超稳Y沸石制备技术对沸石铝分布的影响 Ⅱ.均匀铝分布的超稳Y沸石的制备

对水热处理后得到的USY沸石作进一步的酸处理以及采用改进的氟硅酸盐溶液骨架富硅工艺,分别得到了经XPS剖面分析证实为铝分布均匀的超稳Y沸石HAY-Ⅰ和HAY-Ⅱ。IR分析表明,在酸处理过程中从USY沸石中去掉的那部分非骨架铝类与3690cm~(-1)处羟基有关,仍残留在HAY-Ⅰ沸石中的那部分非骨架铝类与3670cm~(-1)和3600cm~(-1)处羟基有关。XRD和化学分析表明HAY-Ⅰ沸石仍含有约50％的非骨架铝类,而HAY-Ⅱ沸石则基本上不含非骨架铝类,HAY-Ⅱ沸石还显示更高的结晶保留度。DTA分析表明,HAY-Ⅰ和HAY-Ⅱ两种沸石的热稳定性均高于USY沸石。     

Sensitive monitoring of humic acid in various aquatic environments with acidic cerium chemiluminescence detection.

In this research, a simple, sensitive chemiluminescence (CL) method for the determination of humic acid (HA) in water samples was first developed based on the redox reaction between humic acid and cerium(IV) in the acidic condition. Different with the former redox CL reaction which occurred in alkaline solution, no enhancers were needed and neither precipitation nor a second contamination would occur in the present CL system. Comparing with other spectrometric methods, we find that the proposed analysis system had better applicability and accuracy. Under the optimal experiment conditions, the CL peak height was linear with the concentration of HA in the range of 0.03 to 10.0 microg mL(-1). The detection limit is 0.01 microg mL(-1) (S/N = 3), and the relative standard deviation was 2.3% for 0.5 microg mL(-1) HA solution with eleven repeated measurements. The present CL method was successfully applied to the determination of HA in tap water, spring water and river water samples with good recovery from 90.0 to 110.0%. A possible CL mechanism was proposed based on the results of UV and fluorescence spectrometry and the CL spectrum of HA. It was speculated that the semi-quinone radicals in the excited state were the emitters.     

Anchoring Properties of Nematic Liquid Crystals Studied Using the Attenuated Total Reflection Method

By using the attenuated total reflection method associated with the excitation of surface plasmons, the tilt angle of the liquid crystal director and its gradient at the surface are measured in a planar nematic cell as a function of the applied voltage. The surface anchoring anisotropy δπ of the liquid crystal and the surface elastic constant k_s, are found to be δπ = 0.288 erg/cm and k_s, = 9·12 × 10^-11 erg, respectively, when the boundary condition suggested by Barbero et al is used. The theoretical and experimental values obtained with this boundary condition and that of Mada are discussed. The results show that the boundary condition proposed by Barbero et al is in better agreement with the experiment.     

Liquid crystalline hexa-amides and side chain polysiloxanes of azacrown [18]-N6

The hexa-4-dodecyloxybenzoyl derivative 1 of azacrown [18]-N₆ was originally reported to have a 'tubular' mesophase on the basis of its large central ring and 6-fold symmetry. Starting in the mesophase, annealing of 1 under a cover slip results in formation of a new crystalline phase that melts directly to an isotropic liquid at the temperature previously observed for the mesophase to isotropic transition. Thus the phase behaviour of 1 is kinetically controlled. The analogous hexa-3,4-bisdodecyloxybenzoyl derivative 2 of azacrown [18]-N₆ has no kinetic limitations to its phase changes and has an enantiotropic columnar liquid crystalline phase. We have synthesized side chain copolysiloxanes with a (CH₂)₁₁ spacer and 75-84 per cent by weight of the same 4-dodecyloxybenzoyl-[18]-N₆ mesogen. The polysiloxanes also display a liquid crystalline phase.     

Analysis of Paeoniae Radix by high-performance liquid chromatography-electrospray ionization-mass spectrometry.

A method has been developed for the qualitative analysis of paeonol, paeoniflorin and their derivatives in Paeoniae Radix by high-performance liquid chromatography-electrospray ionization-mass spectrometry (HPLC-ESI-MS). Gradient elution with acetonitrile-water solvent system was employed in an HPLC-ESI-MS study. The negative-ion ESI mode was suitable for these compounds. The peaks were identified by their mass spectra, UV spectra and fragments of their MS2 spectra. The structures of three unknown compounds are inferred in this paper.     

Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

Synthesis of some chiral liquid crystals and study of the effect of intramolecular hydrogen bonding on the phase behaviour

The synthesis of three new series of chiral Schiff's bases containing benzilideneaniline and 2-hydroxybenzilideneaniline moieties as mesogenic cores is presented. Differential scanning calorimetry, optical polarizing microscopy and X-ray diffraction measurements were used to study the phase transition temperatures and behaviour. The results reveal that most of these materials show chiral smectic mesomorphism.     

Synthesis of optically active poly(N‐propargylsulfamides) with helical conformation

A novel chiral N‐propargylsulfamide monomer ( 1a ) and its enantiomer ( 1b ) were synthesized and polymerized with (nbd)Rh⁺B^?(C₆H₅)₄ as a catalyst providing poly(1) (poly( 1a ) and poly( 1b )) in high yields (≥99%). Poly(1) could take stable helices in less polar solvents (chloroform and THF), demonstrated by strong circular dichroism signals and UV–vis absorption peaks at about 415 nm and the large specific rotations; but in more polar solvents including DMF and DMSO, poly(1) failed to form helix. Quantitative evaluation with anisotropy factor showed that the helical screw sense had a relatively high thermal stability. These results together with the IR spectra measured in solvents showed that hydrogen bonding between the neighboring sulfamide groups is one of the main driving forces for poly(1) to adopt stable helices. In addition, copolymerization of monomer 1a and monomer 2 was conducted, the solubility of poly(1) was improved drastically. However, the copolymerization had adverse effects on the formation of stable helices in the copolymers. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 500–508, 2007     

Synthesis and application as polymer electrolyte of hyperbranched polyether made by cationic ring‐opening polymerization of 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxymethyl}‐3′‐methyl‐oxetane

A novel cyclic ether monomer 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxy‐methyl}‐3′‐methyloxetane (HEMO) was prepared from the reaction of 3‐hydroxymethyl‐3′‐methyloxetane tosylate with triethylene glycol. The corresponding hyperbranched polyether (PHEMO) was synthesized using BF₃·Et₂O as initiator through cationic ring‐opening polymerization. The evidence from ¹H and ¹³C NMR analyses revealed that the hyperbranched structure is constructed by the competition between two chain propagation mechanisms, i.e. active chain end and activated monomer mechanism. The terminal structure of PHEMO with a cyclic fragment was definitely detected by MALDI‐TOF measurement. A DSC test implied that the resulting polyether has excellent segment motion performance potentially beneficial for the ion transport of polymer electrolytes. Moreover, a TGA assay showed that this hyperbranched polymer possesses high thermostability as compared to its liquid counterpart. The ion conductivity was measured to reach 5.6 × 10^?5 S/cm at room temperature and 6.3 × 10^?4 S/cm at 80 °C after doped with LiTFSI at a ratio of Li:O = 0.05, presenting the promise to meet the practical requirement of lithium ion batteries for polymer electrolytes. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3650–3665, 2006