Effect of biaxial strain and hydrostatic pressure on the magnetic properties of bilayer CrI3

Two-dimensional van der Waals magnetic materials are intriguing for applications in the future spintronics devices, so it is crucial to explore strategy to control the magnetic properties. Here, we carried out first-principles calculations and Monte Carlo simulations to investigate the effect of biaxial strain and hydrostatic pressure on the magnetic properties of the bilayer CrI₃. We found that the magnetic anisotropy, intralayer and interlayer exchange interactions, and Curie temperature can be tuned by biaxial strain and hydrostatic pressure. Large compressive biaxial strain may induce a ferromagneticto-antiferromagnetic transition of both CrI₃ layers. The hydrostatic pressure could enhance the intralayer exchange interaction significantly and hence largely boost the Curie temperature. The effect of the biaxial strain and hydrostatic pressure revealed in the bilayer CrI₃ may be generalized to other two-dimensional magnetic materials.     

L波段高功率线极化径向线阵列天线理论分析与数值模拟

 探索了L波段的高功率线极化径向线阵列天线。基于三角形栅格形式实现了径向线圆形平面阵列天线,分析并给出了径向线并联馈电网络,并以同轴馈电的水平单圆环线极化天线为基础,利用径向线并联馈电网络设计出了间距小于一个波长下L波段高功率线极化径向线阵列天线。研究结果表明：这种结构实现径向线阵列天线的线极化辐射是可行的,该天线在中心频率1.57 GHz下,增益为19.97 dBi,轴比为-52.06 dB,反射系数为0.105 2;在1.37～1.77 GHz的频率范围内增益大于18.64 dBi,轴向轴比值小于-46.45 dB。     

Improvement of the Performance of an Acousto-Optical Q-Switched Nd:YAG 946 nm Laser Using a Convex–Plane Cavity

We improve the performance of an acousto-optical Q-switched Nd:YAG 946 nm laser using a convex–plane cavity. We obtain the highest output average power of 2.3 W with a pulse width of 15.3 ns in a 10 kHz 946 nm laser with a convex–plane cavity. The maximum peak power 15.0 kW is about three times higher than that in a plane–plane cavity. Also we investigate the output performances of the pulsed 946 nm laser with the convex–plane cavity at 20 and 50 kHz.     

基于双目立体视觉实现物体三维测量的研究

以双目立体视觉理论为基础,提取立体图像的Harris角点作为特征点,经过基于小波变换的子线段匹配方法,采用由粗到细的匹配策略匹配端点,盒滤波技术加速法,解决了匹配准确度和匹配速度之间的平衡问题.采用该方法对水泥冷却机内熟料进行测量,实验表明该方法能够较精确的对物体实现三维测量.     

大模场面积光子晶体光纤激光器展宽脉冲锁模域的束缚态运转

实验研究了大模面积光子晶体光纤飞秒激光器在近零色散点展宽脉冲锁模的束缚态运转.获得了双脉冲束缚态锁模,以及脉冲间隔不相等的多脉冲束缚态锁模,实验发现束缚态的子脉冲间距具有随机性.通过建立光纤锁模激光器的数值模型,分析了激光器束缚态锁模建立的动力学过程,在一定抽运强度下,激光器存在多个稳态,或者单脉冲运转,或者子脉冲间隔不相等的束缚态运转,这取决于锁模建立阶段半导体可饱和吸收镜(SESAM)对噪声信号的随机提取.并提出了抑制束缚态的方法,模拟得出此项技术可直接获得的最大单脉冲能量为19.6 nJ,考虑到40%左右的压缩损耗,可得到压缩至76 fs的最短脉冲,单脉冲能量为11.8 nJ.数值模拟结果能很好的与实验相符合.     

Development of Sn2+-based oxyfluoride photocatalyst with visible light response of ca.650 nm via strengthened hybridization of Sn 5s and 02p orbitals

The hybridization between the outmost s orbitals of metal (Bi3+,Sn2+,Pb2+,Ag+) and O 2p orbitals has been widely employed to develop innovative semiconductors w...     

高效液相色谱法同时测定生物质乳酸发酵液中有机酸及糖类化合物

建立了高效液相色谱(HPLC)同时测定生物质乳酸发酵液中有机酸及糖类的分析方法。使用Bio-Rad Aminex HPX-87H色谱柱,以5 mmol/L的H2SO4为流动相,在柱温55 ℃,流速0.6 mL/min条件下,采用示差折光检测器进行检测。结果表明,该方法可在17 min内实现发酵液中各种有机酸和糖类化合物等的完全分离与定量,6种有机酸和3种糖类化合物在0.15～5.19 g/L范围内的线性关系良好,回归方程的线性相关系数在0.9998以上。将该法用于米根霉发酵液的检测,两个水平的加标回收率为96.91%～103.11%,相对标准偏差(n=6)为0.81%～4.61%。该法适用于微生物发酵液中多种有机酸和糖类的快速、高效分离和定量测定。     

Coral reef-like polyanaline nanotubes prepared by a reactive template of manganese oxide for supercapacitor electrode

Coral reef-like PANI nanotubes composed of nanopaticles were successfully synthesized by a reactive template of manganese oxide.The structure was characterized by using SEM,TEM,and FT-IR,and the supercapacitive behaviors of these nanotubes were investigated with cyclic voltammetry（CV）,and charge-discharge tests,respectively.A maximum specific capacitance of 533 F/g could be achieved in 1mol/L aqueous H₂SO₄ with the potential range of -0.2 to 0.8 V（vs.the saturated calomel electrode） in a half-cell setup configuration for PANI electrode,suggesting its potential application in the electrode material for electrochemical capacitors.     

An efficient approach for total synthesis of aminopropyl functionalized ganglioside GM1b

A highly efficient protocol for the synthesis of aminopropyl functionalized ganglioside GM1b has been described. The full protected ganglioside GM1b was obtained in 71% yield within 5 h. The key feature of the synthetic approach was the use of sialic acid donor that was with a C-5 trichloroacetamide moiety and with a dibenzyl phosphite residue as leaving group at the anomeric carbon. The sialyl donor gave high yields and excellent α-anomeric selectivities with a wide variety of glycosyl acceptors ranging from C-3 or C-6 hydroxyls of galactoside to C-6 hydroxyl of glucosaminoside by using TMSOTf as catalyst in a mixture solution of acetonitrile and methylene chloride.