两台自私型机器上自私工件排序的PoA紧界

本文研究了两台自私型机器上有自私型工件的关于二元均衡的排序问题。对任意工件序列$L$, 证明了二元均衡排序的PoA的紧界为$\frac{8}{7}$。如果工件尺寸在区间$[1, r](r\ge1)$内, 得到了二元均衡排序的PoA的紧界为关于$r$的分段线性函数。     

非奇H矩阵的充分条件

文章通过引进一类具有非零元素链的矩阵,利用α对角占优矩阵性质,给出了一个新的非奇H矩阵的充分条件,扩大了非奇H矩阵的判定范围．     

一种含SiO2氧化物玻璃的晶化温度-压力依赖关系

 本文应用DTA及X射线衍射法在常压及高压下对一种含SiO₂的锂离子导体玻璃0.3Li₂O-0.67SiO₂-0.03V₂O₅加热时的晶化行为进行了研究。该氧化物玻璃的晶化过程分两个阶段。在常压下，第一晶化过程发生在560 ℃附近，析出相为Li₂O·2SiO₂。对应的晶化温度T_x1随压力的升高发生了急剧的变化。从常压到0.3 GPa，T_x1从560 ℃升高到620 ℃；继续升压时T_x1突然下降，并在0.4 GPa处跌到528 ℃，呈现一个陡峭的峰值。0.4 GPa以上，T_x1随压力的变化则呈常规行为，比较平稳地，大致线性地升高，一直到最高测定压力2 GPa。 本文最后对这些行为的可能原因进行了讨论。     

安装偏差对光纤布喇格光栅应变测量的影响

通过理论推导和试验分析研究了安装偏差对光纤应变测量的影响,得到安装误差所带来测量误差的计算公式.发现光纤的轴向与预定安装方向的角偏差越大,测量误差也越大.用光纤光栅进行应变测量时,必须考虑光纤的安装偏差,它直接关系到测量结果的准确性.实际测量中要尽量确保传感器安装方位的准确.     

交叉分子束方法研究H+CH4和H+CD4反应:CH3/CD3的振动激发态产物通道

We study the H+CH₄/CD₄→H₂/HD+CH₃/CD₃ reactions using the time sliced velocity map ion imaging technique. Ion images of the CH₃/CD₃ products were measured by the (2+1) resonance enhanced multi-photon ionization (REMPI) detection method. Besides the CH₃/CD₃ products in the ground state, ion images of the vibrationally excited CH₃/CD₃ products were also observed at two collision energies of 0.72 and 1.06 eV. It is shown that the angular distribution of the products CH₃/CD₃ in vibrationally excited states gradually vary from backward scattering to sideways scattering as the collision energy increases. Compared to the CH₃/CD₃ products in the ground state, the CH₃/CD₃ products in vibrationally excited states tend to be more sideways scattered, indicating that larger impact parameters play a more important role in the vibrationally excited product channels.     

LDS751染料的受激喇曼散射

报道了用532nm激光抽运LDS751染料产生720—780nm可调谐染料激光输出的同时,观察到喇曼频移为102和45cm-1的反斯托克斯线,前者谱线较强,后者较弱.与这两条强线对应的斯托克斯线未能观察到.另外,还观察到喇曼频移为34cm-1的一级和二级斯托克斯线与反斯托克斯线 关键词： LDS751染料 受激喇曼散射 喇曼位移 斯托克斯线 反斯托克斯线     

退火对B掺杂纳米金刚石薄膜微结构和电化学性能的影响

采用热丝化学气相沉积法制备B掺杂纳米金刚石薄膜,并对薄膜进行真空退火处理,系统研究了不同退火温度对B掺杂纳米金刚石薄膜的微结构和电化学性能的影响.结果表明,当退火温度升高到800 ℃后,薄膜的Raman谱图中由未退火时在1157,1346,1470,1555 cm^-1处的4个峰转变为只有D峰和G峰,说明晶界上的氢大量解吸附量减少,并且D峰和G峰的积分强度比I_D/I_G值变为最小,即sp²相团簇     

Tm-Doped Fibre Laser Pumped Cr^2＋：ZnSe Poly-Crystal Laser

Demonstrations of cw lasing in Cr^2＋：ZnSe poly-crystal are reported. The laser consists of a 1.7-mm-thick Cr^2＋ ：ZnSe poly-crystal disc pumped by a Tin-silica double-clad fibre laser at 2050nm. Using a concave high- reflection mirror with a radius of curvature of 500mm as the rear mirror, the laser delivers up to 1030mW of radiation around 2.367μm.     

(Na1/2Bi1/2)Cu3Ti4O12陶瓷的微观结构和电学性质

利用固相反应法在不同烧结温度条件下制备了一系列(Na_1/2Bi_1/2)Cu₃Ti₄O₁₂(NBCTO)陶瓷样品,研究了它们的晶体结构、微观组织结构、介电性质和复阻抗及其随温度的变化. 实验发现NBCTO陶瓷所呈现出的电学性质与CaCu₃Ti₄O₁₂陶瓷相应的电学性质非常类似. 烧结温度为990℃至1060℃范围的NBCTO陶瓷样品室 关键词： 高介电材料 介电性质 复阻抗 内阻挡层电容     

Velocity overshoot of start-up flow for a Maxwellfluid in a porous half-space

Stokes' first problem has been investigated for a Maxwell fluid in a porous half-space for gaining insight into the effect of viscoelasticity on the start-up flow in a porous medium. An exact solution was obtained by using the Fourier sine transform. It was found that at large values of the relaxation time the velocity overshoot occurs obviously and the system exhibits viscoelastic behaviours. On the other hand, for short relaxation time the velocity overshoot disappears and the system exhibits viscous behaviours. A critical value of the relaxation time was obtained for the emergence of the velocity overshoot. Furthermore, it was found that the velocity overshoot is caused by both the viscoelasticity of the Maxwell fluid and the Darcy resistance resulting from the structure of the micropore in the porous medium.