Influence of cesium on the stability of a GaAs photocathode

The stability of a reflection-mode GaAs photocathode has been investigated by monitoring the photocurrent and the spectral response at room temperature.We observe the photocurrent of the cathode decaying with time in the vacuum system under the action of Cs current,and find that the Cs atoms residing in the vacuum system are helpful in prolonging the life of the cathode.We examine the evolution and analyse the influence of the barrier on the spectral response of the cathode.Our results support the double dipolar model for the explanation of the negative electron affinity effect.     

声光移频器对微多普勒效应探测的影响研究

为实现基于微多普勒效应的远距离目标探测和识别,研究了采用声光移频器的激光外差相干探测结构对目标微多普勒特征探测的影响。建立了声光移频器驱动功率与系统信噪比之间的数学模型,并进行了仿真计算,搭建了1550 nm激光外差/零差相干探测实验平台对所建模型进行了验证。研究结果表明:在移频器驱动电压限定范围内,驱动电压越高,对微多普勒效应探测的效果越好,得到的目标特征越明显,与理论分析一致。通过对比实验发现在同样条件下,外差探测得到的反映目标特征的时频分布曲线较零差的清晰,特征提取误差小,可读性更高,说明外差探测结构更有利于复杂的远距离目标探测。     

百瓦级高亮度光纤耦合半导体激光模块的研制

用3只976 nm半导体激光短列阵作为子模块,研制出连续工作的百瓦级高亮度光纤耦合模块。首先,利用光束转换器将每个半导体激光短列阵进行光束整形;然后采用空间复用技术将3个半导体激光短列阵在光参数积小的方向上叠加,并利用倒置伽利略望远镜作为扩束器进一步压缩发散角;最后利用优化结构的透镜组将激光聚焦到芯径200 μm,数值孔径为0.22的光纤中。测量结果显示:聚焦后激光的发散角为24.8°,焦平面的光斑尺寸为175.2 μm;耦合后测量光纤出光功率可达107 W,对应亮度为2.23 MW/(cm²·sr),达到了国内利用列阵进行光纤耦合的领先水平;在工作电流为52.5 A时,电光转换效率为43.1%,远高于全固态等激光器;最后测量本模块在不同驱动电流时的光谱,并以此计算出模块的热阻为1.29 K/W,说明它的散热性能良好。结果表明,本光纤耦合模块适合应用于泵浦光纤激光器、医疗和激光加工等领域。     

Novel delay-distribution-dependent stability analysis for continuous-time recurrent neural networks with stochastic delay

<正>In this paper,the problem of delay-distribution-dependent stability is investigated for continuous-time recurrent neural networks(CRNNs) with stochastic delay.Different from the common assumptions on time delays,it is assumed that the probability distribution of the delay taking values in some intervals is known a priori.By making full use of the information concerning the probability distribution of the delay and by using a tighter bounding technique(the reciprocally convex combination method),less conservative asymptotic mean-square stable sufficient conditions are derived in terms of linear matrix inequalities(LMIs).Two numerical examples show that our results are better than the existing ones.     

129I加速器质谱分析研究

通过对129I加速器质谱(AMS)分析中影响敏度和准确度各种参数的研究,如靶电极制备、压样、靶样中辅助介质（Matrix）的选择及使用比例等,优化了用于3 MV加速器质谱仪的SO-110型离子源的条件参数,确定129I-AMS测量的最佳靶电极材料为Cu,最佳的辅助介质为Nb粉末,Nb与AgI样品的最佳体积比为3∶1。在此条件下可以获得稳定且持续的I-束流进行测量129I/127I原子比值,实验测得西安加速器质谱仪的129I/127I本底值为1.5210-14。     

金属Zn液态结构变化的研究

利用ＴＢ模型给出的原子间相互作用势详细计算了不同温度下Ｚｎ的双体分布函数ｇ（ｒ），结果发现随着温度的不断降低，液态金属Ｚｎ的ｇ（ｒ）第一峰变得高而尖，第二峰由弱变强，说明了液态金属Ｚｎ的有序度随温度降低而不断增强；利用键对分析技术统计了液态金属Ｚｎ在不同温度下的键取向序参数、键对数。键取向序参数及键对数随温度的变化，进一步证明了低温液态的有序度高于高温液态，从而充分说明液态金属在不同温度下有不同的结构形式，而不像人们想象得那样杂乱无章。     

