and lower power than the URS mode. Both of these modes exhibit good RS performances, including good retention, reliable cycling and high-speed switching. The result indicates that the coexistence of URS and BRS behaviors in a single device has great potential applications in future nonvolatile multi-level memory.     

基于有限元法分析宝石级金刚石的合成腔体温度场

以有限元法为理论分析手段模拟分析了温度梯度法合成宝石级金刚石大单晶的腔体温度场,实现了对宝石级金刚石的合成腔体内各位置温度同时测量.模拟结果表明:在宝石级金刚石合成过程中,其温度分布呈不均匀分布.腔体内高温区分布在样品(碳源+触媒)边缘,低温区分布在籽晶附近.样品腔内热量的传递方式和样品腔内的碳源输运方式相同,均由碳源的两侧向籽晶附近传输.籽晶附近轴向温度梯度大于径向温度梯度,导致单位时间内其轴向生长尺寸大于径向生长尺寸.宝石级金刚石腔体温度场分析的理论模型的成功构建,为新型宝石级金刚石腔体的研制提供了良好的设计基础,对促进优质宝石级金刚石的生长技术具有指导意义.