The Casimir effect of Reissner-NordstrSm black hole

The stress tensor of a massless scalar field satisfying a mixed boundary condition in a （1 ＋ 1）-dimensional Reissner- Nordstrom black hole background is calculated by using Wald＇s axiom. We find that Dirichlet stress tensor and Neumann stress tensor can be deduced by changing the coefficients of the stress tensor calculated under a mixed boundary condition. The stress tensors satisfying Dirichlet and Neumann boundary conditions are discussed. In addition, we also find that the stress tensor in conformal flat spacetime background differs from that in flat spacetime only by a constant.     

关于不含k-C-圈的n阶r-一致超图的若干结果

主要讨论了不含k-C-圈的n阶r-一致超图,对不同的k,分别得出了它的极大边数的一个下界,并且得出在有些情况下它的下界是最大的.另外,我们得到了Krn含k-C-圈的一个充分必要条件.     

拟南芥胚的不同区域对MeV离子辐照的响应

利用不同能量的质子在大气环境中辐照拟南芥的含水种子，能量从1.1MeV到6.5MeV.根据模拟计算结果，相应能量的离子对种子的损伤区域分别为胚的浅层、胚的一半和整个胚.本实验中，具有较高能量的质子可以完全均匀地作用于拟南芥生长、发育及遗传密切相关的胚茎端分生组织，而能量较低的质子则不能直接作用于茎端分生组织.实验所用质子注量范围为4×10⁹ions/cm²—1×10¹⁴ions/cm².实验结果显示，虽然拟南芥种子的发芽率和幼苗存活率随离子注量增加都呈现下降的趋势，但对应于不同的胚损伤区域，即在不同的入射质子能量条件下，注量曲线具有各自的特征.实验结果显示，拟南芥种子中除了胚茎端分生组织作为对离子辐照敏感的辐射主靶外，茎端分生组织之外的胚区域可能作为离子辐射次靶，影响到最终的辐射生物学效应. 关键词： 离子辐照 拟南芥 胚区域 生物效应     

中间层Re的加入对覆膜钡钨阴极性能的改善

研究了一种新型的覆膜钡钨阴极——双层膜(Os-W/Re膜)钡钨阴极.对这种新型阴极的发射性能进行了测试，重点对其老炼前后表面薄膜的微观形貌进行了分析，表明中间层Re膜的加入使覆膜钡钨阴极的性能得到了改善.通过对Os-W双元合金膜钡钨阴极和Os-W/Re双层膜钡钨阴极发射特性的比较，发现Os-W/Re双层膜阴极的直流发射性能好于Os-W合金膜阴极.对两种阴极激活后发射表面的X射线光电子能谱分析表明，Os-W/Re双层膜阴极激活后表面形成的三元合金膜是其发射特性优于Os-W合金膜阴极的主要原因.应用扫描电子显微镜分析比较两种阴极激活老炼后的表面状态，结果表明：Os-W合金膜阴极在老炼一段时间后，其表面薄膜出现开裂，这会导致阴极发射均匀性下降；而Os-W/Re双层膜阴极在同样老炼条件下，发射表面薄膜均匀并保持完整，从而确保覆膜钡钨阴极发射均匀性和工作可靠性. 关键词： 双层膜钡钨阴极 Os-W/Re膜 Os-W膜 薄膜开裂     

表面活性剂对均相沉淀法制备单晶Ce2O(CO3)2￠H2O微粉形貌及 形成机理的影响

在尿素及硝酸铈的混合溶液中分别加入表面活性剂CTAB、 PEG19000、OP-10,利用均相沉淀法合成了不同形貌的CeO2超细前驱体Ce2O(COa)2·H2O,采用X射线衍射及透射电子显微镜等测试手段,对产品的物相和形貌进行了表征．实验结果表明,所得产品均为斜方晶系的单晶Ce2O(CO3)2·H2O,且表面活性剂的加入使晶体的晶化程度明显提高;添加不同的表面活性剂得到不同形貌尺寸的产物: 阳离子型表面活性剂CTAB对Ce2O(CO3)2·H2O晶体的形貌影响不大,所得产物尺寸变小,且分散性得到一定的改善;非离子型表面活性剂对所得产物的形貌影响显著．加入PEG19000和OP-10分别得到了形状排列有序的、尺寸较均匀的、较规则无团聚的微米棒及具有紧密结合中心的发散状的花样微粒．不同形貌前驱体的形成与晶粒形成生长机理的改变有关．     