Dosimetry in sonochemistry: the use of aqueous terephthalate ion as a fluorescence monitor

The generation of HO radicals by acoustic cavitation in water was monitored by their reaction with terephthalic acid (TA) anion to produce fluorescent hydroxyterephthalate ions using a cleaning bath (38kHz) and a probe system (20, 40 and 60 kHz) as different sources of ultrasound. When using the ultrasonic bath as a source of energy for sonochemical studies, the shape of the reaction vessel is important. In the case of HO production from water (50 cm³), reaction in a conical flask (100 cm³) produces 2.75 times more radicals than a round-bottomed flask of the same capacity. The fluorescence yield (fluorescence intensity/ultrasound dosage) obtained using the conical flask and ultrasonic bath was similar to that for a probe operating at 40 kHz on the same volume of solution. For a probe system operating at 20, 40 and 60 kHz the greatest sonochemical efficiency was attained at the highest of these frequencies (60 kHz). For the probe system the fluorescence yield is directly proportional to power input and the concentration of TA. The fluorescence yield decreases as the temperature is increased.     

基于二代curvelet变换的图像融合研究

曲波(Curvelet)作为一种新的多尺度分析方法比小波更加适合分析二维图像中的曲线或直线状边缘特征,而且具有更高的逼近精度和更好的稀疏表达能力.将curvelet变换引入图像融合,能够更好地提取原始图像的特征,为融合图像提供更多的信息.第二代curvelet理论的提出也使得其理论更易理解和实现.因此,提出了一种基于第二代curvelet变换的图像融合方法,首先将图像进行curvelet变换,然后在相应尺度上利用融合规则将curvelet系数融合,最后进行重构得到融合结果.对多聚焦图像进行了实验,采用均方误差、偏差指数和相关系数对融合结果进行了客观评价,并与基于小波变换的融合进行了比较,实验结果表明该方法除分解2层时与小波性能相当,取其他分解层数时均获得更好的融合效果.     

采用(meta)-GGA泛函对Ag(111)、Rh(111)和Ir(111)上乙烯吸附的理论研究

本文针对在多种催化反应的重要中间体乙烯,使用(meta)-GGA等级的包含PBE,BEEF-vdW,SCAN以及SCAN+rVV10在内的多种交换关联泛函,系统研究了在过渡金属表面(Ag,Rh和Ir)上乙烯吸附势能面对泛函的依赖关系. 研究发现,对于乙烯在贵金属Ag(111)上的吸附,除了PBE外,BEEF-vdW,SCAN以及SCAN+rVV10均能预测出物理吸附态的存在. 对于乙烯在Rh(111)面的吸附,SCAN和SCAN+rVV10预测在化学吸附位之前存在有物理吸附前驱态,而基于PBE和BEEF-vdW的势能面并没有发现前驱态的存在. 而对于乙烯在Ir(111)上的吸附,BEEF-vdW也能微弱地预测出化学吸附前驱态的存在. 研究结果表明,无论在哪一种金属表面上,四种泛函中SCAN+rVV10给出的吸附能最强,其次是SCAN,最后是PBE或者BEEF-vdW.     

Fast multi-planar gradient echo MR imaging: impact of variation in pulse sequence parameters on image quality and artifacts

The purpose of this investigation was to quantitatively evaluate the practical impact of alteration of key imaging parameters on image quality and artifacts in fast multi-planar gradient echo (GRE) pulse sequences. These include multi-planar GRASS (MPGR) and fast multi-planar spoiled GRASS (FMPSPGR). We developed a composite phantom with different T(1) and T(2) values comprising the range of common biological tissues, which was also subjected to periodic motion in order to evaluate motion effects. Magnetic resonance imaging was performed on a GE Signa 1.5-T system. Experimental variations in key parameters included excitation flip angle (FL), echo time (TE), repetition time (TR), and receive bandwidth (BW). Quantitative analysis consisted of signal-to-noise-ratio (SNR) and contrast (CN), image nonuniformity (NU), full-width-at-half-maximum (FWHM) (i.e., blurring or geometric distortion), and ghosting ratio (GR). We found that flip angle, TE, and TR play particularly critical roles in determining image signal, homogeneity, and ghosting artifact with these sequences. Optimum clinical application of these pulse sequences requires careful attention to these imaging parameters and to their complex interactions.