Direct sample introduction of wines in graphite furnace atomic absorption spectrometry for the simultaneous determination of arsenic, cadmium, copper and lead content

A multi-element graphite furnace atomic absorption spectrometry (GFAAS) method was elaborated for the simultaneous determination of As, Cd, Cu, and Pb in wine samples of various sugar contents using the transversally heated graphite atomizer (THGA) with end-capped tubes and integrated graphite platforms (IGPs). For comparative GFAAS analyses, direct injection (i.e., dispensing the sample onto the IGP) and digestion-based (i.e., adding oxidizing agents, such as HNO(3) and/or H(2)O(2) to the sample solutions) methods were optimized with the application of chemical modifiers. The mixture of 5 microg Pd (applied as nitrate) plus 3 microg Mg(NO(3))(2) chemical modifier was proven to be optimal for the present set of analytes and matrix, it allowing the optimal 600 degrees C pyrolysis and 2200 degrees C atomization temperatures, respectively. The IGP of the THGA was pre-heated at 70 degrees C to prevent the sputtering and/or foaming of sample solutions with a high organic content, dispensed together with the modifier solution, which method also improved the reproducibility of the determinations. With the digestion-based method, the recovery ranged between 87 and 122%, while with the direct injection method it was between 96 and 102% for Cd, Cu, and Pb, whereas a lower, compromise recovery of 45-85% was realized for As. The detection limits (LODs) were found to be 5.0, 0.03, 1.2, and 0.8 microg l(-1) for As, Cd, Cu, and Pb, respectively. The characteristic mass (m(0)) data were 24 pg As, 1.3 pg Cd, 13 pg Cu, and 35 pg Pb. The upper limits of the linear calibration range were 100, 2, 100, and 200 microg l(-1) for As, Cd, Cu, and Pb, respectively. The precisions were not worse than 4.8, 3.1, 3.7, and 2.3% for As, Cd, Cu, and Pb, respectively. For arsenic, a higher amount of the modifier (e.g., 20 microg Pd plus 12 microg Mg(NO(3))(2)) could be recommended to overcome the interference from the presence of sulphate and phosphate in wines. Although this method increased the sensitivity for As (m(0)=20 pg), it also enhanced the background noise, thus only a slight improvement in the LOD of As (3.9 microg l(-1)) was realized. For the 35 red and white wine samples studied, the highest metal contents were observed for Cu ranging from 20 to 640 microg l(-1) (average: 148 microg l(-1)), followed by Pb from 6 to 90 microg l(-1) (average: 32.3 microg l(-1)), and Cd from 0.05 to 16.5 microg l(-1) (average: 1.06 microg l(-1)), whereas the As content was below the LOD. This wide fluctuation in the trace metal content could be associated with the origin of wines from various regions (i.e., different trace metal level and/or quality of soil, and/or anthropogenic impact), and with diverse materials (e.g., additives and containers) involved in the wine production processes. The Cu content of wine samples was significantly correlated with Pb, whereas its weak anti-correlation was found with Cd. Interestingly, the level of Pb was anti-correlated with the year of production of the wines. This is likely due to the gradual decrease in the Pb content of soils of vineyards by time, which certainly causes less Pb-uptake of the grape plant, thus a decrease in the Pb content of wines as well.     

High-efficiency aminocarbonylation by introducing CO to a pressurized continuous flow reactor

Halogenated aryl carboxylic acids were efficiently converted to the corresponding dicarboxylic acid monoamides by a one-step Pd-catalyzed aminocarbonylation in a micro/meso fluidic continuous flow reactor (X-Cube) operated at high pressure and high temperature with CO gas introduction. Reaction parameters (solvent, base, catalyst, pressure, temperature) were rapidly optimized in the reactions, which required less than 2 min. The method gave improved results over comparable batch techniques and is also suited to automated parallel syntheses of compound libraries.     

Non-standard base pairing and stacked structures in methyl xanthine clusters

We present resonant two-photon ionization and IR-UV double resonance spectra of methylated xanthine derivatives including 7-methylxanthine dimer and theobromine dimer seeded in a supersonic jet by laser desorption. For 7-methylxanthine, theophylline and theobromine monomer we assign the lowest energy tautomer based on comparison with IR-UV double resonance spectra and calculated IR frequencies. For the 7-methylxanthine dimer, we observe hydrogen bonding on the N3H position suggesting 3 possible combinations, one that is reverse Watson-Crick type and two that are reverse Hoogsteen type. For the theobromine dimer, we observe a stacked structure. For trimethylxanthine dimers we infer a stacked structure as well.     

Photoelectron spectroscopy and thermochemistry of tert-butylisocyanide-substituted cobalt tricarbonyl nitrosyl

A new organometallic complex, Co(CO)2NOtBuNC, was synthesized and investigated by photoelectron spectroscopy (PES) and threshold photoelectron photoion coincidence (TPEPICO) spectrometry in order to determine its ionization energy as well as the bond energies in the ionic forms. The assignment of the nine peaks in the PES was based on Kohn-Sham molecular orbital energies, and an adiabatic ionization energy of 7.30 +/- 0.05 eV was determined. In the TPEPICO experiment, the following 0 K onsets were determined for the various fragment ions: CoCONOtBuNC+ (8.17 +/- 0.05 eV); CoNOtBuNC+ (9.01 +/- 0.05 eV); and CotBuNC+ (10.42 +/- 0.05 eV). Because the photon source did not extend above 14 eV, we could not observe the bare Co+ ion in the experiment. The heat of formation of the CotBuNC+ ion was estimated by ab initio and DFT calculations of the CoL+ + tBuNC --> CotBuNC+ + L (L = CO, NO, NH3, H2O, PMe3) substitution enthalpies.     

