光子晶体中双通道之间能量的转移

从理论和实验上分析了光子晶体中双通道之间能量的转移.在双通道之间引入复合型光子晶体波导,通过调节复合型波导的内部参数，使其满足一定的条件，就可以实现双通道之间能量的完全转移，从而实现了光的定向传输.在实验中，测得了输出端的透过谱. 关键词： 复合型光子晶体波导 能量转移 定向传输     

Absolute Gap of Two-Dimensional Fractal Photonic Structure

We propose a model for two-dimensional photonic materials constructed on a kind of fractal structures. Total energy flows of the photonic materials constructed with either dielectric cylinders or air holes show that both of them possess absolute gaps for the electromagnetic waves.     

近红外波段硅基金属光子晶体平板的亚波长成像特性

利用时域有限差分方法,理论上研究了由正方形金属嵌入背景材料硅中组成的二维正方晶格和三角晶格光子晶体的亚波长成像特性。采用Drude模型描述金属银的色散特性,在近红外波段该模型可以很好地描述金属的实际介电常数。通过结构参数的设计,在上述两种结构中实现了波长在1550nm附近的亚波长成像,并且发现金属对入射光的吸收使得成像位置处的光强稍有降低,但是对于光子晶体亚波长成像的质量并无影响。相对于通常的硅基空气孔型光子晶体亚波长成像器件,该种硅基金属型全固态光子晶体结构更加稳定,因而可以更好地在复杂全光集成回路中加以实际应用。     

二维八重准晶有机光子晶体平板的光学传播特性

采用时域有限差分法研究了二维八重准晶有机光子晶体的光传输特性,重点分析了光束在聚苯乙烯空气柱平板结构和聚苯乙烯介质柱结构中的透射特性与光局域特性。研究结果表明,即使在低折射率对比度的情况下,两种完整八重准晶平板结构中均出现了可见光波段的光子带隙和本征模,且光子带隙中心位置随着平板厚度的增大而红移。当在两种准晶结构中引入缺陷微腔时,带隙内的缺陷模产生位置和波长红移特性随着微腔结构的变化规律明显不同,这种差异性是由两种物理机制(即光子晶体缺陷能级变化与微腔所支持的驻波条件)共同作用的结果。这一研究结果将为实验制备有机准晶发光器件提供一定的理论基础。     

Two-dimensional ring-type photonic crystals in the near-infrared region

We propose a ring photonic crystal working in the near infrared region, where the air holes in the background material GaAs are arranged to form a series of rings. We find that the band gaps do not depend on the incident direction, and only a small number of rows are needed to create a frequency gap in the transmission spectrum. The transmission spectra of both P and S polarizations show that there is a complete bandgap in the hexagonal ring photonic crystals and the ratio of gap width to mid-gap frequency is as high as 11%.     

Engineering the light propagating features through the two-dimensional coupled-cavity photonic crystal waveguides

This paper studies the propagating characteristics of the electromagnetic waves through the coupled-resonator optical waveguides based on the two-dimensional square-lattice photonic crystals by the finite-difference time-domain method.When the traditional circular rods adjacent to the centre of the cavities are replaced by the oval rods,the simulated results show that the waveguide mode region can be adjusted only by the alteration of the oval rods’ obliquity.When the obliquity of the oval rods around one cavity is different from the obliquity of that around the adjacent cavities,the group velocities of the waveguide modes can be greatly reduced and the information of different frequencies can be shared and chosen at the same time by the waveguide branches with different structures.If the obliquities of the oval rods around two adjacent cavities are equal and they alternate between two values,the group velocities can be further reduced and a maximum value of 0.0008c(c is the light velocity in vacuum) can be acquired.     

Band Gaps of an Amorphous Photonic Materials

A new kind of amorphous photonic materials is presented.Both the simulated and experimental results show that although the disorder of the whole dielectric structure is strong,the amorphous photonic materials have two photonic gaps.This confirms that the short-range order is an essential factor for the formation of the photonic gaps.     

基于环形微腔的多频段三角晶格光子晶体耦合腔波导光学传输特性

本文理论研究了近红外波段硅基三角晶格光子晶体环形微腔的光场局域特性,通过将微腔在空间周期性排列组成耦合腔光波导,研究了多个导带区域内光束传输时的群速度,最大和最小值分别为0.0028c和0.00028c.将环形微腔在垂直于光传输方向上进行交错排列,通过改变相邻微腔之间的耦合区域,可以大幅降低多频段范围内光束在耦合腔波导中传输时群速度之间的差异,并提高部分频段的透过率数值.在不改变介质柱半径条件下,通过去掉三角晶格光子晶体中距中心介质柱距离分别为2a和√3a的六个介质柱构成了两种微腔,研究了两种微腔所支持的谐振波长之间的差异,在此基础上构造了两种耦合腔波导,进而将这两种耦合腔光波导与W1型输入/输出波导相连,最终实现了在多个不同频率范围内降低群速度的同时实现频段选择和频段分束功能,其导模群速度可降低到0.00047c.     

一维边发射有机半导体光子晶体激光器设计

基于有机共轭聚合物聚[2-甲氧基-5-(2-乙基己氧基)-1,4-苯乙炔](MEH-PPV)的脊形波导,利用光子晶体特殊的光调制特性,模拟设计了一维边发射有机光子晶体激光器。利用光子晶体的带隙结构和带边效应构建了由光子晶体全反镜和透反镜形成的谐振腔,在谐振腔内的脊形波导上引入一维缺陷型光子晶体,利用光子晶体缺陷模特性抑制了多纵模竞争,并在此基础上分析了复合结构所导致的边界模效应,得出此类非金属微腔激光器腔长设计的经验公式。模拟结果表明该一维边发射有机光子晶体激光器可实现中心波长为588nm、半峰全宽为0.131nm的单纵模激光输出。     

Negative refraction and subwavelength imaging of a photonic-crystal slab for the frequencies in the third band

Negative refraction and subwavelength imaging properties of a two-dimensional （2D） photonic crystal （PC） slab are studied by the finite-difference time-domain method. The PC consists of a triangular lattice of air holes immersed in a dielectric. For a certain frequency range in the third photonic band, the directions of the group velocities and the phase velocities can be opposite, so the PC can work as a kind of negative refractive-index material. The light radiated from a point source can form a subwavelength image spot through the PC slab. Negative refraction and an effective refractive index of the PC slab n = -1 can be achieved for the incident wave with its incident angle within a certain range.