The polar ionosphere at Zhongshan station on May 11, 1999, the day the solar wind almost disappeared

The solar wind almost disappeared on May 11, 1999: the solar wind plasma density and dynamic pressure were less than 1cm⁻³ and 0.1 nPa respectively, while the interplanetary magnetic field was northward. The polar ionospheric data observed by the multi-instruments at Zhongshan Station in Antarctica on such special event day was compared with those of the control day (May 14). It was shown that geomagnetic activity was very quiet on May 11 at Zhongshan. The magnetic pulsation, which usually occurred at about magnetic noon, did not appear. The ionosphere was steady and stratified, and the F₂ layer spread very little. The critical frequency of day-side F₂ layer, f₀F₂, was larger than that of control day, and the peak of f₀F₂ appeared 2 hours earlier. The ionospheric drift velocity was less than usual. There were intensive auroral E_s appearing at magnetic noon. All this indicates that the polar ionosphere was extremely quiet and geomagnetic field was much more dipolar on May 11. There were some signatures of auroral substorm before midnight, such as the negative deviation of the geomagnetic H component, accompanied with auroral E_s and weak Pc3 pulsation.

     

激光等离子体2660紫外探针及干涉系统

成功地在六路高功率Nd玻璃激光装置上建立了2660紫外激光探针和适合紫外波段的Normaski干涉仪,首次将可见波长的连续激光应用于紫外干涉仪中靶成像调整和光路准直。利用该紫外光干涉仪,在铜柱状靶(φ500μm)上测量了厚等离子体中高达0.6n。的电子密度。     

Error analysis: a tool for selecting travel demand models

In developing travel demand models it is generally assumed that the base-year data used in developing the parameters, as well as the forecasted data to be used as independent variables for the design year, are of acceptable quality. The purpose of this paper is to present the application of error propagation theory in assesing the predictive quality of one type of travel demand forecasting model (multinomial logit models) and to demonstrate how error considerations can be used as a tool for identifying the optimal model. The general conclusions of this study are that: (1) it is indeed possible to quantify errors in dependent variables in logit models as a consequence of errors in independent variables; and (2) error consideration can be used as a tool for identifying the optimal model from a set of candidate models. Further research is recommended to develop better insights into the phenomenon of error propagation so that the consideration of errors can be a factor in decisions on model selection.     

The diffraction of plane gravitational waves by the edge of an ice cover

The diffraction of plane surface gravitational waves by the edge of an ice cover lying on the surface of an incompressible fluid of infinitely great depth is considered. The ice cover is simulated by a thin elastic plate. The wave reflection and transmission coefficients are determined when it interacts with the ice cover. A wave field is constructed in the fluid under the conditions that a periodic lumped force and a lumped moment act on the edge of the ice cover. It is shown that as the incident wavelength increases the reflection coefficient tends to zero and the transmission coefficient tends to unity.     

Two inequalities involving Hadamard products of positive semi-definite Hermitian matrices

We extend two inequalities involving Hadamard products of positive definite Hermitian matrices to positive semi-definite Hermitian matrices. Simultaneously, we also show the sufficient conditions for equalities to hold. Moreover, some other matrix inequalities are also obtained. Our results and methods are different from those which are obtained by S. Liu in [J. Math. Anal. Appl. 243:458–463(2000)] and B.-Y. Wang et al. in [Lin. Alg. Appl. 302–303: 163–172(1999)].     

Solitary waves and their bifurcations of KdV like equation with higher order nonlinearity

We investigate the KdV like equation with higher order nonlinearity ut + a(1 +bun)unux + uxxx = 0with n ≥ 1, a, b ∈ R and α≠ 0. The bifurcations and explicit expressions of solitary wave solutions for theequation are discussed by using the bifurcation method and qualitative theory of dynamical systems. Thebifurcation diagrams, existence and number of the solitary waves are given.     

Can Millimeter Waves Generate Electroporation?

Analysis of the field distributions in a single biological cell under electromagnetic wave is given. With Debye approximation, the dielectric relaxation of each part of the cell, including the extracellular and cellular media, the cell membrane and the nuclear membrane, was taken into account. Making use of some typical parameters for a cell, the voltage across nuclear and cytoplasma membranes under electromagnetic waves are calculated up to millimeter wave frequency range. The calculated result indicates that it is unlikely to generate electroporation by present available millimeter wave sources.     

拉曼放大器中放大的自发拉曼散射与拉曼开-关增益关系的研究

研究了拉曼放大器中放大的自发拉曼散射对拉曼开－关增益的影响，并提出了一种利用自发拉曼散射谱来调整拉曼放大器位曼开－关增益平坦的方法，实验采用4个波长为14xx nm的激光二极管作为抽运源，75km的G．652光纤作为传输介质，获得了C波段附近的光放大，同时对此给出了合理的理论解释。     

A comprehensive study of the long pulse Nd:YAG laser drilling of multi-layer carbon fibre composites

The results of an extensive experimental study of the free running Nd:YAG laser drilling of a multi-layer carbon fibre composite, where adjacent layers have differently orientated fibres, are reported. For holes drilled with the laser operating in fixed-Q mode at 1064 nm, parallel sections of blind holes illustrating discontinuities in the hole size along a given section direction will be shown to occur at the interface between adjacent layers. An explanation for this effect is proposed. Detailed single pulse drilling characteristics will be presented illustrating the exit hole diameter as a function of pulse energy and material thickness. These characteristics illustrate a ‘stable' drilling regime in which the exit hole diameters are least sensitive to changes in pulse energy or material thickness and a less ‘stable' regime in which they are more strongly dependent on these parameters. Drilling characteristics will be given for two different beam qualities, illustrating the greater drilling depth and reduced hole size achievable with an improved beam quality. Finally holes drilled through a 2 mm thick sample of material with multiple pulses are considered. Size distribution curves for entrance and exit holes will be presented. The total energy required (number of pulses × pulse energy) to drill through 2 mm thick material will be reported as a function of pulse energy in stationary air and argon atmospheres and in a partial vacuum, illustrating a threshold energy which is dependent upon the drilling atmosphere. The threshold energies will be discussed with reference to plasma formation and the reactivity of the drilling atmosphere.     

Correlations between dynamical properties and features of potential energy surfaces for the light atom transfer reactions O+HCl→OH+Cl AND Cl+HCl→ClH+Cl

A three-dimensional quasiclassical trajectory study of the dynamics of the light atom transfer reaction O(³P) + HCl(ν=0)→ OH + Cl was carried out employing two LEPS potential energy surfaces (I and II). Attention was focused mainly on three-dynamical properties; the oscillatory behavior of partial cross sections as a function of collision energy; the rotational excitation of the products; and the influence of reagent rotation on reactivity. Distinct differences were found between surfaces I and II with respect to these properties. The examination of individual trajectories indicated that there is a significant difference in the nature of these surfaces. While surface I is governed by weak repulsive forces, surface II is governed by strong attractive forces which tend to direct the reactants toward a collinear geometry. The present results confirm conclusions reached from an earlier study of the reaction Cl+HCl→ClH+Cl concerning correlations between dynamical properties and features of potential energy surfaces. For surfaces of the type that we termed HREP, since they are of repulsive nature and they lead to highly rotationally excited products, no significant oscillations of partial cross sections are obtained and reagent rotation promotes the reaction. On the other hand, for surfaces of the type that we termed COLD (collinearly directing), since they tend to direct the reactants toward a collinear geometry and form rotationally “cold” products, significant oscillations of partial cross sections are obtained and reagent rotation causes a decline in reactivity.