不同方法制备的CO2-3替换磷灰石固溶体晶体化学的FTIR研究

采用不同方法制备了CO2-3替换的磷灰石固溶体,利用FTIR结合XRD对其进行了晶体化学研究,结果表明均相沉淀法制备的碳羟磷灰石(CHAP)属B型替换且替换方式是[CO3·OH]四面体替换[PO4]四面体;固相离子交换法制备的CHAP属A型替换且替换方式是[CO3]三角形配位体替换通道位置的OH-;固相反应法制备的碳氟磷灰石(CFAP)属B型替换,其替换方式是[CO3·F]四面体替换[PO4]四面体;sol-gel法制备的CHAP属AB混合型替换,其Ψ3分裂为Ψ3-1,Ψ3F,Ψ3-4.高斯函数法拟合表明Ψ3F峰是A型替换的Ψ3-2与B型替换的Ψ3-3的叠合.当WCO2-3＜3.34%时,随CO2-3含量增加,A型替换量增大,且当WCO2-3=3.34%时达最大值,当3.34%＜WCO2-3＜7.52%时,随CO2-3含量增加,B型替换量增大,且当WCO2-3= 7.52%时亦到饱和.     

准二维无序系统的电子结构

对形如N_t×N_l型准二维无序系统，只考虑格点之间的最近邻跳跃积分，采用特殊的格点编号方案，在单电子近似下，系统的哈密顿量可表示为简明对称矩阵，借助豪斯荷尔德变换将其约化为对称三对角矩阵，再利用负本征值理论及传输矩阵等方法,对系统态密度、局域长度及电导等电子结构特性进行数值计算. 重点研究了准一维四平行链和五平行链无序系统， 将结果与一维单链、准一维双链及三链系统进行对比，发现随维度的增加，系统的能带有所展宽，能态密度分布发生很大的变化，其峰值数量呈偶数规律增加. 并且在能带中心处存在有局域长度大于系统大小的扩展态，处于这些态下的系统具有较大电导. 从单链到多链，相当于扩大了系统的关联范围，使系统出现了类似非对角长程关联的行为. 关键词： 准二维无序系统 态密度 局域长度 电导     

A solar radio moving type IV burst of expanding arches type involving multi-sources

A complex solar radio moving type IV burst was observed on 23 September 1998 with the broadband (1.0–2.0 GHz and 2.6–3.8 GHz) spectrometers with high temporal and spectral resolutions at National Astronomical Observatories of China (NAOC). Comparing to the high spatial resolution data of Siberian Solar Radio Telescope (SSRT), we find that this burst is a rare type of moving type IV burst which is caused by the expanding arches, and the spatial structure oscillations of the radio sources are related with the time structure pulsations of the radio emission. Furthermore, the burst is associated with the multiple quasi-periodic long-term pulsations, and this suggests the existence of multi-scale magnetic structures in a large expanding coronal arch. We think the moving type IV burst is due to the synchrotron emission of the energetic electrons trapped in the expanding arch, and the multiple quasi-periodic pulsations are due to the second harmonic plasma emission.     

Modelling for the planning and management of bed capacities in hospitals

The internal dynamics of a hospital represent a complex non-linear structure. Planning and management of bed capacities must be evaluated within an environment of uncertainty, variability and limited resources. A common approach is to plan and manage capacities based on simple deterministic spreadsheet calculations. This paper demonstrates that these calculations typically do not provide the appropriate information and result in underestimating true bed requirements. More sophisticated, flexible and necessarily detailed capacity models are needed. The development and use of such a simulation model is presented in this paper. The modelling work, in conjunction with a major UK NHS Trust, considers various types of patient flows, at the individual patient level, and resulting bed needs over time. The consequence of changes in capacity planning policies and management of existing capacities can be readily examined. The work has highlighted the need for evaluating hospital bed capacities in light of both bed occupancies and refused admission rates. The relationship between occupancy and refusals is complex and often overlooked by hospital managers.