太阳模拟器中椭球面聚光镜参数的确定

椭球面聚光镜是太阳模拟器设备的重要组成部分,其能量收集的效率决定着太阳模拟系统的能量传递效率,而太阳模拟器光学系统中的椭球面聚光镜参数一直没有理论上的设计依据,结合氙灯的发光特性并通过对MATLAB 中建立的椭球面聚光镜聚光过程数值分析模型给出了椭球面聚光镜包括第一焦距、最大成像放大倍率、包容角范围及前后开口直径的确定依据,并通过在Lighttools 中建立的4种仿真模型验证了理论分析的正确性。第一焦距由光源光中心高确定,最大成像放大倍率由光学积分器相对孔径及椭球镜包容角范围共同确定,椭球镜包容角范围不小于30°～120°,前开直径口由椭球镜的最大孔径角确定,后开口直径由最小孔径角和光源的径向调节量共同确定。该结论给椭球面聚光镜的设计提供了理论支撑,有利于设计完成高能量收集效率的椭球面聚光镜。     

钙钛矿/硅异质结叠层太阳电池:光学模拟的研究进展

近几年,钙钛矿/硅异质结叠层太阳电池发展迅速,效率已经从13.7％提升到29.1％.由于叠层电池器件的制作工艺复杂,而叠层太阳电池中的光学损失对转换效率的影响很大,所以通过光学模拟进而获得高效电池至关重要.本文首先从商业软件和自建模型两方面概述了光学模拟的方法,接着从反射损失和寄生吸收两方面针对光学模拟研究进展进行了总...     

基于改进型阿特伍德机的重力加速度测量

阿特伍德机是用于测量加速度和验证运动定律的力学实验装置.本文通过增加滑轮组提高系统在实验中的稳定性,增加运动控制装置消除在改变小质量时的初速度的不良影响,通过等加速度方程对加速度求解的,并通过对实验过程的考虑以及对数据的处理方法的选择,同时我们对空气阻力以及滑轮转动惯量计算的修正方法,通过PASCO测量系统测得到精确的...     

The research on suspended ZnO nanowire field-effect transistor

This paper reports that a novel type of suspended ZnO nanowire field-effect transistors (FETs) were successfully fabricated using a photolithography process, and their electrical properties were characterized by I--V measurements. Single-crystalline ZnO nanowires were synthesized by a hydrothermal method, they were used as a suspended ZnO nanowire channel of back-gate field-effect transistors (FET). The fabricated suspended nanowire FETs showed a p-channel depletion mode, exhibited high on--off current ratio of ～10⁵. When V_DS=2.5 V, the peak transconductances of the suspended FETs were 0.396 μS, the oxide capacitance was found to be 1.547 fF, the pinch-off voltage V_TH was about 0.6 V, the electron mobility was on average 50.17 cm²/Vs. The resistivity of the ZnO nanowire channel was estimated to be 0.96× 10²Ω cm at V_GS = 0 V. These characteristics revealed that the suspended nanowire FET fabricated by the photolithography process had excellent performance. Better contacts between the ZnO nanowire and metal electrodes could be improved through annealing and metal deposition using a focused ion beam.     

Mn掺杂ZnO纳米棒阵列的制备及其磁学性质研究

在95 ℃条件下通过水热方法制备出垂直于ITO基底高密度均匀生长的Mn掺杂ZnO（ZnO：Mn）纳米棒阵列. 纳米棒的直径约为100纳米,长约1微米,且沿［001］方向生长. XRD和XPS结果证实了Mn以替位方式掺杂到纳米棒中,并且掺杂浓度与反应物中的Mn离子浓度似呈正比关系. 所制备的ZnO：Mn纳米棒在室温均有铁磁性,其饱和磁化强度随反应物中Mn离子浓度的提高,饱和磁化强度呈现出先增大,5at.%时达到最大值,0.11 emu/g,然后减小. 铁磁性来源于取代Zn离子的Mn离子之间的铁磁交换相互作用.     

