Theoretical calculation and experiment of microwave electromagnetic property of Ni(C) nanocapsules

With the combination of the dielectric loss of the carbon layer with the magnetic loss of the ferromagnetic metal core,carbon-coated nickel Ni(C) nanoparticles are expected to be the promising microwave absorbers. Microwave electromagnetic parameters and reflection loss in a frequency range of 2 GHz–18 GHz for paraffin-Ni(C) composites are investigated.The values of relative complex permittivity and permeability, the dielectric and magnetic loss tangent of paraffin-Ni(C) composites are measured, respectively, when the weight ratios of Ni(C) nanoparticles are equal to 10 wt%, 40 wt%, 50 wt%,70 wt%, and 80 wt% in paraffin-Ni(C) composites. The results reveal that Ni(C) nanoparticles exhibit a peak of magnetic loss at about 13 GHz, suggesting that magnetic loss and a natural resonance could be found at that frequency. Based on the measured complex permittivity and permeability, the reflection losses of paraffin-Ni(C) composites with different weight ratios of Ni(C) nanoparticles and coating thickness values are simulated according to the transmission line theory. An excellent microwave absorption is obtained. To be proved by the experimental results, the reflection loss of composite with a coating thickness of 2 mm is measured by the Arch method. The results indicate that the maximum reflection loss reaches-26.73 d B at 12.7 GHz, and below-10 d B, the bandwidth is about 4 GHz. The fact that the measured absorption position is consistent with the calculated results suggests that a good electromagnetic match and a strong microwave absorption can be established in Ni(C) nanoparticles. The excellent Ni(C) microwave absorber is prepared by choosing an optimum layer number and the weight ratio of Ni(C) nanoparticles in paraffin-Ni(C) composites.     

Nonlinear compression of picosecond chirped pulse from thin-disk amplifier system through a gas-filled hollow-core fiber

We theoretically study the nonlinear compression of a 20-m J, 1030-nm picosecond chirped pulse from the thin-disk amplifier in a krypton gas-filled hollow-core fiber. The chirp from the thin-disk amplifier system has little influence on the initial pulse, however, it shows an effect on the nonlinear compression in hollow-core fiber. We use a large diameter hollow waveguide to restrict undesirable nonlinear effects such as ionization; on the other hand, we employ suitable gas pressure and fiber length to promise enough spectral broadening; with 600-μm, 6-bar(1 bar = 105Pa), 1.8-m hollow fiber,we obtain 31.5-fs pulse. Moreover, we calculate and discuss the optimal fiber lengths and gas pressures with different initial durations induced by different grating compression angles for reaching a given bandwidth. These results are meaningful for a compression scheme from picoseconds to femtoseconds.     

Three-dimensional detonation cellular structures in rectangular ducts using an improved CESE scheme

The three-dimensional premixed H_2-O_2 detonation propagation in rectangular ducts is simulated using an in-house parallel detonation code based on the second-order space-time conservation element and solution element(CE/SE) scheme.The simulation reproduces three typical cellular structures by setting appropriate cross-sectional size and initial perturbation in square tubes.As the cross-sectional size decreases,critical cellular structures transforming the rectangular or diagonal mode into the spinning mode are obtained and discussed in the perspective of phase variation as well as decreasing of triple point lines.Furthermore,multiple cellular structures are observed through examples with typical aspect ratios.Utilizing the visualization of detailed three-dimensional structures,their formation mechanism is further analyzed.     

高效液相色谱快速测定草本植物饮料中28种外源性药物和内源性成分

建立了高效液相色谱快速测定草本植物饮料中28种外源性药物和内源性成分的分析方法。样品经甲醇-水（70：30,v/v）超声提取后,使用Thermo Accucore C18色谱柱（100 mm×4.6 mm,2.6 μm）,以甲醇、乙腈和20 mmol/L乙酸铵溶液（pH 4.2）为流动相进行梯度洗脱,流速为1.2 mL/min,柱温为35℃,采用二极管阵列检测器,检测波长为254和220 nm,外标法定量。结果表明,28种成分在1~100 mg/L范围内线性关系良好,相关系数（r）均不小于0.999。液体样品和固体样品的检出限（LODs）分别为1~10和20~200 mg/kg。28种成分在液体和固体样品中的加标回收率分别为88.8%~118.6%和92.7%~112.3%,相对标准偏差（RSDs）分别为0.1%~6.7%和0.1%~6.4%。按上述方法检测草本植物饮料456批,检出阳性样品55批次,检出率为12.1%。该法简便快速、准确可靠,适用于草本植物饮料中28种成分的测定。     

可调谐锁模脉冲环形腔掺铒光纤激光器

报道了一种结构简单、波长稳定可调的被动锁模环形腔掺铒光纤激光器.利用非线性偏振旋转效应作为等效可饱和吸收体实现自起振被动锁模,通过使用光纤偏振控制器和偏振相关光隔离器作为波长调谐器件,在输出端使用输出耦合器为工作波长在1550±50 nm的宽带耦合器,实现了光纤激光器的输出锁模脉冲激光中心波长较宽范围可调谐.实验上获得了低阈值自起振,重复频率为10.23 MHz,中心波长在1548.64～1600.24 nm内连续可调,边模抑制比大于44 dB的超短脉冲输出.     

