Optically active helical polyurethane@attapulgite composites: Effect of optical purity of S-1,1′-binaphthyl-2,2′-diol on infrared emissivity

Helical polyurethane@attapulgite (HPU@ATT) composites were prepared after the surface modification of the rod-like attapulgite (ATT). HPU@ATT composites based on S-1,1′-binaphthyl-2,2′-diol (S-BINOL) with different optical purity (O.P.) were characterized by Fourier-transform infrared spectroscopy (FT-IR), X-ray diffraction (XRD) and thermogravimetric analysis (TGA). The results indicate that the helical polyurethane has been successfully grafted onto the surfaces of the modified ATT without destroying the original crystalline structure of ATT. The rod-like nanoparticles were confirmed by transmission electron microscopy (TEM). Infrared emissivity values of HPU@ATT composites have been investigated, and the results indicate that the optical purity of monomer plays a very important role in the infrared emissivity for HPU@ATT owing to the effect of helical conformation and interchain hydrogen bonds. Along with the increased optical purity of S-BINOL, the infrared emissivity of HPU@ATT is reduced evidently. Infrared emissivity value of HPU@ATT based on S-BINOL with 100% optical purity is the lowest one (0.431).     

光学综合孔径望远镜中子望远镜平行性和光程差调整的研究

光干涉技术与天文望远镜技术的结合是提高天文观测分辨率的一种有效方法.采用望远镜阵代替单个大口径望远镜来集光观测,利用最大基线的概念来等效传统光学望远镜的最大口径,很大程度上解决了单个望远镜集光能力不足、角分辨率不高的问题.然而对于光干涉来说,在应用中,只有满足:两束光的相位差δ必须相对稳定、存在相互平行的振动分量、频率相同、两光波在相遇点所产生振动的振幅相差不悬殊和两光波在相遇点的光程差(OPD)应在相干长度之内等这些条件时才能部分相干.光学综合孔径(OAS)望远镜产生干涉条纹的前提条件是子望远镜之间必须两两相干.推导了双光束光干涉的要求,并从双光束干涉的平行性和光程差的要求出发,研究并得出光学综合孔径望远镜子望远镜的平行性和光程差的要求.结合双光束干涉的恒星光干涉仪的光束平行性和光程差的调整方案,研究并得到了光学综合孔径望远镜子望远镜的平行性和光程差调整的光学方案,并讨论了该系统的改进措施.     

多媒体课件在物理教学中的应用分析

进入新世纪,传统教学模式已不适应现代教育教学的需要,多媒体辅助教学应运而生,且已融人现代教育技术,参与到整个教学过程.电教媒体不再局限于视听范畴,而呈现多媒体化、超文本化、网络化、交互性等新特点.应用多媒体课件,化抽象为形象、微观为宏观、静态为动态、不可操作为可操作过程,对激发学生的学习兴趣和积极性,化解知识难点,提高综合能力,推进素质教育具有重要意义.     

脉冲激光二极管侧面抽运Nd:YAG激光器晶体时变热效应

采用数值计算的方法,对脉冲激光二极管三向侧面抽运固体激光器中,激光晶体的温度场时变分布进行了计算. 分析了三向侧面抽运情况下晶体内光强分布,在此基础上,采用有限元法,以脉冲激光二极管侧面抽运Nd:YAG激光器为例,对单脉冲过程中晶体温度分布及其影响因素进行分析. 结果表明,晶体升温过程受到抽运条件以及散热条件的影响,但是主要受到抽运条件即抽运光强度和光束半径的影响,降温过程受到晶体热物性参数和晶体半径以及散热条件的影响. 当晶体温度达到周期性分布后,由于晶体径向温度梯度的周期性变化,引起通过晶体的平面光波的中心和边缘光线相对光程差也随时间作周期性变化.     

