Preparation of a set of selectively protected disaccharides for modular synthesis of heparan sulfate fragments: toward the synthesis of several <Emphasis Type="Italic">O</Emphasis>-sulfonated [β-D-GlcUA-(1→4)-β-D-GlcNAc]OPr types

A concise method for a stereocontrolled synthesis of a set of selectively protected disaccharides is reported. Coupling of the donor 11 onto acceptors 23 and 24, promoted by trimethylsilyl triflate-N-iodosuccinimide (TMSOTf-NIS), generated the disaccharides 25 and 26. Under typical conditions, condensation of the fully protected donor 12 onto acceptors 23 and 24 produced the disaccharides 27 and 28. The building blocks 25–28 were prepared in moderate yields having exclusive β-stereoselectivity. A unique pattern of protecting groups distinguished clearly between positions to be sulfated and functional groups remaining as free hydroxyl groups. Acetyl and/or levulinoyl esters temporarily protected the positions to be sulfated, while benzyl ethers were used for permanent protection. The anomeric positions were protected as allyl ethers, whereas the 4′-positions were masked as p-methoxybenzyl (PMB) ethers. The orthogonality of the PMB and allyl groups can then be used for further elongation of the chain by recurrent deprotection and activation steps. The hydroxyl group, OH-6, of glucosamine moieties was protected as a TBDPS ether to avoid oxidation. A five-step deprotection/sulfonation sequence was applied to the disaccharide 27 to generate the corresponding sulfated [β-D-GlcUA-2-OSO₃Na-(1→4)-β-D-Glc pNAc]-(1→O-Pro) 34.     

Optimization of the design and operation of FAIMS analyzers

Field asymmetric waveform ion mobility spectrometry (FAIMS) holds significant promise for post-ionization separations in conjunction with mass-spectrometric analyses. However, a limited understanding of fundamentals of FAIMS analyzers has made their design and operation largely an empirical exercise. Recently, we developed an a priori simulation of FAIMS that accounts for both ion diffusion (including anisotropic components) and Coulomb repulsion, and validated it by extensive comparisons with FAIMS/MS data. Here it is corroborated further by FAIMS-only measurements, and applied to explore how key instrumental parameters (analytical gap width and length, waveform frequency and profile, the identity and flow speed of buffer gas) affect FAIMS response. We find that the trade-off between resolution and sensitivity can be managed by varying gap width, RF frequency, and (in certain cases) buffer gas, with equivalent outcome. In particular, the resolving power can be approximately doubled compared to "typical" conditions. Throughput may be increased by either accelerating the gas flow (preferable) or shortening the device, but below certain minimum residence times performance deteriorates. Bisinusoidal and clipped-sinusoidal waveforms have comparable merit, but switching to rectangular waveforms would improve resolution and/or sensitivity. For any waveform profile, the ratio of two between voltages in high and low portions of the cycle produces the best performance.     

Structure-direct assembly of hexagonal pencil-like ZnO group whiskers

Hexagonal ZnO group whiskers synthesized from Zn(NH₃)₄²⁺ precursor at 145°C in a structure-directing template solvent (2.5% v/v alcohol) show strong photoluminescence at 409 and 420 nm. FE-SEM and TEM observation reveals that the ZnO group whiskers consist of uniform pencil-like whiskers with the diameter of around 1.5 μm and the length of up to 6 μm.     

