Intense Upconversion Luminescence of Yb<Superscript>3+</Superscript>-Er<Superscript>3+</Superscript> in Li<Subscript>2</Subscript>O Content Tungsten-tellurite Glasses

The Er³⁺ -Yb³⁺ codoped in Li₂O content tungsten -tellurite (TWL) transparent glasses are synthesized and measured the absorption, Raman and upconversion luminescence (UPL) spectra. At room temperature intense green emission peak at 560 nm ( ⁴S_3/2→⁴I_15/2) and red emission peak at 670 nm ( ⁴F_9/2→⁴I_15/2) of Er³⁺ observed even at minimum 86 mW pumping power of infrared 980 nm excitation. For structure of the TWL glass, Raman spectrum result revealed that an important role of WO₃ in the formation of glass network linkage with Li₂O. Under this influence estimated lifetime of the ⁴I_11/2 of Er³⁺ was 1.89 μs and due to lower phonon energy of the glass produce strong upconversion signal. The effect of Er₂O₃ concentration on emission intensity result indicated that green emission intensity initially increase in compare to red emission. Under the 980 nm pump power variation measured the relatively increases the red emission to the green emission intensity and analyze the possible upconversion mechanism and process.     

Formation of Gallium-induced nanostructures on single crystal HOPG surface

The room temperature growth of gallium atoms on the highly oriented pyrolytic graphite (HOPG) surface has been performed. The gallium atoms were deposited by thermal evaporation method in an ultra high vacuum system at a base pressure 5 × 10⁻¹⁰ torr. The X-ray photo electron spectroscopy (XPS) studies had been performed to confirm the presence of gallium atoms on HOPG surface. Scanning tunneling spectroscopy (STM) technique was employed to study the surface morphology of the clean HOPG surface and gallium covered HOPG surfaces which recognize the formation of gallium induced nanostructures. The deconvoluted XPS core level spectra of C (1s) and Ga (3d) demonstrate the possible interaction between substrate and the adsorbate atoms. The STM analysis revealed that the gallium deposition on HOPG led to significant change in the surface morphology. It was observed that the Ga atoms adsorbed as layer structure on HOPG surface for low coverage while quasi one-dimensional chain like nanostructure (1 ± 0.2 nm) has been formed for higher Ga coverage. The nanostructured surfaces induced by Ga deposition are found to be stable and could be used as a template for the growth of metallic nanostructures.     

医用生物材料的低温保存研究

生物材料的低温保存一般都要经历降温过程、低温储存过程及复温过程,其中降温过程中对生物细胞的影响最大.每一种生物细胞都有自己合适的降温速率,如能满足其这种降温速率,细胞所受到的低温损伤最小,则生物细胞的复活率最高.文中介绍程序控制变速降温装置的主要结构及几种典型生物体的降温过程.最后,对器官的低温保存进行分析讨论.     

Synthesis of Ethynylated Phenothiazine Based Fluorescent Boronic Acid Probes

Ethynylated phenothiazine based fluorescent boronic acid probes were prepared. Sonogashira coupling reaction was used to introduce substituted phenylethynylene fragments to the phenothiazine fluorophore to extend the π-conjugation and to enhance the emission property. The photophysical properties and the binding properties of these probes with hydroxyl acids were investigated. We found that the probes with significant ICT effect show emissions which are sensitive to solvent polarity. The phenothiazine moiety is proved to be electron-donating. We found the substitution profile imparts significant effect on the photophysical properties of the probes. For example, one of the probes shows d-PeT effect, whereas the regioisomer probe with similar π-conjugation fragment but different substitution profile shows the a-PeT effect. The easy derivatization of phenothiazine fluorophore, the structure-photophysical property relation and the novel d-PeT fluorescence transduction profile of the phenothiazine based probes described herein may inspire more investigation into this fascinating research area.     

Preparation of functional spherical polysilsesquioxane/gold nanoparticle composites and their applications in DNA assay

Functional spherical solid and hollow particles of polysilsesquioxanes (PSQs) containing amine, thiol, and vinyl groups were prepared by polymerizing organotrialkoxysilanes (OTASs) containing corresponding chemical groups. Fluorescent PSQ particles were prepared by physically entrapping Rhodamine 6G, Coumarin 7, and Fluoresceine sodium salts. The intensity of fluorescent light increased initially with increasing amount of entrapped fluorophores and then leveled off or decreased slightly after reaching a maximum value. PSQ particles containing gold nanoparticles (GNPs), both inside and on the surface, were prepared by the in situ reduction of gold ions by the PSQ particles. When the reduction reaction was carried out for extended periods of time, the GNP that had formed inside the poly(3-mercaptopropyl)silsesquioxane (PMPSQ) and polyvinylsilsesequioxane (PVSQ) particles underwent interesting morphological changes. PSQ particles containing amine and thiol groups fixed the GNPs on the surface, which could be utilized further in binding amine-modified oligo-DNA strands. The aggregation of PSQ/GNP particles combined with complementary oligo-DNA strands was examined to demonstrate that these particles could be applied to DNA assays and isolation. The particles were characterized by scanning electron microscopy, transmission electron microscopy, solid state nuclear magnetic resonance spectroscopy, ultraviolet/visible spectroscopy, and fluorescence microscopy.     

