Application of XPS imaging analysis in understanding interfacial delamination and X‐ray radiation degradation of PMMA

The recent development of X‐ray Photoelectron Spectroscopy (XPS) instrumentation with spatial resolution down to several microns has advanced the capability of elemental and chemical state imaging. XPS imaging analysis has been applied in understanding the delamination problems of siloxane coatings on polymethyl‐methacrylate (PMMA) polymer. It was found that delamination occurred by interfacial failure, and the coating suffered complete delamination from a PMMA substrate. This example offered an opportunity for the investigation of X‐ray damage on polymers encountered in XPS imaging analysis. This paper also demonstrated how to construct a constrained peak model with the aid of chemical knowledge and supporting evidence of the sample. Monte Carlo error analysis was used to determine the validity of the peak fit models used. Copyright © 2013 John Wiley & Sons, Ltd.     

Characterization of size‐segregated aerosols using ToF‐SIMS imaging and depth profiling

Size‐segregated particles were collected with a ten‐stage micro‐orifice uniform deposit impactor from a busy walkway in a downtown area of Hong Kong. The surface chemical compositions of aerosol samples from each stage were analyzed using time‐of‐flight secondary ion mass spectrometry (ToF‐SIMS) operated in the static mode. The ToF‐SIMS spectra of particles from stage 2 (5.6–10 µm), stage 6 (0.56–1 µm), and stage 10 (0.056–0.1 µm) were compared, and the positive ion spectra from stage 2 to stage 10 were analyzed with principal component analysis (PCA). Both spectral analysis and PCA results show that the coarse‐mode particles were associated with inorganic ions, while the fine particles were associated with organic ions. PCA results further show that the particle surface compositions were size dependent. Particles from the same mode exhibited more similar surface features. Particles from stage 2 (5.6–10 µm), stage 6 (0.56–1 µm), and stage 10 (0.056–0.1 µm) were further selected as representatives of the three modes, and the chemical compositions of these modes of particles were examined using ToF‐SIMS imaging and depth profiling. The results reveal a non‐uniform chemical distribution from the outer to the inner layer of the particles. The coarse‐mode particles were shown to contain inorganic salts beneath the organics surface. The accumulation‐mode particles contained sulfate, nitrate, ammonium salts, and silicate in the regions below a thick surface layer of organic species. The nucleation‐mode particles consisted mainly of soot particles with a surface coated with sulfate, hydrocarbons, and, possibly, fullerenic carbon. The study demonstrated the capability of ToF‐SIMS depth profiling and imaging in characterizing both the surface and the region beneath the surface of aerosol particles. It also revealed the complex heterogeneity of chemical composition in size and depth distributions of atmospheric particles. Copyright © 2014 John Wiley & Sons, Ltd.     

Computational studies on two novel energetic nitrogen‐rich compounds based on tetrazolone

Two novel energetic nitrogen‐rich compounds 1,4‐diaminotetrazol‐5‐one ( DATO ) and 1,4‐dinitrotetrazol‐5‐one ( DNTO ) were proposed first and studied by quantum chemistry method with B3LYP/6‐31G* level of theory. The optimized geometry, IR predicted spectrum and thermochemical parameters, frontier molecular orbitals and molecular electrostatic potential were calculated for inspecting the electronic structure, molecular stability and chemical reactivity. The important macroscopic properties including density, enthalpy of formation, detonation parameters and impact sensitivity have been predicted as well. As a result, two designed compounds DATO and DNTO possess positive enthalpy of formation (395.79 and 342.77 kJ/mol), impressive detonation parameters (D = 8.80 km/s, P = 33.69 GPa; D = 8.89 km/s, P = 34.98 GPa) superior to the remarkable explosive RDX, acceptable sensitivities and might be promising candidates of energetic materials. Copyright © 2015 John Wiley & Sons, Ltd.     

Electrical actuation of dielectric droplets by negative liquid dielectrophoresis

This paper presents an electrical actuation scheme of dielectric droplet by negative liquid dielectrophoresis. A general model of lumped parameter electromechanics for evaluating the electromechanical force acting on the droplets is established. The model reveals the influence of actuation voltage, device geometry, and dielectric parameter on the actuation force for both conductive and dielectric medium. Using this model, we compare the actuation forces for four liquid combinations in the parallel-plate geometry and predict the low voltage actuation of dielectric droplets by negative dielectrophoresis. Parallel experimental results demonstrate such electric actuation of dielectric droplets, including droplet transport, splitting, merging, and dispending. All these dielectric droplet manipulations are achieved at voltages < 100 V_rms. The frequency dependence of droplet actuation velocity in aqueous solution is discussed and the existence of surfactant molecules is believed to play an important role by realigning with the AC electric field. Finally, we present coplanar manipulation of oil and water droplets and formation of oil-in-water emulsion droplet by applying the same low voltage.     

