基于能量变分法的钢底板波形钢腹板组合箱梁畸变效应分析

为合理分析钢底板波形钢腹板梯形箱梁的畸变效应,按各板件面内外抗弯刚度不变的原则将全截面等效为钢材,利用圣维南原理考虑顶底板对波形钢腹板的约束作用,修正畸变扇性坐标分布模式,基于能量变分法建立畸变控制微分方程。与已有文献及有限元进行对比分析,并研究腹板俯角和波形钢腹板厚度变化对畸变翘曲正应力的影响。结果表明,本文解析解与文献解及ANSYS解均吻合较好;基于圣维南原理修正后的扇形坐标分布模式更合理;利用本文等效方法亦可分析传统波形钢腹板组合箱梁的畸变效应;腹板俯角的设置有利于减小畸变翘曲正应力;波形钢腹板厚度变化对腹板与底板交接处的畸变翘曲正应力影响显著。     

基于飞秒激光直写光纤光栅的掺镱光纤激光器

 利用飞秒激光微加工技术,可以在光纤纤芯内直写出布拉格光栅,它与传统的光纤光栅制作方法相比,具有耗时短、无需光敏光纤、周期可任意设定、光栅稳定性高等优点。采用800 nm钛宝石飞秒激光器,在Hi1060光纤内写入一支8 mm长的布拉格光栅,光纤光栅的周期为2.9 μm,这是中心波长为1 042 nm的八阶光纤布拉格光栅。将所得光栅与一段有源的双包层光纤熔接,作为激光输出镜,利用975 nm的LD光纤模块作为泵浦源,采用端泵浦技术构成双包层光纤激光器。双包层光纤采用Nufern公司镱(Yb³⁺)离子掺杂双包层光纤,光纤长度3 m。所得激光器的输出功率为71.1 W,中心波长1 042 nm,带宽约为0.8 nm。     

Coherent Scattering of Light by Bose-Einstein Condensation in a Tight Confinement

We have observed strong scattering of a probe light by dilute Bose-Einstein condensate （BEC） ^87Rb gas in a tight magnetic trap. The scattering light forms fringes at the image plane. It is found that we can infer the real size of the condensation and the number of the atoms by modelling the imaging system. We present a quantitative calculation of light scattering by the condensed atoms. The calculation shows that the experimental results agree well with the prediction of the generalized diffraction theory, and thus we can directly observe the phase transition of BEC in a tight trap.     

Semiconductor-Optical-Amplifier-Based Inverted and Non-Inverted Wavelength Conversion at 40 Gb/s Using a Detuning Optical Bandpass Filter

We experimentally demonstrate 40Gb/s semiconductor-optical-amplifier-based tunable wavelength conversion （WC） using a detuning optical bandpass filter. Both inverted and non-inverted WCs are obtained by shifting the filter central wavelength with respect to the probe wavelength. When the filter is red shifted by 0.4nm or blue shifted by 0.3nm, the WC is non-inverted. However, when the filter is blue shifted by 0.1 nm, the WC is inverted. It is experimentally demonstrated that the WC has a tunable range covering the C-band.     

Growth and Characterization of A1GaN/A1N/GaN HEMT Structures with a Compositionally Step-Graded A1GaN Barrier Layer

A new A1GaN/A1N/GaN high electron mobility transistor （HEMT） structure using a compositionally step-graded A1GaN barrier layer is grown on sapphire by metalorganic chemical vapour deposition （MOCVD）. The structure demonstrates significant enhancement of two-dimensional electron gas （2DEG） mobility and smooth surface morphology compared with the conventional HEMT structure with high A1 composition A1GaN barrier. The high 2DEG mobility of 1806 cm2/Vs at room temperature and low rms surface roughness of 0.220 nm for a scan area of 5μm×5 μm are attributed to the improvement of interracial and crystal quality by employing the stepgraded barrier to accommodate the large lattice mismatch stress. The 2DEG sheet density is independent of the measurement temperature, showing the excellent 2DEG confinement of the step-graded structure. A low average sheet resistance of 314.5Ω/square, with a good resistance uniformity of 0.68%, is also obtained across the 50 mm epilayer wafer. HEMT devices are successfully fabricated using this material structure, which exhibits a maximum extrinsic transconductance of 218 mS/ram and a maximum drain current density of 800 mA/mm.     

An Economical Magnetocardiogram System Based on High-To SQUIDs

An economical magnetocardiogram （MCG） system is built in our laboratory. It mainly consists of a MCG data acquisition stage equipped with two high-To superconducting quantum interference device （SQUID） magnetometers, a data processing stage with digital filtering and a one-layer μ-metal magnetically shielded room in conjunction with a high-Tc SQUID based active compensation. Experimental results show that a noise level of pico-tesla in MCG profiles, which is necessary for clinical applications, may be achieved with the system. Moreover, stable and convenient operations of the system are demonstrated with simulating MCG measurements.     

实施概念图教学对学生物理学习影响的实证研究

概念图教学作为一种教学策略，在国外有着广泛的研究和应用．国内也有不少文献对此进行了介绍．概念图教学在物理教学中的实验研究，在一定程度上证实了概念图教学对学生的物理学习有影响，概念图教学优于传统的物理教学．     

表面人工低维结构的功能设计与构造

可控地构造具有一定功能的表面人工低维结构,并且总结、理解体系微观结构对其宏观性质影响的一般规律,不仅对探索低维基本物理以及其中的新奇量子现象至关重要,更是微电子工业保持持续发展的关键前提.这方面的研究包括发展新的生长技术实现对体系形成过程的精确控制,对获得的材料做高分辨率的表征;从理论上则要理解体系的生长过程,阐明热力学、动力学的作用机理,从而指导制备技术的发展.深入研究表面人工低维结构的性质更可能导致新物理现象与原理的发现,产生全新的器件概念,进一步反馈给体系功能的设计,推动基础研究与应用探索的发展.文章简要介绍了表面物理国家重点实验室近年来在表面人工低维结构的功能设计与构造方面的研究成果     

迈克耳孙干涉仪中的镜面面形误差研究分析EI北大核心CSCD

从迈克耳孙干涉仪干涉原理出发,分析了圆形镜面抛光面形误差对干涉调制度的影响。由于存在镜面面形误差,干涉调制度不能达到理想情况下的100%,但其干涉调制度不能低于理想情况下的90%。通过分析和讨论,镜面面形误差最好控制在λ/14以内,干涉调制度才可能不低于90%,这样干涉仪才能保持比较满意的性能。同时,使用Zygo干涉仪对5组平面镜的平面度进行了测量,得到了这5组平面镜的峰-峰值和其他一些参数,通过分析测量结果,这5组平面镜的平面度都能达到干涉调制度的要求。通过对迈克耳孙干涉仪中平面镜面形误差的研究,这对于干涉光谱仪的设计、研制和性能的分析都具有一定的指导意义。     

利用提升小波的蛋白质相互作用特征提取

利用提升小波从蛋白质序列中提取出它们相互作用的频谱特征,经支持向量机训练学习后,用于预测蛋白质间的相互作用.模拟计算结果表明,在阳性数据和阴性数据平衡的前提下,利用提升小波获取的低维蛋白质相互作用特征向量可以得到较高预测精度.进一步阐述了不同物种的蛋白质相互作用网络有着不同特征,为了得到更准确的预测结果,需要利用不同的方法提取蛋白质相互作用的特征.