AlF<Subscript>3</Subscript> coating of LiNi<Subscript>0.5</Subscript>Mn<Subscript>1.5</Subscript>O<Subscript>4</Subscript> for high-performance Li-ion batteries

AlF₃-coating is attempted to improve the performance of LiNi_0.5Mn_1.5O₄ cathode materials for Li-ion batteries. The prepared powders are characterized by scanning electron microscope, powder X-ray diffraction, charge/discharge, and impedance. The coated LiNi_0.5Mn_1.5O₄ samples show higher discharge capacity, better rate capability, and higher capacity retention than the uncoated samples. Among the coated samples, 1.0 mol% AlF₃-coated sample shows highest capacity after charge–discharged at 30 mA/g for 3 cycles, but 4.0 mol% coated sample exhibits the highest capacity and cycling stability when cycled at high rate of 150 and 300 mA/g. The 40th cycle discharge capacity at 300 mA/g current still remains 114.8 mAh/g for 4.0 mol% AlF₃-coated LiNi_0.5Mn_1.5O₄, while only 84.3 mAh/g for the uncoated sample.     

Nonlinear dust-ion-acoustic waves in a multi-ion plasma with trapped electrons

A dusty multi-ion plasma system consisting of non-isothermal (trapped) electrons, Maxwellian (isothermal) light positive ions, warm heavy negative ions and extremely massive charge fluctuating stationary dust have been considered. The dust-ion-acoustic solitary and shock waves associated with negative ion dynamics, Maxwellian (isothermal) positive ions, trapped electrons and charge fluctuating stationary dust have been investigated by employing the reductive perturbation method. The basic features of such dust-ion-acoustic solitary and shock waves have been identified. The implications of our findings in space and laboratory dusty multi-ion plasmas are discussed.     

The Dirac Operator on Generalized Taub-NUT Spaces

We find sufficient conditions for the absence of harmonic L ² spinors on spin manifolds constructed as cone bundles over a compact Kähler base. These conditions are fulfilled for certain perturbations of the Euclidean metric, and also for the generalized Taub-NUT metrics of Iwai-Katayama, thus proving a conjecture of Vi?inescu and the second author.     

The Influence of Temperature on Coumarin 153 Fluorescence Kinetics

The influence of temperature varied in the range 183 K–323 K on the fluorescence quantum yield, fluorescence lifetime, absorption and emission transition moments and non-radiative deactivation rate was determined for the well known and largely used dye Coumarin 153, dissolved in 1-chloropropane. The Kennard-Stepanov relation connecting the absorption and emission spectra was used to check for the presence of more than one absorbing/emitting species and to investigate whether intramolecular vibrational redistribution completes in the C153 excited S ₁ state before the emission takes place. The emission spectrum corresponding to S ₁→S ₀ transition, was fitted at each temperature to the model function including the information on the dye vibrational modes coupling. In this way the displacement in equilibrium distance for the most active vibrational mode was determined for C153 in S ₁ and in S ₀. Using the temperature dependence of the fluorescence decay time and quantum yield, the non-radiative deactivation rate was determined. Its temperature dependence was compared to that calculated using the theoretical model with the most active vibrational mode displacement values taken from steady-state spectra analysis. The somewhat surprising dependence of the fluorescence decay time and quantum yield on temperature was related to non-trivial coupling between low-frequency vibrational modes of C153 in the excited and ground states.     

Plasma-filled rippled wall rectangular backward wave oscillator driven by sheet electron beam

Performance of the backward wave oscillator (BWO) is greatly enhanced with the introduction of plasma. Linear theory of the dispersion relation and the growth rate have been derived and analysed numerically for plasma-filled rippled wall rectangular waveguide driven by sheet electron beam. To see the effect of plasma on the TM₀₁ cold wave structure mode and on the generated frequency, the parameters used are: relativistic factor γ = 1.5 (i.e. v/c = 0.741), average waveguide height y ₀ = 1.445 cm, axial corrugation period z ₀ = 1.67 cm, and corrugation amplitude ε = 0.225 cm. The plasma density is varied from zero to 2 ×10¹² cm^− 3. The presence of plasma tends to raise the TM₀₁ mode cut-off frequency (14 GHz at 2 ×10¹² cm^− 3 plasma density) relative to the vacuum cut-off frequency (5 GHz) which also causes a decrease in the group velocity everywhere, resulting in a flattening of the dispersion relation. With the introduction of plasma, an enhancement in absolute instability was observed.