氯化钠在球形纳米氧化铈形成过程中的作用

以水合碳酸铈为原料, 以氯化钠作为助磨剂和阻聚剂, 采用机械活化法制备了球形纳米氧化铈, 用XRD法研究了水合碳酸铈与氯化钠质量比、球磨时间、煅烧温度对CeO2粉体晶粒度的影响, 用TEM对最终产物粒子进行形貌观察. 结果表明: 在碳酸铈的球磨过程及其随后的煅烧过程中, 氯化钠的存在起到了很好的助磨和阻聚作用, 所得CeO2为类球形粒子, 分散性较好, 晶粒度约为30～50 nm.     

Preparation of solutions of amidomagnesium chlorides in poly(ethylene oxide) and their characterization by conductivity measurements

Polymer electrolyte systems were prepared for the first time by dissolution of amidomagnesium chlorides in poly(ethylene oxide), (PEO). For the preparation, solutions of (hexamethyldisilylamido)magnesium chloride, (dimethylpyrrolyl)magnesium chloride, (diisopropylamido)magnesium chloride, piperidinomagnesium chloride and morpholinomagnesium chloride were chosen. The composition of these polymer electrolyte systems corresponds to the general formula R₂NMgCl·P(EO)_n·THF. Most work has been done with the system (hexamethyldisilylamido)magnesium chloride in PEO, (Me₃Si)₂NMgCl·P(EO)_n·THF, with n= 3, 4, 5, or 7. The electrolytes have a soft rubber-like consistency. At 30 °C, electrical conductivities of 10⁻⁶–10⁻⁵ S/cm were found. The conductivities were measured in the temperature range 20–60 °C. Within this temperature range a linear dependence of the logarithms of the conductivity on the inverse temperature was found and activation energies for the conducting process of 30–60 kJ/mol were calculated. Using those polymer electrolytes with a high content of the amidomagnesium compound, a reversible magnesium deposition takes place by cathodic reduction at potentials below −1.9 V vs. a Ag/AgCl reference electrode. These polymer electrolytes were found to be stable against oxidation up to about −0.3 V vs. Ag/AgCl. Electronic Publication     

熔盐电解合成希土六硼化物的研究——REBO3、LiBO2和LiF体系熔盐电解合成RER6

本文在800℃和空气中电解REBO₃-LiBO₂-LiF熔盐体系合成了单相的REB₆.石墨川埚兼作容器和阳极.耐火金属棒如Cu和Mo等被悬吊在电解质中作为阴极.根据似二元体系LiBO₂-LiF和LiBO₂-LaBO₃的低熔点组成以La₂O₃、B₂O₃、Li₂CO₃和LiF为原料找到了具有较低熔点的熔盐体系.根据X射线粉末衍射,该熔体是由REBO₃、LiBO₂和LiF三个物相组成.     

溶出伏安法同时测定水中痕量铀和镍

本文报道了同时测定钴和镍的一种方法.在 0.01mol/L NH_3·H_2O-0.01mol/LNH_4Cl-3.0×10~(-5)mol/L安息香缩氨基硫脲(BTSC)溶液中,钴(Ⅱ)和镍(Ⅱ)均产生非常灵敏的还原波,其峰电位分别是:-0.94和-0.75V(vs.SCE),峰电流与钴和镍的浓度分别在2.0×10~(-8)~1.0×10~(-6)和1.0×10~(-8)~8.0×10~(-7)mol/L范围内成直线关系,该方法用于测定水中痕量钴和镍,相对标准偏差分别为1.4~2.0%和2.1~2.5%,回收率分别在98.0%~101.8%和97.9%~102.1%之间.     

A novel three-component reaction for the synthesis of new 4-azafluorenone derivatives

Reaction of arylidenemalononitriles, 1,3-indanedione, and mercaptoacetic acid or 4-methylbenzenethiol is successfully carried out using microwave heating. It is an efficient and promising synthetic strategy to build the indenopyridine skeleton.     

