三维荧光光谱技术在水监测中的应用

应用荧光光谱技术分析水中污染物的含量具有灵敏度高、检测速度快等优点,三维荧光光谱技术可以提供在普通的荧光光谱中所得不到的信息,此技术可以用于多组分同时测量。讨论了如何运用三维荧光光谱技术分析水中污染物的成分,计算其含量,并给出了有效的荧光光谱特征数据库建立、多组分分析和浓度反演的数学模型。     

平行排列液晶器件的波前调制特性

设计了一种新型的平行排列液晶相位调制器(LC PM),可在纯相位的模式下进行相位调制,研究了液晶相位调制器的光学特性,理论上给予了分析．对畸变波前进行了调制,在1 cm2的校正面积上,调制后的准确度PV(peak to valley)值接近λ／15(λ=0.6328 μm),RMS(Root Means Square)可达到λ／100,斯特列尔比SR (Strehl Ratio)达到0.989．改变了传统的扭曲向列液晶器件难于进行纯相位调制和得到高准确度调制的缺点,达到了理想的效果.     

激光诱导荧光探测水体中溶解有机物浓度

用Nd∶YAG激光器的三倍频355 nm光作为激发光源,根据激光诱导荧光(LIF)方法激发并探测污染水体的荧光光谱.通过对荧光光谱的分析处理研究归一化荧光强度,即450 nm处水中溶解有机物(DOM)峰与405 nm处水的拉曼峰的比值,反演溶解有机物浓度.用商品腐殖酸和去离子水配置成已知浓度的溶液代替标准DOM溶液进行标定,得到回归方程.结果证明,DOM的归一化荧光强度与水体中DOM浓度有较好的线性关系,因此LIF方法是对大面积水域水质进行动态遥测的较理想方法.     

Measurements of AIM for Visible Wavelength Based on Individual Eye Model

We measure and calculate the aerial image modulation （AIM） of human retina for visible wavelengths based on the individual eye model. By employing the optical design software ZEMAX, we obtain the modulation transfer function （MTF） of human eye in visible wavelengths. Using CSV-1000 and VAF-1000, the contrast sensitivity function （CSF） and the visual acuity （VA） for the same eye are measured. Then the AIM of human retina could be acquired by the relations between MTF and CSF and between MTF and VA. The AIM of human retina is independent of MTF, and the values of AIM for normal eyes （without retina disease） are similar, so the assembly average for large numbers of normal eyes can be a standard AIM curve, which is helpful for the diagnosis of diseases in the retina system.     

水体的温度变化对测定溶解有机物浓度的影响

用激光诱导荧光(LIF)方法研究了水体的温度变化对溶解有机物(DOM)发射荧光强度的影响。随着温度的增加,DOM的荧光强度和水的拉曼散射强度不断降低。在20～75 ℃范围之内,对归一化荧光强度与温度关系曲线进行线性拟合,计算出归一化荧光强度随温度升高的变化梯度平均值为-5.24×10-4 ℃-1,根据归一化荧光强度与浓度的关系,给出了所测DOM的浓度随着温度升高的平均下降速率为-3.45×10-3 (mg·L-1)·℃-1。因此,在这一温度范围内测量时,假设归一化荧光强度不变,则温度变化将引起DOM浓度最大为8.45%的相对变化。     

新型掺偶氮苯聚合物的取向增强及全息存储

研究一种新型的并列式的高密度存储材料ADPA-PVK-PBA-TNF聚合物薄膜.在非吸收区用光抽运测试法研究了薄膜光致双折射,获得光致双折射变化值Δn=1.3×10^-3,分析了该聚合物薄膜光致取向增强的物理和化学机理.探讨了抽运光对光致双折射的增强和抑制效应.在此基础上初步实现了多重角度复用信息存储、获得了较为清晰的全息存储图像.并讨论了图象存储的增强/抑制效应,利用这种效应可对存储图像处理或删除. 关键词： 掺杂偶氮苯聚合物薄膜 光致双折射 光全息存储 光致取向增强     

Analysis of resistive switching behaviors of vanadium oxide thin film

We demonstrated the polarization of resistive switching for Cu/VO_x/Cu memory cell. Switching behaviors of Cu/VO_x/Cu cell were tested by semiconductor device analyzer (Agilent B1500A), and the relative micro-analysis of I-V characteristics of VO_x/Cu was characterized by conductive atomic force microscope (CAFM). The I-V test results indicated that both forming and the reversible resistive switching between low resistance state (LRS) and high resistance state (HRS) can be observed under either positive or negative sweep. The CAFM images for LRS and HRS directly exhibited evidences of the formation and rupture of filaments based on positive or negative voltage. Cu/VO_x/Cu sandwiched structure exhibits a reversible resistive switching behavior and shows potential applications in the next generation nonvolatile memory field.     

Large-Quantity Synthesis of Single-Crystalline Metal Indium Nano/Sub-Micron Wires

Large quantities of metal indium single-crystalline wires with diameters ranging from tens of nanometres to a few micrometres were synthesized on Si substrates. Unlike traditional methods for the fabrication of nanowires or nanorods, liquid indium was squeezed out of the pores and cracks from porous an InAlN layer to form the wires. Continuous pushing out of liquid metal indium under strength, lowering of liquid-solid interfaces and the confinement of the cracks all contribute to the growth of indium wires. Our experiments have shed some light on the possibility of synthesizing large quantities quasi-1D nano/sub-micron structures with specified cross-sectional geometry using the similar method.     

气炮加载实验中拉曼光谱技术的发展及应用

拉曼光谱技术已经成为静高压实验中诊断物质微观结构的重要手段之一。本文主要综述拉曼光谱技术在动态加载实验中的发展及应用现状。拉曼光谱技术和气炮加载技术相结合,由于采集信号时间短、杂散光强等,其技术难度比较大。迄今,仅有少数几个气炮加载实验室具备冲击拉曼光谱诊断能力。本文首先介绍了气炮加载拉曼光谱技术的发展历程,然后通过对现有文献的分析,总结出当前该技术的瓶颈。最后陈述了拉曼光谱在研究动态加载过程中透明介质微观结构变化方面的优势。     

场发射冷阴极微栅孔阵列制备技术

实现了一种采用聚苯乙烯纳米球自组装技术和微机械制造技术加工的场发射阴极用亚微米栅极微孔阵列。设计了一套完整的工艺实验方案,首先采用微球自组装技术获得了亚微米级金属网孔掩膜,然后通过反应离子刻蚀技术获得了亚微米栅极孔阵列,从而实现了集成度高、分布均匀的周期性亚微米孔洞阵列的制备,微孔集成度达到108cm-2。实验研究了氧气刻蚀聚苯乙烯微球的规律。采用金属掩膜,四氟化碳干法刻蚀二氧化硅,获得了深度为500 nm的微孔。实验结果证明该工艺方案是一种获得大面积、均匀分布、集成度高的场发射冷阴极栅孔阵列的有效方法。