高频单线圈双调谐NMR单晶探头的研制

本文报道了一种测角单晶NMR探头。该探头采用单线圃双调谐电路,工作频率在90MHz-110 MHz连续可调,可进行交叉极化大功率去耦实验。文中提出了一种简单而有效的测角装置,可使单晶绕三个互相垂直轴转动实现单晶的NMR测量。作为典型的应用例子,本文利用该探头实现了单晶DGO(2NH₂CH₂COOH·H₂C₂O₄)屏蔽张量的测量。     

Device research on GaAs-based InAlAs/InGaAs metamorphic high electron mobility transistors grown by metal organic chemical vapour deposition

This paper applies a novel quad-layer resist and e-beam lithography technique to fabricate a GaAs-based InAlAs/InGaAs metamorphic high electron mobility transistor (HEMT) grown by metal organic chemical vapour deposition (MOCVD). The gate length of the metamorphic HEMT was 150~nm, the maximum current density was 330~mA/mm, the maximum transconductance was 470~mS/mm, the threshold voltage was -0.6~V, and the maximum current gain cut-off frequency and maximum oscillation frequency were 102~GHz and 450~GHz, respectively. This is the first report on tri-termination devices whose frequency value is above 400~GHz in China. The excellent frequency performances promise the possibility of metamorphic HEMTs grown by MOCVD for millimetre-wave applications, and more outstanding device performances would be obtained after optimizing the material structure, the elaborate T-gate and other device processes further.     

失谐整体叶盘多模态振动抑制的吸振器阵列方法

整体叶盘是新一代高性能航空发动机的关键部件,具有结构紧凑、重量轻和推重比高等优点,但也存在结构阻尼低、模态密度高和随机失谐问题,导致其通过共振区域时振幅大,显著影响整体叶盘结构的可靠性和疲劳寿命.为有效抑制失谐整体叶盘的多模态振动,提出一种由一系列吸振器环状布置而成的吸振器阵列减振方法,通过设置多组匹配不同模态的吸振器,实现对多模态共振峰值的抑制.为揭示吸振器阵列方法的多模态减振机理,采用具有代表性的集中参数模型构建整体叶盘-吸振器阵列系统的动力学分析模型,结合解析形式的功率流分析方法,分析吸振器质量、频率调谐精度、阻尼水平以及吸振器个数等关键参数对吸振器阵列减振性能的影响.搭建了吸振器阵列方法验证实验台,并通过实验验证了吸振器阵列方法的效果.分析结果表明:吸振器阵列方法能够有效控制叶片主导与叶片-轮盘耦合型模态,能够以较小的质量实现对谐调与失谐整体叶盘多模态共振的高效抑制,减振性能的鲁棒性较好.     

Nanoforest-like CdS/TiO_2 heterostructure composites:Synthesis and photoelectrochemical application

In this study, TiO_2 nanoforest films consisting of nanotubes have been synthesized by a simple hydrothermal method and a subsequent sintering technique. The hydrothermal reaction time is important for the controlling of the nanotube diameter and the specific surface area of holistic TiO_2 films. When the hydrothermal process reaction time is up to 8 hours,the diameter of the nanotube is about 10 nm, and the specific surface area of TiO_2 nanoforest films reaches the maximum.CdS nanoparticles are synthesized on TiO_2 nanoforest films by the successive ionic layer adsorption and reaction(SILAR)technique. The transmission electron microscope(TEM) and energy dispersive x-ray spectroscopy(EDX) mapping results verify that TiO_2/CdS heterostructures are realized. A significant red-shift of the absorption edge from 380 nm to 540 nm can be observed after the pure TiO_2 film is sensitized by CdS nanoparticles. Under irradiation of light, the current density of the optimal TiO_2/CdS photoanode is 2.30 mA·cm-2 at 0 V relative to the saturated calomel electrode(SCE), which is 6 times stronger than that of the pure TiO_2 photoanode. This study suggests that the TiO_2 nanoforest consisting of interlinked pony-size nanotubes is a promising nanostructure for photoelectrochemical.     

一种基于模态域波束形成的水平阵被动目标深度估计

水面水下目标分辨与识别一直是被动声呐探测领域的难题.利用一种水平阵模态域波束形成算法获得己知方位目标声源的各阶模态强度,将其与不同深度的各阶参考模态强度进行匹配,最终实现了对声源的深度估计.仿真结果表明,该算法可以在信噪比为-10 dB的情况下,用300Hz带宽的信号样本,实现对声源深度的有效估计.系统分析了不同参数和不同波导条件对该方法目标深度估计性能的影响.其中,阵元数越多,模态样本数越多,计算频段越宽,方位估计精度越高,有效阵长越长,深度估计的性能越好.阵元间距和波导深度的变化不会影响该方法的深度估计性能,并且该方法的深度估计性能在声速剖面、海底参数等波导条件存在扰动时具有鲁棒性.