镧对镉胁迫下豌豆幼苗根部细胞内离子平衡及膜质子泵的影响

以水培豌豆(PisumsativumL)幼苗为材料,研究了La3+对Cd2+胁迫下豌豆幼苗生长、叶部与根部细胞对Cd2+的吸收、根部细胞内无机离子平衡体系及膜H+-ATPase,H+-PPase活性的影响。结果表明:Cd2+胁迫下喷施适宜浓度的La3+(0.50mg·L-1)可使豌豆幼苗相对生物量、苗长、叶绿素含量以及光合速率受到的毒害明显缓解,有效减少叶部与根部细胞对Cd2+的吸收,显著减轻了Cd2+胁迫导致的离子平衡系统的紊乱,明显缓解Cd2+对质膜及液泡膜H+-ATPase,H+-PPase活性的抑制作用。10mg·L-1Cd2+胁迫下La3+的保护效应比30mg·L-1Cd2+胁迫下更为显著。样品中La3+的测定和分析结果还表明,外源La3+处理后,La3+主要结合于细胞膜外,进入原生质体的仅占很小部分,但30mg·L-1Cd2+处理样品中La3+进入细胞的量则明显多于10mg·L-1Cd2+处理的样品。     

Amperometric biosensor for ethanol based on immobilization of alcohol dehydrogenase on a nickel hexacyanoferrate modified microband gold electrode

Alcohol dehydrogenase (ADH) has been immobilized on a nickel hexacyanoferrate modified microband gold electrode surface by a glutaraldehyde/bovine serum albumin (BSA) cross-linking procedure to provide a new amperometric sensor for the assay of ethanol. The resulting enzyme electrode exhibits excellent electrocatalysis for the oxidation of reduced nicotinamide-adenine dinucleotide (NADH). The amperometric determination is based on the electrochemical detection of NADH which is generated in the enzymatic reaction of ethanol with NAD(+) under catalysis of ADH. The influence of various experimental conditions was examined for the determination of the optimum analytical performance. The sensor responds rapidly to ethanol with a detection limit of (5.0 +/- 0.3) x 10(-7) mol 1(-1). The response current increases linearly with ethanol concentration up to 5 mmol 1(-1). The sensor remains relatively stable for about 1 week.     

Mixed micellization of an anionic gemini surfactant (GA) with conventional polyethoxylated nonionic surfactants in brine solution at pH 5 and 298 K

The micellization behavior of an anionic gemini surfactant, GA with nonionic surfactants C₁₂E₈ and C₁₂E₅ in presence of 0.1 M NaCl at 298 K temperature, has been studied tensiometrically in pure and mixed states, and the related physicochemical parameters (cmc, γ _cmc, pC ₂₀, Γ _max, and A _min) have been evaluated. Tensiometric profile (γ vs log [surfactant]), for conventional surfactants, generally consists of a single point of intersection; a gradually decreasing line (normally linear, or with slight curvature) ultimately saturates in γ at a particular [surfactant], corresponding to complete monolayer saturation. The gemini, in this report, led to two unequivocal breaks in the tensiometric isotherm. An attempt to the interpretation of the two breaks from molecular point of view is provided, depending solely on the chemical structure of the surfactant. The gemini, even in mixed state with the conventional nonionic surfactants C₁₂E₅ and C₁₂E₈, manifested the dual breaks; of course, the dominance of the feature decreases with increasing mole fraction of the nonionics in the mixture. Theories of Clint, Rosen, Rubingh, Motomura, Georgiev, Maeda, and Nagarajan have been used to determine the interaction between surfactants at the interface and micellar state of aggregation, the composition of the aggregates, the theoretical cmc in pure and mixed states, and the structural parameters according to Tanford and Israelachvili. Several thermodynamic parameters have also been predicted from those theories.     

Thermal degradation behaviors of some branched and linear polysiloxanes

The thermal degradation behaviors of some branched and linear polysiloxanes were studied by thermogravimetric (TG) analysis and infrared (IR) spectroscopy, and the effect of phenyl content on the thermal stability of the tested branched polysiloxanes was investigated. The branched polysiloxanes with phenyl obtain higher thermal stability at lower temperature. The degradation residues of the examined branched polysiloxanes at 800 °C are rather high, 65.1-77.6% in N₂ and 40.5-66.5% in air, respectively. However, the amount of solid residue increases with decrease in phenyl content in both N₂ and air atmospheres. It was found that the thermal stability of the branched polysiloxanes is higher than that of the linear one, which indicated that the branched structure benefits the formation of a crosslink in the solid residue.     

Study on synthesis of two-armed polymers containing a crown ether core and their self-assembly behaviors in selective solvents

A series of well-defined two-armed polymers containing a crown ether core, poly(stearyl methacrylate)-crown ether-poly(stearyl methacrylate) (PSMA-crown-PSMA), with different molecular weight were synthesized via atom transfer radical polymerization (ATRP). The resultant polymers were characterized by ¹H NMR and GPC. The self-assembly behaviors of this kind of polymer in selective solvents were studied by TEM, and it was found that polymers with different molecular weight can directly self-assemble into hollow spheres, solid spheres and a monolayer film with regular pores by varying molecular weight and water content. The possible molecular packing motels for their self-assembly behaviors were proposed.