二元室温金属流体热导率的理论计算与实验研究

室温金属流体在芯片散热领域中正日益显示重要价值,但相关材料的热物性比较缺乏.本文基于Faber-Ziman理论和Wiedemann-Franz-Lorenz定律,采用Ashcroft-Langrethp硬球模型偏结构因子以及空核心模型赝势计算了液态二元镓铟及钠钾合金的热导率.结果表明:相比于钠钾合金的热导率随原子组分浓度呈抛物线变化,镓铟合金的热导率与原子组分浓度呈单调变化关系,同时镓铟合金的热导率随着温度升高而升高.作为对比,本文同时也对镓铟合金的热导率进行了实验测定.结合所获数据及钠钾合金文献数据对比,表明计算结果与实验值符合得较好.本文工作为进一步研究二元合金热导率打下了基础.     

Optimization control of modulation-instability gain in photonic crystal fibres with two-zero dispersion wavelengths

We design three kinds of photonic crystal fibres (PCF) with two zero-dispersion wavelengths (ZDWs) using the improved full vector index method (FVIM) and finite-difference frequency domain (FDFD) techniques. Based on these designed fibres, the effect of fibre structure, pump power and wavelength on the modulation instability (MI) gain in the anomalous dispersion region close to the second ZDW of the PCFs is comprehensively analysed in this paper. The analytical results show that an optimal MI gain can be obtained when the optimal pump wavelength (1530~nm) is slightly shorter than the second ZDW (1538~nm) and the optimal pump power is 250~W. Importantly, the total MI gain bandwidth has been increased to 260~nm for the first time, so far as we know, for an optimally-designed fibre with Λ = 1.4~nm and d/Λ = 0.676, and the gain profile became much smoother. The optimal pump wavelength relies on the second ZDW of the PCF whereas the optimal pump power depends on the corporate operation of the optimal fibre structure and optimal pump wavelength, which is important in designing the most appropriate PCF to attain higher broadband and gain amplification.     

An Ultra-Broadband Spatially Dispersed Regenerative Amplifier Free from Spatial Chirp

An ultra-broadband Ti：sapphire regenerative amplifier based on spatially dispersed amplification is demonstrated experimentally. Departing from previous reports, a new design of the cavity gets the amplified pulse free from spatial chirp. Utilizing this new regenerative amplifier, chirped pulses with bandwidth （FWHM） of about 80 nm are obtained, and the bandwidth is limited only by that of the incident seed pulses.     

Self-Starting Passively Mode-Locked Er^3＋/Yb^3＋ Codoped Phosphate Glass All-Fibre Ring Laser

A self-starting, passively mode-locked all-fibre ring laser based on the homemade Er^3＋/Yb^3＋ codoped phosphate glass fibre is reported. Dual-pump sources were used to achieve the mode-locked operation in the experiment. The fundamental mode-locked pulse repetition rate is 10.67MHz. The pulse duration, assumed as the fit of hyperbolic secant pulse shape, is 5.82ps. We also observe the multi-pulse output of the fibre laser.     

络合剂对制备TiO2薄膜的影响以及超亲水特征

采用溶胶-凝胶技术,以钛酸丁酯(Ti(OC4H9)4)为前驱体,加入乙酰丙酮(acac)和二乙醇胺(DEA)作为络合剂,在玻璃基片上制备了TiO2多孔薄膜。 通过SEM观察了多孔薄膜的表面形貌,探讨了样品在溶胶-凝胶及烧结过程中孔状结构的形成过程,并测量了薄膜的表面润湿性。 实验结果表明,单独以acac或DEA作为络合剂制备的涂膜十分致密和平坦,水接触角分别为20°和23°。 但以二者复合使用,由于低缩聚物迅速形成使溶液体系产生二相分离,随着二乙醇胺加入量的增加,两相完全分离所需的时间逐渐减少,在煅烧过程中溶剂挥发时,气体放出就出现了孔状结构,从而使表面具有更大的平均粗糙度。 多孔TiO2的涂膜在避光的条件下水接触角达6.5°。