基于改善空间关联性的混沌控制

基于混沌信号的统计特性，提出了一种通过改善混沌信号的空间关联性实现混沌控制的方法.以Hénon离散混沌系统和四阶Chua's电路超混沌连续系统为例进行了数值研究，验证了这种控制方法的有效性.结果表明， 通过改善混沌信号之间的空间关联性， 混沌系统能以较快的速度收敛到它的平衡点或多种周期轨道. 关键词： 混沌控制 空间关联性 Hénon系统 四阶Chua's电路     

接枝羧基的有限长碳纳米管电子结构的第一性原理研究

基于局域密度泛函理论，采用第一性原理方法，建立了对(5,5)型和(9,0)型有限长碳纳米管接枝羧基官能团的原子模型，通过计算其电子分布和态密度的变化，讨论羧基官能团对碳纳米管电子结构和电子输运特性的影响. 计算表明，接枝羧基的碳纳米管,其电子结构明显改变，其费米能级上的电子态密度下降；最高占据轨道上的非定域程度减弱,致使电子输运性能呈下降趋势. 关键词： 碳纳米管 密度泛函理论 电子结构     

针板型触发电晕稳定开关的特性

 为了验证在空气状态下电晕稳定开关的重复频率特性,对自行研制的盘式触发三电极电晕稳定开关的工作特性进行了实验研究,并分析了实验结果。结果表明,在空气状态下,开关具有良好的触发特性,开关抖动和导通时延最小可以分别控制在4, 36 ns;同时,还可以通过减小触发间隙,进一步减小开关的导通时延和增加开关的稳定性。     

图形处理器并行计算用于离子发动机粒子模拟

 为了研究离子发动机羽流对航天器的影响,采用质点网格-蒙特卡罗碰撞方法对离子发动机羽流中的交换电荷离子进行了模拟。利用计算设备统一架构技术,开发出一套基于图形处理器的并行粒子模拟程序。随机数生成采用并行MT19937伪随机数生成器算法,电场方程使用完全近似存储格式的代数多重网格法求解。r-z轴对称坐标系中,在z=0 m处获得的电流密度均值为4.5×10^-5 A/m²,图形处理器所得结果与中央处理器模拟结果吻合。在16核心的NVIDIA GeForce 9400 GT图形显示卡上,取得相对于Intel Core 2 E6300中央处理器4.5~10.0倍的加速比。     

An upgraded external beam PIXE setup for multielemental analysis of atmospheric aerosol samples

The external beam particle‐induced X‐ray emission (PIXE) setup has been upgraded by introducing a new silicon drift detector with the aim of obtaining better minimum detection limits (MDLs) at the 2 × 1.7 MV Tandetron accelerator of the Beijing Normal University in China. The upgraded external beam PIXE setup is equipped with two silicon drift detectors for PIXE analysis of low and high Z elements. A surface barrier detector for Rutherford backscattering spectrometry monitors beam and helium flow. Two kinds of aerosol filter samples (quartz fiber filters and Teflon filters) were studied. A 200‐μm thick Mylar absorber in front of the medium‐high energy X‐rays detector was adopted, and it got the best MDLs for atmospheric aerosol samples analysis. Multielemental analysis of quartz fiber filter aerosol samples was achieved. For more accurate and better MDLs of low Z elements in PIXE analysis, it is necessary to keep sufficient helium flow behind the thin samples.     

Hearing loss from interrupted, intermittent, and time varying non-Gaussian noise exposure: The applicability of the equal energy hypothesis

Sixteen groups of chinchillas (N=140) were exposed to various equivalent energy noise paradigms at 100 dB(A) or 103 dB(A) SPL. Eleven groups received an interrupted, intermittent, and time varying (IITV) non-Gaussian exposure quantified by the kurtosis statistic. The IITV exposures, which lasted for 8 hday, 5 daysweek for 3 weeks, were designed to model some of the essential features of an industrial workweek. Five equivalent energy reference groups were exposed to either a Gaussian or non-Gaussian 5 days, 24 hday continuous noise. Evoked potentials were used to estimate hearing thresholds and surface preparations of the organ of Corti quantified the sensory cell population. For IITV exposures at an equivalent energy and kurtosis, the temporal variations in level did not alter trauma and in some cases the IITV exposures produced results similar to those found for the 5 day continuous exposures. Any increase in kurtosis at a fixed energy was accompanied by an increase in noise-induced trauma. These results suggest that the equal energy hypothesis is an acceptable approach to evaluating noise exposures for hearing conservation purposes provided that the kurtosis of the amplitude distribution is taken into consideration. Temporal variations in noise levels seem to have little effect on trauma.     

