The improvement of Al2O3/AlGaN/GaN MISHEMT performance by N2 plasma pretreatment

This paper discusses the effect of N 2 plasma treatment before dielectric deposition on the electrical performance of a Al2O3 /AlGaN/GaN metal-insulator-semiconductor high electron mobility transistor(MISHEMT),with Al2O3 deposited by atomic layer deposition.The results indicated that the gate leakage was decreased two orders of magnitude after the Al2O3 /AlGaN interface was pretreated by N 2 plasma.Furthermore,effects of N 2 plasma pretreatment on the electrical properties of the AlGaN/Al2O3 interface were investigated by x-ray photoelectron spectroscopy measurements and the interface quality between Al2O3 and AlGaN film was improved.     

Study on the degradation of NMOSFETs with ultra-thin gate oxide under channel hot electron stress at high temperature

This paper studies the degradation of device parameters and that of stress induced leakage current (SILC) of thin tunnel gate oxide under channel hot electron (CHE) stress at high temperature by using n-channel metal oxide semiconductor field effect transistors (NMOSFETs) with 1.4-nm gate oxides. The degradation of device parameters under CHE stress exhibits saturating time dependence at high temperature. The emphasis of this paper is on SILC of an ultra-thin-gate-oxide under CHE stress at high temperature. Based on the experimental results, it is found that there is a linear correlation between SILC degradation and V_h degradation in NMOSFETs during CHE stress. A model of the combined effect of oxide trapped negative charges and interface traps is developed to explain the origin of SILC during CHE stress.     

超深亚微米PMOS器件的NBTI退化机理

对超深亚微米PMOS器件的负栅压温度不稳定性(NBTI)退化机理进行了研究.主要集中在对器件施加NBT和随后的PBT应力后器件阈值电压的漂移上.实验证明反型沟道中空穴在栅氧中的俘获以及氢分子在栅氧中的扩散是引起NBTI退化的主要原因.当应力条件变为PBT时，陷落的空穴可以快速退陷，但只有部分氢分子可以扩散回栅氧与衬底界面钝化硅悬挂键，这就导致了PBT条件下阈值电压只能部分恢复. 关键词： 超深亚微米PMOS器件 负偏压温度不稳定性 界面陷阱 氢气     

斜切蓝宝石衬底MOCVD生长GaN薄膜的透射电镜研究

利用MOCVD技术在斜切角度为0.3°的c面蓝宝石衬底上生长了非故意掺杂 GaN 薄膜, 并采用透射电子显微镜对材料的质量和材料内部缺陷进行了分析. 研究发现斜切蓝宝石衬底上外延的GaN材料中,位错在距离衬底0.8 μm附近大量湮灭, 同时位错扎堆出现.基于上述现象, 提出了斜切衬底上GaN材料中位错的湮灭机制, 解释了斜切衬底能够提高GaN晶体质量的原因.     

The etching of a-plane GaN epilayers grown by metal--organic chemical vapour deposition

Morphology of nonpolar (1120) a-plane GaN epilayers on r-plane (1102) sapphire substrate grown by low-pressure metal-organic vapour deposition was investigated after KOH solution etching. Many micron-and nano-meter columns on the a-plane GaN surface were observed by scanning electron microscopy. An etching mechanism model is proposed to interpret the origin of the peculiar etching morphology. The basal stacking fault in the a-plane GaN plays a very important role in the etching process.     

60Co γ射线辐射对AlGaN/GaN HEMT器件的影响

采用⁶⁰Co γ射线辐射源对非钝化保护的AlGaN/GaN高电子迁移率晶体管(HEMT)器件进行了1 Mrad(Si)的总剂量辐射,实验发现辐射累积剂量越大,器件尺寸越小,器件饱和漏电流和跨导下降越明显,同时辐射后器件栅泄漏电流明显增大,而阈值电压变化很小. 对辐射前后器件的沟道串联电阻和阈值电压变化的分析表明,辐射感生表面态负电荷的产生是造成AlGaN/GaN HEMT器件电特性退化的主要原因之一. 关键词： AlGaN/GaN HEMT器件 γ射线辐射 表面态     

感应耦合等离子体刻蚀p-GaN的表面特性

研究了p-GaN材料经感应耦合等离子体(ICP)刻蚀后的表面特性，并用不同的方法对刻蚀表面进行处理.利用原子力显微镜(AFM)和X射线光电子能谱(XPS)对刻蚀样品进行分析，并在样品表面制作Ni/Au电极，进行欧姆接触特性的测试.实验结果表明了NaOH溶液处理表面对改善材料表面和欧姆接触特性是比较有效的.     

AlGaN/GaN high-electron-mobility transistors with transparent gates by Al-doped ZnO

AlGaN/GaN high-electron-mobility transistors （HEMTs） with Al-doped ZnO （AZO） transparent gate electrodes are fabricated, and Ni/Au/Ni-gated HEMTs are produced in comparison. The AZO-gated HEMTs show good DC characteristics and Schottky rectifying characteristics, and the gate electrodes achieve excellent transparencies. Compared with Ni/Au/Ni-gated HEMTs, AZO-gated HEMTs show a low saturation current, high threshold voltage, high Schottky barrier height, and low gate reverse leakage current. Due to the higher gate resistivity, AZO-gated HEMTs exhibit a current-gain cutoff frequency （fT） of 10 GHz and a power gain cutoff frequency （fmax） of 5 GHz, and lower maximum oscillation frequency than Ni/Au/Ni-gated HEMTs. Moreover, the C-V characteristics are measured and the gate interface characteristics of the AZO-gated devices are investigated by a C-V dual sweep.     

Characteristics and threshold voltage model of GaN-based FinFET with recessed gate

In this work, AlGaN/GaN FinFETs with different fin widths have been successfully fabricated, and the recessed-gate FinFETs are fabricated for comparison. The recessed-gate FinFETs exhibit higher transconductance value and positive shift of threshold voltage. Moreover, with the fin width of the recessed-gate FinFETs increasing, the variations of both threshold voltage and the transconductance increase. Next, transfer characteristics of the recessed-gate FinFETs with different fin widths and recessed-gate depths are simulated by Silvaco software. The relationship between the threshold voltage and the AlGaN layer thickness has been investigated. The simulation results indicate that the slope of threshold voltage variation reduces with the fin width decreasing. Finally, a simplified threshold voltage model for recessed-gate FinFET is established,which agrees with both the experimental results and simulation results.     

Reliability analysis of GaN-based light emitting diodes for solid state illumination

In this paper, we have discussed the effect of electrical stress on GaN light emitting diode （LED）. With the lapse of time, the LED with an applied large current stress can reduce its current more than without such a stress under a large forward-voltage drop. Its scanning electron microscopy （SEM） image shows that there exist several pits on the surface of the p-metal. With an electrical stress applied, the number of pits greatly increases. We also find that the degradation of GaN LED is related to the oxidized Ni/Au ohmic contact to p-GaN. The electrical activation of H-passivated Mg acceptors is described in detail. Annealing is performed in ambient air for 10 min and the differential resistances at a forward-voltage drop of 5 V are taken to evaluate the activation of the Mg acceptors. These results suggest some mechanisms of degradation responsible for these phenomena, which are described in the paper.