Characterization and electrochemical investigation of boron-doped mesocarbon microbead anode materials for lithium ion batteries

The structure and anodic performance of boron-doped and undoped mesocarbon microbeads (MCMBs) have been comparatively studied and the results obtained by XPS, XRD, SEM, Raman spectroscopy and electrochemical measurements are discussed. It is found that boron doping introduces a depressed d ₀₀₂ spacing and the larger amount of "unorganized carbon", which induces vacancy formation in the graphite planes and leads to a quite different morphology from that of the undoped material. Electrochemical charge/discharge cycle tests indicated that after boron doping the lithium intercalation was carried through at a somewhat higher potential, being attended by greater irreversible capacity loss. Electronic Publication     

SDS胶束对孔雀绿褪色反应的影响

研究了十二烷基硫酸钠（SDS）表而活性剂胶束和预胶束对孔雀绿褪色可逆反应的影响，建立了1－1型可逆反应的胶束催化模型和预胶束催化模型，获得了胶束相中正逆反应的速率常数和预胶束的平均聚集数．结果表明，SDS胶束和预胶束对正反应有禁阻作用，而对逆反应有催化作用．     

SAPO—11分子筛用i—Pr2NH导向合成及其酸性研究

以ＡｌＰＯ４、Ｈ３ＰＯ４、ＳｉＯ２等为原料采用单一模板剂ｉＰｒ２ＮＨ合成了ＳＡＰＯ１１分子筛，利用Ａｖｒａｍｉ方程等对合成过程进行了定量描述。还利用红外（ＩＲ）、程序升温脱附（ＴＰＤ）、线性丁烯骨架异构反应催化活性测试等手段表征了ＳＡＰＯ１１的酸性。结果表明，合成过程随温度有明显变化，晶化阶段的活化能远高于核化阶段的值。可用Ａｖｒａｍｉ方程的参数来表征合成过程的难易程度。分子筛中存在Ｂ酸和Ｌ酸位，主要在中等强度范围，从而对线性丁烯骨架异构反应有较好的催化活性。提高分子筛中硅含量可明显增大酸位浓度，酸强度也有轻度增强。     

Reactions in a Mixture of CH4 and CO2 under the Aciton of Microwave Discharge at Atmospheric Pressure

Reactions between CH4 and CO2 under the action of continuous microwave discharge at atmospheric pressure were studied in a special homemade reactor,The main products were CO and H2,while acetylene and ethylene were also found in the products.Experimental results show that conversions of CH4 and CO2 could be higher than 90% without the presence of any catalyst,Effects of CO2/CH4 molar ratio and total flow rate of the feed gas on the reaction were also investigated.     

A light-driven rotaxane molecular shuttle with dual fluorescence addresses

[reaction: see text] A molecular shuttle containing an alpha-CD macrocycle, an azobenzene unit, and two different fluorescent naphthalimide units was synthesized. The cis-trans photoisomerization of the azobenzene unit resulted in the motion of the CD macrocycle on the track. Because of the easy regulation and full reversibility of the fluorescence change of the two stopper units, the molecular shuttle could be used as a molecular storage medium or switch with all-optical inputs and outputs.     

Infrared-optical properties of vapour-deposited metal films

Spectroscopic infrared ellipsometry was applied to determine the optical constants of thin metal layers deposited on dielectric substrates such as glass or CaF(2). The layers were produced by evaporating gold or silver in a vacuum, and the coverage, that is the deposited mass per area, was chosen in the range 80-1200 mg m(-2) for gold, which refers to thicknesses in the lower nanometer range; in the case of the specifically lighter silver, about half the coverage was applied. At low coverage a metal island structure is obtained, which gives rise to surface-enhanced infrared absorption (SEIRA). Depending on the coverage, the deposited films exhibit either dielectric or metallic optical properties. Atomic force microscopy and conductivity measurements complement the spectroscopic observation.     

过渡金属配合物阴离子嵌人聚吡咯膜电极的表征

采用电化学聚合方法在水溶液中制备出Fe(CN)_6~(4-)嵌入的聚吡咯膜修饰电极, 电极具有稳定的Fe(CN)_6~(4-)/Fe(CN)_6~(3-)电化学响应, 其氧化、还原电位与电解质溶液中H~+浓度有关。借助XPS、IR和ESR方法对聚合物膜结构进行表征, 探讨嵌入物种Fe(CN)_6~(n-)和聚吡咯之间的相互作用, 提出一种可能的轨道相互作用模式。