A lateral super-resolution differential confocal technology with phase-only pupil filter

In order to achieve a higher lateral resolution required for ultraprecision measurement of microstructural workpieces, phase-only pupil filtering differential confocal microscopy (PFDCM), a new approach is proposed based on the differential confocal microscopy (DCM), which uses a three-zone phase-only pupil filter with lateral super-resolution capability obtained through optimized design to change the distribution of DCM three-dimensional point spread function, so that the DCM lateral resolution is therefore significantly improved while its axial resolution is slightly improved. Preliminary experimental comparison and analyses indicate that, the lateral and axial resolutions of PFDCM are better than 0.2 μm and 2 nm, respectively, when wavelength of incidence laser beam , numerical aperture of measuring lens NA=0.85, and lateral spot size with a three-zone phase-only pupil filter G_T=0.65. It is therefore concluded that PFDCM is a new approach to further improvement of lateral resolution in laser probe measurement systems.     

Hydrocarbon film growth by energetic CH3 molecule impact on SiC (0 0 1) surface

Classic molecular dynamics (MD) calculations were performed to investigate the deposition of thin hydrocarbon film. SiC (1 0 0) surfaces were bombarded with energetic CH₃ molecules at impact energies ranging from 50 to 150 eV. The simulated results show that the deposition yield of H atoms decreases with increasing incident energy, which is in good agreement with experiments. During the initial stages, with breaking Si-C bonds in SiC by CH₃ impacting, H atoms preferentially reacts with resulting Si to form Si-H bond. The C/H ratio in the grown films increases with increasing incident energy. In the grown films, CH species are dominant. For 50 eV, H-Csp3 bond is dominant. With increasing energy to 200 eV, the atomic density of H-Csp2 bond increases.     

Microstructures and electrical properties of La0.8Sr0.2MnO3 films synthesized by sol-gel method

La_0.8Sr_0.2MnO₃ (LSMO) thin films were fabricated on alumina substrates by an improved sol-gel dip-coating process. It was found that multiple dip-coating process could not be performed until the pre-firing temperature reached 600 °C. Different amounts of LSMO powders were added to precursor solution with an aim to avoid cracks in LSMO thin films during calcining caused by the shrinkage mismatch between the film and the substrate. The structure and surface morphology of the films prepared from precursors with and without LSMO powders were characterized using X-ray diffraction (XRD) and scanning electron microscopy (SEM). It was found that the addition of 56.4 wt.% LSMO powders into the sol-gel precursor solution significantly modified the microstructure of films. A single LSMO perovskite phase was obtained on alumina substrate after calcining at 800 °C for 4 h by the improved sol-gel method. The sheet resistance of the films prepared with different processing parameters was measured by four-point dc method. Results indicated that the sheet resistance of films decreased with increasing the number of coating applications and the amount of LSMO powders.     

A study of sound intensity control for active noise barriers

Active noise control systems have been applied to increase the insertion loss of noise barriers where the squared sound pressure or the total acoustic energy density is used as the cost function in previous works. The absolute value of the mean active sound intensity is chosen as the cost function to obtain extra sound insertion loss in the dark area of a hybrid active noise barrier system in this note. The strategy of minimizing the near-field sound intensity at discrete locations along the edge of the passive barrier is shown to be able to provide better far-field noise reduction than that of minimizing the squared sound pressure control. Both numerical simulations and off-line experiments are carried out with a three-channel demonstration system, where the locations of the secondary sources and the error sensors are optimized and comparisons are made between the extra sound pressure attenuation of the sound intensity control and that of the squared sound pressure control.