Investigations of reactions involved in electrothermal atomic absorption procedures: Part 9. An atomization system with controlled atmosphere and temperature for the determination of volatile elements in complex matrices

A controlled temperature controlled atmosphere atomization system is described. The sample is placed on a tungsten wire provided with temperature-controlled heating. After thermal pretreatment of the sample the wire is inserted into a hot quartz tube and rapid vaporization is accomplished by separate electrothermal heating. The pyrolysis products formed are mixed with a gas buffer and are passed through two equilibrium zones. The residence time of the analyte in the system is of the order of seconds so that the probability of attaining a state close to equilibrium is high for high temperatures. A third zone is placed perpendicularly to the others and constitutes the atomic absorption measuring cell. The usefulness of the system is illustrated for the determination of lead, bismuth, cadmium and zinc. The system provides unique possibilities in controlling interference effects in complex matrices. Examples are given for lead in concentrated chloride and sulphate solutions. Good agreement between the experimental results and high-temperature equilibrium calculations was obtained for a large variation in the composition of the gas phase.     

Kupferanalyse

Ohne Zusammenfassung     

A mass spectrometric study on meloxicam metabolism in horses and the fungus Cunninghamella elegans,and the relevance of this microbial system as a model of drug metabolism in the horse

This paper describes a study where the metabolism of the non‐steroidal anti‐inflammatory drug meloxicam was investigated in six horses and in the filamentous fungus Cunninghamella elegans. The metabolites identified were compared between the species, and then the fungus was used to produce larger amounts of the metabolites for future use as reference material. C. elegans proved to be a good model of phase I meloxicam metabolism in horses since all four metabolites found were the same in both species. Apart from the two main metabolites, 5′‐hydroxymethylmeloxicam and 5′‐carboxymeloxicam, a second isomer of hydroxymeloxicam and dihydroxylated meloxicam were detected for the first time in horse urine and the microbial incubations. Phase II metabolites were not discovered in the C. elegans samples but hydroxymeloxicam glucuronide was detected intact in horse urine for the first time in this study. Urine from six horses was further analyzed in a semi‐quantitative sense and 5′‐hydroxymethylmeloxicam gave peaks with much higher intensity compared to the parent drug and the other metabolites, and was detected for at least 14 days after the last given dose in some of the horses. From the results presented in this article, we suggest that analytical methods developed for the detection of meloxicam in horse urine after prohibited use should focus on the 5′‐hydroxymethyl metabolite and that C. elegans can be used to produce large amounts of this metabolite for potential future use as a reference compound. Copyright © 2009 John Wiley & Sons, Ltd.     

Restoration of selection rules in nonadiabatic resonant inelastic x-ray scattering

Recently a new effect in the Raman scattering of x-ray radiation has been predicted theoretically and discovered in experiments, the effect of restoration of the selection rules for the scattering tensor under strong electron-vibrational interaction. We propose a fairly simple model for describing this effect, a model that allows for an exact solution and takes into account the real vibrational structure of the molecule and electron-vibrational interaction. Zh. éksp. Teor. Fiz. 112, 37–49 (July 1997)     

A fast simple hot-wire method of determining the mean velocity vector of complex three-dimensional flows

A fast and simple method of determining the mean velocity vector of complex three-dimensional flow fields is outlined. Straight and slanted single hot-wires are rotated in two perpendicular planes. This method increases the angular resolution, which is of importance in flow situations where one of the velocity components dominates and the other changes rapidly from one point to another. The method was calibrated in a wind tunnel and assessed in the internal flow field at the outlet of a fan in a defroster channel. It is shown that the hot-wire method yields good agreement with corresponding flow visualizations determined using a textile thread, and an integration of the measured mean flow yields a flow rate which agrees within a few percent with corresponding direct measurements on an orifice plate.     

Numerical Investigations of the Steady State Relative Permeability of a Simplified Porous Medium

The purpose of this paper is to investigate, by flow simulations in a uniform pore-space geometry, how the co and countercurrent steady state relative permeabilities depend on the following parameters: phase saturation, wettability, driving force and viscosity ratio. The main results are as follows: (i) with few exceptions, relative permeabilities are convex functions of saturation; (ii) the cocurrent relative permeabilities increase while the countercurrent ones decrease with the driving force; (iii) with one exception, phase 2 relative permeabilities decrease and phase 1 relative permeabilities increase with the viscosity ratio M=₁/₂; (iv) the countercurrent relative permeabilities are always less than the cocurrent ones, the difference being partly due to the opposing effect of the viscous coupling, and partly to different levels of capillary forces; (v) the pore-level saturation distribution, and hence the size of the viscous coupling, can be very different between the cocurrent and the countercurrent cases so that it is in general incorrect to estimate the full mobility tensor from cocurrent and countercurrent steady state experiments, as suggested by Bentsen and Manai (1993).(Now at AS Norske Shell, Norway.) e-mail:     

Well‐Defined Palladium Nanoparticles Supported on Siliceous Mesocellular Foam as Heterogeneous Catalysts for the Oxidation of Water

Herein, we describe the use of Pd nanoparticles immobilized on an amino‐functionalized siliceous mesocellular foam for the catalytic oxidation of H₂O. The Pd nanocatalyst proved to be capable of mediating the four‐electron oxidation of H₂O to O₂, both chemically and photochemically. The Pd nanocatalyst is easy to prepare and shows high chemical stability, low leaching, and recyclability. Together with its promising catalytic activity, these features make the Pd nanocatalyst of potential interest for future sustainable solar‐fuel production.     

Selective extraction of triazine herbicides based on a combination of membrane assisted solvent extraction and molecularly imprinted solid phase extraction

A selective extraction technique based on the combination of membrane assisted solvent extraction and molecularly imprinted solid phase extraction for triazine herbicides in food samples was developed. Simazine, atrazine, prometon, terbumeton, terbuthylazine and prometryn were extracted from aqueous food samples into a hydrophobic polypropylene membrane bag containing 1000μL of toluene as the acceptor phase along with 100mg of MIP particles. In the acceptor phase, the compounds were re-extracted onto MIP particles. The extraction technique was optimised for the type of organic acceptor solvent, amount of molecularly imprinted polymers particles in the organic acceptor phase, extraction time and addition of salt. Toluene as the acceptor phase was found to give higher triazine binding onto MIP particles compared to hexane and cyclohexane. Extraction time of 120min and 100mg of MIP were found to be optimum parameters. Addition of salt increased the extraction efficiency for more polar triazines. The selectivity of the technique was demonstrated by extracting spiked cow pea and corn extracts where clean chromatograms were obtained compared to only membrane assisted solvent extraction or only molecularly imprinted solid phase extraction. The study revealed that this combination may be a simple way of selectively extracting compounds in complex samples.