Dissociation dynamics of sequential ionic reactions: heats of formation of tri-, di-, and monoethylphosphine

The sequential ethene (C2H4) loss channels of energy-selected ethylphosphine ions have been studied using threshold photoelectron photoion coincidence (TPEPICO) spectroscopy in which ion time-of-flight (TOF) distributions are recorded as a function of the photon energy. The ion TOF distributions and breakdown diagrams have been modeled in terms of the statistical RRKM theory for unimolecular reactions, providing 0 K dissociation onsets, E0, for the ethene loss channels. Three RRKM curves were used to model the five measurements, since two of the reactions differ only by the internal energy of the parent ion. This series of dissociations provides a detailed check of the calculation of the product energy distribution for sequential reactions. From the determined E0's, the heats of formation of several ethylphosphine neutrals and ions have been determined: Delta(f)H degrees 298K[P(C(2)H(5))3] = -152.7 +/- 2.8 kJ/mol, Delta(f)H degrees 298K[P(C(2)H(5))3+] = 571.6 +/- 4.0 kJ/mol, Delta(f)H degrees 298K[HP(C(2)H(5))2] = -89.6 +/- 2.1 kJ/mol, Delta(f)H degrees 298K[HP(C(2)H(5))2+] = 669.9 +/- 2.5 kJ/mol, Delta(f)H degrees 298K[H(2)PC(2)H(5)] = -36.5 +/- 1.5 kJ/mol, Delta(f)H degrees 298K[H(2)PC(2)H(5)+] = 784.0 +/- 1.9 kJ/mol. These values have been supported by G2 and G3 calculations using isodesmic reactions. Coupled cluster calculations have been used to show that the C2H4 loss channel, which involves a hydrogen transfer step, proceeds without a reverse energy barrier.     

Structure and stereochemistry of novel ecdysteroids from the roots of Serratula wolffii

Three new natural ecdysteroids viz. 22‐dehydro‐20‐deoxy‐ajugasterone C (1), 1‐hydroxy‐22‐deoxy‐20,21‐didehydro‐ecdysone (2) and 22‐deoxy‐20,21‐didehydro‐ecdysone (3) were isolated from the methanol extract of the roots of Serratula wolffii. The structures of compounds 1–3 were established by various spectroscopic techniques, including one‐ and two‐dimensional NMR, circular dichroism and mass spectroscopic methods. Copyright © 2010 John Wiley & Sons, Ltd.     

Lie Derived Lengths of Group Algebras of Groups with Cyclic Derived Subgroup

In this article the Lie derived length and the strong Lie derived length of group algebras are determined in the case when the derived subgroup of the basic group is cyclic of odd order. As a consequence, we have the characterization of the group algebras of minimal strong Lie derived length.     

Glass-fibre reinforced composite materials based on unsaturated polyester resins

The effect of glass-fibre content on the thermal and mechanical properties of cross-linked composites based on unsaturated polyester resins have been investigated by thermogravimetric analysis, differential scanning calorimetry, dynamic mechanical thermal analysis and by measuring the heat distortion temperature (HDT). Two different matrix resins and two different glass mats were used, and the glass-fibre contents varied. Altogether 12 composite systems were tested. The glass- transition temperature of each composite was characteristic to the matrix resin and did not depend on the glass-fibre content, as it was expected. The effect of glass-fibre content on the storage modulus and on HDT has been elucidated. It has been found that up to 12 mass% (6?vol%) glass-fibre content the HDT did not change, above this value it increased with increasing glass-fibre content for each composite, but not at the same extent. This means that matrix-fibre interaction has an important role in the performance of the composites at elevated temperatures. Storage moduli increased with increasing glass-fibre content. The temperatures detected by dynamic mechanical thermal analysis corresponding to the storage modulus of 750?MPa??calculated by Takemori??are above the glass-transition and also increased with higher glass-fibre content in accordance with the real heat-distortion temperature measurements. It may be concluded that the effect of reinforcement on the performance of the composite could be detected more reliably by HDT measurements, since it gives information on the deformation of the composites. Matrix-fibre interaction has an essential role on the performance and on the HDT of the composite materials.     

Stereoselective synthesis of pinane-based β- and γ-amino acids via conjugate addition of lithium amides and nitromethane

Michael addition of dibenzylamine to (?)- and (+)-tert-butyl myrtenate, (?)-2 and (+)-2, derived from (?)- and (+)-myrtenal, furnished monoterpene-based β-amino acid derivatives in highly stereospecific reactions. The resultant amino esters (?)-3 and (+)-3 were transformed to unsubstituted, mono- and disubstituted and Fmoc-protected amino acids (?)-6-11 and (+)-6-11, which are promising building blocks for the synthesis of β-peptides and 1,3-heterocycles. The microwave-assisted conjugate addition of nitromethane to α,β-unsaturated esters (?)-12 and (+)-12 likewise resulted in nitro esters (?)-13 and (+)-13 in highly stereospecific reactions. Compounds (?)-13 and (+)-13 were successfully transformed into γ-amino acids (?)-16 and (+)-16 in two steps.