Tb2AlFe16-xMnx化合物的结构、磁性及正电子湮没谱研究

通过X射线衍射、磁测量及正电子湮没谱等手段研究了Tb₂AlFe_16-xMn_x（x=1—8）化合物的结构和磁性.X射线衍射研究结果表明Tb₂AlFe_16-xMn_x化合物具有六角相的Th₂Ni₁₇型结构.室温下的正电子湮没实验研究表明,Mn对Fe的替代导致化合物中的铁磁相互作用减弱,并且化合物中存在着较强烈的磁弹耦合效应.磁测量研究结果表明,Mn的替代导致Tb₂AlFe_16-xMn_x化合物的居里温度及自发磁化强度急剧下降. 关键词： 2AlFe_16-xMn_x化合物')" href="#">Tb₂AlFe_16-xMn_x化合物 磁弹耦合效应 居里温度     

Microwave tunable dielectric properties of multilayer CNT membranes for smart applications

We investigated the effect of the length of carbon nanotubes (CNTs) on the electrical property of CNT-based flexible, transparent, and conductive films (TCFs). We grew vertically aligned CNTs with controlled lengths, dispersed them in ethanol by ultrasonication, and spray coated them onto polyethylene terephthalate (PET) sheets. We focused on the variation in the sheet resistance and transmittance of the above-mentioned films as a function of the CNT length, and we found that the optimum CNT length was 200?μm. We concluded that the CNT length should be carefully optimized because a shorter tube affords the advantage of efficient dispersion, while a longer tube helps in reducing the number of contact points between tubes along the electrical conduction path.     

Accuracy analysis and stabilization design of the Fabry–Perot frequency discriminator in double-edge wind lidars

The measurement error of a double-edge wind lidar caused by a disturbed Fabry–Perot interferometer (FPI) is analyzed. Several error sources such as air pressure variations, temperature changes, and mechanical vibrations are considered in the measurement-error model. The simulation results show that a double-edge wind lidar is so sensitive to environmental variations that the measurement error reaches ±60 m/s if the FPI is not stabilized. In order to compensate the external disturbance acting on the FPI, a nonlinear proportional–integral–derivative (PID) control scheme is designed based on the transmission measurement of the calibration channel. An arc tangent function is used to improve the feedback gain of the usual PID control design. The results show that with the new controller the measurement accuracy of the wind lidar can be improved 4–5 times in comparison with the usual control design, and the range of the measurement error is only ±3 m/s.     

一种新的参数估计方法及其在混沌信号盲分离中的应用

为了有效地估计非线性映射中的参数,本文采用一种容积准则近似该映射的加权积分函数. 基于由状态空间模型建模的参数,提出了一种新的参数估计方法. 混沌信号的盲分离是一种具有挑战性的参数估计问题.将新的参数估计方法应用在该问题上, 实现混沌信号的有效重构.仿真结果表明该算法具有较快的收敛速度和较高的数值精度, 并能有效地分离原始混沌信号.     

栅极电势对强光场下石墨烯场效应管中电子隧穿的影响

利用时域有限差分方法研究了强光场下石墨烯场效应管中栅极电势对电子隧穿的影响. 在强光场下由于光学stark效应,石墨烯场效应管的完美手征透射被抑制.这种抑制除了 可以利用光场来调控外,也可以通过改变栅极电势的宽度、势垒高度等来调控. 研究了非方势垒中电子的隧穿. 研究发现,当电势的倾斜较小时,电子隧穿概率变化不大.而当电势倾斜很大时,电子隧穿概率急剧改变.     

Ideal Mixture Approximation of Cluster Size Distributions at Low Density

We consider an interacting particle system in continuous configuration space. The pair interaction has an attractive part. We show that, at low density, the system behaves approximately like an ideal mixture of clusters (droplets): we prove rigorous bounds (a) for the constrained free energy associated with a given cluster size distribution, considered as an order parameter, (b) for the free energy, obtained by minimising over the order parameter, and (c) for the minimising cluster size distributions. It is known that, under suitable assumptions, the ideal mixture has a transition from a gas phase to a condensed phase as the density is varied; our bounds hold both in the gas phase and in the coexistence region of the ideal mixture. The present paper improves our earlier results by taking into account the mixing entropy.