Theoretical kinetic study on the decomposition of 1,5‐diaminotetrazole

1,5‐Daminotetrazole (DAT) is of much interest because of the practical significance and the diversity of characteristics. The study on the decomposition pathway and the kinetics of DAT has been performed based on the quantum chemistry theory. The minimum energy path (MEP) calculation has shown that NH₂N₃ and NH₂CN are the initially detected products of DAT. And the structures of reactant, products and transition state were optimized with MP2 methods using 6‐311G** basis sets, and the energies were refined using CCSD(T)/6‐311G** levels of theory. The calculated rate constants were obtained using the conventional transition‐state theory (TST) and the canonical variational transition‐state theory (CVT) methods. The calculation results indicated that the energy barrier of decomposition reaction is 47.98 kcal mol^?1 and the variational effect is small. In addition, the rate constants and the Arrhenius experience formula of DAT decomposition have been obtained between 200 and 2500 K temperature regions. The fitted three‐parameter expressions calculated using the TST and CVT methods are (TST) and (CVT). This work may provide the theoretical support for further experimental synthesis and testing. Copyright © 2015 John Wiley & Sons, Ltd.     

含硅功能化聚烯烃:合成及应用

聚烯烃功能化改性是获得高性价比新材料的有效途径。含硅功能化聚烯烃(SFPO)是聚烯烃分子结构中含有机硅功能基团或有机硅聚合物链段的一类功能化聚烯烃的统称。由于有机硅功能基团及有机硅聚合物特殊的理化性质,SFPO通常具有丰富反应性或优异性能,成为一类有代表性的功能化聚烯烃。SFPO可以作为反应性中间体,用于制备具有复杂拓扑结构的功能化聚烯烃(如星型聚合物、梳型聚合物、接枝共聚物)或聚烯烃共价键接枝改性纳米材料;SFPO还可作为功能性添加剂(如增容剂、加工助剂,表面改性剂),用于开发聚烯烃新材料。近年来,研究人员在含硅功能化聚烯烃研究领域取得了系列进展,本文旨在对相关工作进行系统总结,以期引起同行注意并促进相关研究深入发展。     

Living Supramolecular Polymerization of an Aza‐BODIPY Dye Controlled by a Hydrogen‐Bond‐Accepting Triazole Unit Introduced by Click Chemistry

An aza‐BODIPY dye 1 bearing two hydrophobic fan‐shaped tridodecyloxybenzamide pendants through 1,2,3‐triazole linkages was synthesized by a click reaction and characterized. ¹H NMR studies indicated that dye 1 exhibited variable conformations through intramolecular H‐bonding interaction, which is beneficial for the polymorphism of aggregation. The thermodynamic, structural, and kinetic aspect of the supramolecular polymerization of dye 1 was investigated by UV/Vis absorption spectroscopy, IR spectroscopy, AFM, TEM, and SEM. Biphasic aggregation pathways of dye 1 , leads to the formation of off‐pathway, metastable Agg. I and thermodynamically stable Agg. II with distinct H‐aggregation spectra and nanoscale morphology. The living manner of the supramolecular polymerization of dye 1 was demonstrated in seeded polymerization experiments with temperature‐modulated successive cooling–heating cycles.     

Construction of Liposomes Mimicking Cell Membrane Structure through Frame‐Guided Assembly

The shape of eukaryotic cells is determined by the cytoskeleton associated with membrane proteins; however, the detailed mechanism of how the integral morphologies with structural stability is generated and maintained is still not fully understood. Here, based on the Frame‐Guided Assembly (FGA) strategy, we successfully prepared hetero‐liposomes with structural composition similar to that of eukaryotic cells by screening a series of transmembrane peptides as the leading hydrophobic groups (LHGs). It was demonstrated that the conformation and transmembrane mode of the LHGs played dominant roles during the FGA process. The FGA liposomes were formed with excellent stability, which may further provide evidence for the cytoskeleton–membrane protein–lipid bilayer model. Taking advantage of the biocompatibility and stability, the FGA liposomes were also applied to prepare novel drug delivery vehicles, which is promising in diagnostic imaging and cancer therapy applications.     

La-Ba-Sm体系催化剂上的甲烷氧化偶联

用甲烷氧化偶联反应评价了不同方法制备的Ｌａ－Ｂａ－Ｓｍ体系催化剂，结果表明，用机械混合Ｌａ２Ｏ３，Ｂａ（ＯＨ）２．８Ｈ２Ｏ和Ｓｍ２Ｏ３三组分及高温焙烧方法制备的催化剂，从Ｃ２收率和选择性总体看，较其它方式优越，在催化剂（ＩＶ）上进行了５００ｈ的稳定性实验，在整个过程中，催化剂的活性和选择性基本稳定；催化剂的起动温度较低，在较宽的温度范围内易于控制对工业生产意义较大，通过ＸＲＤ，ＸＰＳ，ＩＲ，ＳＥＭ