SYNTHESIS OF LIGHT OLEFINS FROM SYNGAS VIA DIMETHYLETHR——A NEW TECHNIQUE PROCESS

A new route named as SDTO method for the synthesis of lightolefins from syngas has been proposed.That is to convert syngas todimethylether and then to convert dimethylether to light olefins.The catalystsfor the two conversion reactions have been developed.For the first reaction,the catulySt was synthesized by the combination of methanol synthesis catalystwith γ-Al_2O_3or zeolites which possesses both metallic and acidic functions.Thecatalyst for the second reaction was modified SAPO-34 molecular sieve.Thevariables of the reactions have also been investigated.The results from theserial connection of the two conversion steps without any separation show thatthe yield of C_2~-C_4~- olefins Could be>100g/(m~3 syngas).     

Protein Conformation of a Lattice Model Using Tabu Search

We apply tabu search techniques to the problem of determining the optimal configuration of a chain of protein sequences on a cubic lattice. The problem under study is difficult to solve because of the large number of possible conformations and enormous amount of computations required. Tabu search is an iterative heuristic procedure which has been shown to be a remarkably effective method for solving combinatorial optimization problems. In this paper, an algorithm is designed for the cubic lattice model using tabu search. The algorithm has been tested on a chain of 27 monomers. Computational results show that our method outperforms previously reported approaches for the same model.     

服装主观热感觉的统计分析

本文用多因子方差分析模型和多重比较分析了服装穿着时的主观热感觉与服装品种、环境条件、穿着者的活动状态与籍贯之间的关系。通过主成分回归建立了用生理指标预测主观热感觉的模型，从而得出一种定量地评价服装属性的方法。     

红外光谱中溶剂效应机理初探——配位机制的提出

本文就红外光谱中溶剂效应机理提出了溶质和溶剂分子间的瞬时配位作用机制，认为同－溶质在不同溶剂中的振动波数不同，是由于这种瞬时配位作用改变了溶质价电子运动状态所致。据此提出了溶剂效砂的定量关系式，测定了七种溶剂配位效应常数。用这一套经验参数处理了几种取代苯甲酸的羰基伸缩振动的溶剂效应，得较好的线性关系。还发现羰基的振动波数与取代基的Ｈａｍｍｅｔｔ常数σ之间，羰基伸缩振动对溶剂效应的敏感度与σ之间，Ｈ     

光纤机敏结构制作方法的研究

本文讨论机敏结构的制作方法、集成光纤传感器存在的问题、现有解决方法和今后的研究方向。     

Hybrid organosilazane/organosilylamine telechelic oligomers—I. Two-dimensional NMR spectroscopy characterization of dimethylsilylethylenediamine oligomers

The detailed characterization of multifunctional hybrid organosilazane/organosilylamine telechelic oligomers by IR and ¹H, ¹³C and ²⁹Si NMR spectroscopy in one and two dimenions has been undertaken. The specific multifunctional oligomers, comprising NH/NH₂ or SiCl functionalities depending on the monomer feed-ratio, were prepared from mono- and di-functionally reacted dichlorodimethylsilane (DDS) and mono-, di-, tri- and tetra-functionally reacted ethylenediamine (EDA). Varying the feed-ratio afforded control of the microstructures of the oligomers and the preparation of oligomers with, in some cases, conterminously located silicon–chlorine (SiCl) groups. The combination of the NMR methods with the IR technique has enabled the detailed microstructural characterization of the oligomers and the identification of the functionalities therein. This approach and the knowledge gained from the DDS/EDA system has been applied to the microstructural characterization of other hybrid organosilazane/silylamine preceramic telechelic oligomers.     

金属表面生成氧化膜在电解质中的电位

测量金属表面生成氧化膜在电解质中的电位时,金属/氧化膜/电解质/参比电极构成了多电极体系,其中包括3个电池,由3个电池之间的关系、电池过程中所有的电化学反应、电荷传输步骤和化学反应步骤,导出电位的普遍适用的公式: E=E_a⁰+sum from s=1 to 3|η_t,s|-1/(ne)v₇ΔG₇, E=E_c⁰-sum from s=4 to 6|η_t,s|+1/(ne)v₈ΔG₈.当金属/氧化膜/电解质电池受到不同的步骤控制时,可以得到不同的简化公式.     

超稳Y沸石制备技术对沸石铝分布的影响 Ⅱ.均匀铝分布的超稳Y沸石的制备

对水热处理后得到的USY沸石作进一步的酸处理以及采用改进的氟硅酸盐溶液骨架富硅工艺,分别得到了经XPS剖面分析证实为铝分布均匀的超稳Y沸石HAY-Ⅰ和HAY-Ⅱ。IR分析表明,在酸处理过程中从USY沸石中去掉的那部分非骨架铝类与3690cm~(-1)处羟基有关,仍残留在HAY-Ⅰ沸石中的那部分非骨架铝类与3670cm~(-1)和3600cm~(-1)处羟基有关。XRD和化学分析表明HAY-Ⅰ沸石仍含有约50％的非骨架铝类,而HAY-Ⅱ沸石则基本上不含非骨架铝类,HAY-Ⅱ沸石还显示更高的结晶保留度。DTA分析表明,HAY-Ⅰ和HAY-Ⅱ两种沸石的热稳定性均高于USY沸石。     

纳米硅薄膜光吸收谱的研究

用恒定光电导法测量了纳米硅(其晶粒尺寸为3-5nm,晶态成分比X_c为45％—50％)薄膜在0.9—2.5eV范围的光吸收谱。分析了在不同光子能量范围可能存在的对光电导作主要贡献的几种光跃迁过程,以及随着X_c的增加,材料由非晶、微晶转变为纳米硅薄膜时光吸收谱的变化。发现纳米硅晶粒之间的界面区(平均厚度约为1nm)中载流子的跃迁及传输过程对整个范围的光吸收谱起主导作用。联系纳米硅的这种特殊结构解释了有关实验结果。 关键词：     

Interfacial effects on stress distribution in model composites

Raman mechanical spectroscopy was used to examine interfacial effects on the stress distribution in model polydiacetylene fiber/epoxy composites. Epoxy release agents were coated on fiber surfaces to modify the interfacial adhesion properties. The modified fiber surfaces were then characterized by scanning electron microscopy and x-ray photoelectron spectroscopy as well as optical microscopy. No difference in the maximum stress value or stress distribution was observed for the two types of fibers, coated or uncoated, used in composites. This suggests that adhesion properties at the composite interface do not affect tensile stress transfer efficiency nor, therefore, the composite tensile modulus along the fiber axis direction in uniaxial composites. Experimental data were also compared with theoretical calculations assuming perfect bonding between fiber and matrix, and idealized frictional force transfer mechanism at the fiber–matrix interface.