Photoluminescence properties of the composite of porous alumina and poly (2,5-dibutoxy-1,4 phenylenevinylene)

The spin coating method was used to assemble polymer (Poly (2,5-dibutoxy-1,4-phenylenevinylene)) (DBO-PPV) into the pores of porous alumina which was prepared by anodization. Four peaks in the photoluminescence (PL) spectra of the composite, with contributions from the DBO-PPV and porous alumina, were found. It was also found that the light emitting from the porous alumina could excite the photoluminescence of DBO-PPV. The nanometer effect of the porous alumina can lead to a blue shift of 90 nm of the PL peaks of DBO-PPV.     

La掺杂浓度对PLZT薄膜红外光学性质的影响

采用溶胶-凝胶法在Pt/Ti/SiO2/Si衬底上制备了不同La掺杂浓度PLZT(x/40/60)薄膜- x射线衍射分析表明制备的PLZT(x/40/60)薄膜是具有单一钙钛矿结构的多晶薄膜- 通过红外椭圆偏振光谱仪测量了波长为2-5—12-6μm范围内PLZT薄膜的椭偏光谱，采用经典色 散模型拟合获得PLZT薄膜的红外光学常数，同时也拟合获得PLZT薄膜的厚度- 随着La掺杂浓 度的增大，折射率逐渐减小- 而消光系数除PLZT(4/40/60)薄膜外，呈现逐渐增大的趋势- 分析表明这些差异主要与PLZ 关键词： PLZT薄膜 红外光学性质 红外椭圆偏振光谱     

2,2’—二硫代双(4,6—二叔丁基苯酚)的晶体和分子结构

一种塑解剂经高压液体色谱分离制备出主要成份2,2′—二硫代双(4,6二叔丁基苯酚)。由质谱分析得到分子量为474化学式为C_(28)H_(2)O_2S_2、晶体呈现孪生。基体单晶属三斜晶系,空间群为(?)PI(NO.2),晶体结构用直接法解出,=0.07。研究结果表明该分子是二硫代酚类化合物。在EI场中,S—S键断裂是主要断裂过程。晶体中,分子的一个环上的羟基是无序分布的。羟基与最邻近的硫原子形成氢键。     

Approximation of signals from local averages

This work is concerned with approximation of a signal from local averages. It improves a result of Butzer and Lei [P.L. Butzer, J. Lei, Approximation of signals using measured sampled values and error analysis, Commun. Appl. Anal. 4 (2000) 245–255].     

Fabrication of magnetic composite nanofibers of poly(ε-caprolactone) with FePt nanoparticles by coaxial electrospinning

In this article, composite nanofibers of poly(ε-caprolactone) (PCL) with iron–platinum (FePt) nanoparticles were successfully fabricated via coaxial electrospinning. The structure and morphology of FePt/PCL composite nanofibers were observed using transmission electron microscope and scanning electron microscope, respectively. The magnetic behavior of FePt/PCL composite nanofibers was investigated by alternating gradient magnetometer at room temperature.     

Nanoparticle composites: FePt with wide-band-gap semiconductor

We present a simple way to synthesize FePt and ZnO (wide-band-gap semiconductor) nanoparticle composites. The FePt nanoparticles were fabricated using the method reported by Sun et al. By controlling the heating rate, 3 nm FePt nanoparticles were synthesized. Well-dispersed FePt and ZnO nanoparticle composites were prepared by further adding zinc acetate and oleyl amine into the 3 nm FePt nanoparticle dispersion. By controlling the molar ratio of the FePt and zinc acetate, FePt and ZnO nanoparticle composites with different FePt particle fractions were obtained. The intensity of photo luminescence spectra of the nanoparticle composites increases very much with decreasing FePt particle fraction, whereas the peak position shifts a little. After annealing at 550 °C for half an hour, the nanoparticle composites become magnetically hard or semi-hard with coercivity much dependent on the FePt particle volume fraction. The coercivity of the composites increases with annealing temperature. The composites hold the promise of applications in new generation recording and/or optical devices.     

Evaluation of gap length fluctuation with harmonic analysis method

Gap length (GL) of reading head is one of the most critical parameters for high-density magnetic recording systems. A novel method is proposed for quantitative evaluation of the GL fluctuation among a batch of magneto-resistive/giant magneto-resistive heads with same structure design. The method works at head-gimbal assembly level and the evaluation can be done with any read/write analysis equipment. The testing process is based on harmonic analysis of the readback signal. The testing system consists of a selected reference head and sample heads for evaluation. A GL variation function is introduced for the evaluation of GL deviation between the reference head and sample head. This method proved to be easy for implementation and results suggest that variation of GL is considerable and has obvious effect on recording performance in high recording density systems.     

一类非定常对流占优扩散问题差分-流线扩散法的后处理

讨论了一类非定常对流占优扩散方程的差分-流线扩散格式(FDSD),利用插值后处理技术,提高了特殊网格下该FDSD格式在双线性元空间的精度,从而按L∞(L2(Ω) 模达到最优．     

LD端抽运平直腔Nd:YVO4固态激光器的输出功率特性研究

对LD端抽运平直腔Nd:YVO₄固态激光器输出功率特性受激光器内在诸因素(热透镜效应、腔长、激活孔径等)的制约关系进行了研究.并用传播圆-变换圆图解分析方法给出了合理的解释，同时，对进一步提高其输出功率特性指出了方向. 关键词： 固体激光器 热透镜 变换圆 平直腔     

利用富铈混合稀土改善工业纯铝中富铁相形貌的研究

利用金相分析方法研究了富Ce混合稀土变质对含不同Fe量的工业纯铝的组织和其中富铁相形貌的影响。试验结果表明,随着Fe含量的增加,富铁相由弥散细小的颗粒状向短棒状、长针状转变;富Ce混合稀土变质使铝中的富铁相由长针状变为弥散细小的颗粒状。随着稀土含量的增加,-αAl晶粒逐渐细化,富铁相尺寸及数量逐渐减小。添加0.5%稀土时,-αAl晶粒细化效果最佳,而且富铁相呈细小颗粒状均匀分布在-αAl基体的晶界处。本文还对稀土改善富铁相的机制进行了分析。