A 24-GHz Patch Array with a Power Amplifier/Low-Noise Amplifier MMIC

This paper presents an active patch array designed at 24 GHz. It can be used as a front-end component for a phased array. A series resonant array structure is chosen which is compact and easy excite. With 5 elements, the array proved a 12-dB antenna gain. A power amplifier and a low noise amplifier are designed on a single GaAs chip (PALNA). Bias switch is used in the PALNA, which greatly reduces the switch loss in a transceiver and increases the efficiency. 20-dB small signal gain is achieved in both power amplifier and low noise amplifier. The active patch array is built by the combination of the patch array and PALNA. The measured active gain of this antenna is 35-dB for the PA mode and 31-dB for the LNA mode. This active patch array can obtain an EIRP of 34 dBm with a total radiated power of 22dBm and a maximum PAE of 32%. To check the noise performance, we applied sources at both normal temperature and 77K (liquid nitrogen) and extracted the noise figure (3.5 dB) of the active antenna by the Y factor method. The results proved that the active antenna is working efficiently as both a transmitting and receiving antenna.     

具有两亲性质的异环酰基－3－二茂铁基－2－丁烯酸酯衍生物的合成

３－二茂铁基－２－丁烯酸乙酯与８种不同类型的酰氯反应，合成了８种具有两亲结构的α，β－不饱和酯二茂铁双取代新衍生物。同时，发现一种新的酰化反应现象，即３－二茂铁基－２－丁烯酸乙酯与２－丁烯酰氯或肉桂酰氯反应时，酰化反应既能在茂环上又能在α，β－不饱和酯基的烯键上发生，得到另两种新化合物。测得了上述１０种化合物的１ＨＮＭＲ谱、ＩＲ光谱及元素分析数据。     

Trace determination of Tl, Cu, Pb, Cd, and Zn in specimens of the limnic environment using isotope dilution mass spectrometry with thermal ionization

Within the framework of the German Environmental Specimen Bank program, Tl, Cu, Pb, Cd and Zn were determined in homogenized materials from the limnic environment using Isotope Dilution Mass Spectrometry (IDMS) with thermal ionization. The analytical procedures which were developed for the trace metal analysis of bioindicator and sediment samples are described in detail. Results obtained in bream, mussels (Dreissena polymorpha) and sediments of Lake Constance/Estuary of Constance in the sampling years 1981, 1985, 1988, 1990, 1992 and 1993 are discussed and compared with those of bream from the lakeland district of Born-hoeved/Lake Belau and from the River Saar as well as from reference materials.     

Model calculations of interface segregation in dilute systems

Using a discrete model for the segregation kinetics based on the Darken theory of diffusion and on the regular solution model (RSM), one and two dimensional simulations of interface segregation in binary and ternary systems have been performed. The aim of the calculations was to investigate the kinetics of segregation sequences in ternary systems, the segregation kinetics in discrete systems during the initial phase and finally the kinetics of surface segregation in the region of a grain boundary intersected by the surface.     

Strategies for the development of a voltammetric sensor for the determination of hydrogen peroxide at high concentrations

Different strategies are presented for the development of a voltammetric sensor for in-line measurement and monitoring of H₂O₂ in high concentrations (up to 30 g/l) as used in textile bleaching systems. When using macroelectrodes, signal saturation is observed even at medium concentrations. Some improvement can be achieved by hydrodynamic electrodes like ring-disk electrodes. Satisfactory results up to the desired level in practical solutions (possessing only limited conductivity) are obtained with Pt-microelectrodes.     

HPLC with amperometric detection for the determination of pesticides of high polarity

A relatively simple procedure is described for the selective and highly sensitive determination of amitrole (3-amino-1,2,4-triazole) by ionpair HPLC with amperometric detection. The separation was achieved on a polar CN-column using hexane, propanol, water (62:36:2) with LiClO₄ (2.5 g·l^–1) and trichloroacetic acid (2 g·l^–1) as electrolytes. The determination range lies between 500 pg and 500 ng and the limit of detection was found to be 200 pg (s.d.: 11%; N=9). The minimum detectability for the alternative UV-monitoring was 2.5 ng. The developed method may be helpful in production and quality control and for the selective determination of amitrole in commercial formulations.     

Resonance ionization spectroscopy for trace analysis and fundamental research

Resonance ionization spectroscopy (RIS) and its combination with mass spectrometry (RIMS) have grown to become powerful techniques, which offer high sensitivity as well as elemental and isotopic selectivity. The principles of RIS and RIMS are introduced; they primarily concern the analysis of the optical spectra for the choice of efficient excitation schemes and the suitable design of the experimental apparatus. Recent applications span from studies of short-lived isotopes at on-line mass separators to a wide variety of trace analysis applications for radioactive isotopes, which can range from measurements of solar neutrino flux to environmental assessment.On leave from Pacific Northwest Laboratory, Richland, USA