反相乳液聚合制备壳聚糖接枝共聚物及应用

以壳聚糖、丙烯酰胺、甲基丙烯酰氧乙基三甲基氯化铵为原料,硝酸铈铵为引发剂,Span-20为乳化剂,通过反相乳液聚合技术,合成壳聚糖阳离子接枝共聚物。分析讨论了乳化剂用量、引发剂浓度、油水体积比、单体配比、反应时间、反应温度对共聚物接枝率的影响,并采用正交试验方法对合成条件进行了优化。研究了其对重金属离子Cu2 、Cd2 、Zn2 的吸附性能。结果表明,在Cu2 、Cd2 、Zn2 的混合离子体系中,该共聚物对Cu2 、Zn2 有选择性吸附。     

非线型缩聚物的重均分子量

本文用数学期望方法研究了非线型共缩聚物的重均分子量,并推导出重均分子量表达式,将3种特例的理论曲线与实验结果相比较,两者基本相符。     

锂离子电池正极材料LiMn2O4的合成与晶体结构（英）

Spinel LiMn₂O₄ powders were prepared using two-step synthesis method consisting of solid-state reaction method and citrate modified sol-gel method. The effects of the calcination temperature and the Li/Mn ratio of raw materials were studied on the physicochemical and electrochemical properties of the spinel LiMn₂O₄ powders, such as crystallinity, lattice constant and density. The title compound was characterized by powder X-ray diffraction (XRD), scanning electron microscopy (SEM) and transmission electron microscopy (TEM). Polycrystalline LiMn₂O₄ powers calcined at 750 ℃ were found to be composed of very uniformly-sized microcrystal with an average particle size of 300 nm. The improvement in electrochemical properties was mainly attributed to the process of re-grinding by absolute alcohol.     

微波辐照下无皂阳离子聚(St-MMA)高分子纳米粒子的制备和表征

讨论了微波辐照下 ,以丙酮 水为分散介质 ,利用阳离子型自由基引发剂偶氮二异丁基脒盐酸盐(AIBA)引发苯乙烯 (St)和甲基丙烯酸甲酯 (MMA)共聚 ,合成出表面带正电荷的P(St MMA)共聚物纳米粒子 ,考察了丙酮用量、单体和引发剂浓度对纳米粒子粒径、粒径分布和乳液稳定性的影响 .结果表明 ,丙酮 水的体积比由 0增加到 1 2 6∶1时 ,粒子的平均水化半径从 12 2 2 1nm降低到 2 4 6 8nm ,粒径分布变宽 ,乳液抗电解质稳定性逐渐增强 ;增加引发剂和共聚单体MMA的浓度 ,粒子的水化半径逐渐减小 ,粒径分散系数增大 .     

煤气部分返回炼焦过程焦炭脱硫

将半焦中的硫区分为无机硫和有机硫，在不同气氛和温度下进行脱硫实验；计算煤气返回对焦炉温度的影响和模拟炼焦过程返回煤气在炭化室的分布。结果表明：增加氢气浓度对有机硫和无机硫的脱除都有利，但是温度升高并不总是有利于脱硫；氢气脱硫效果要好于甲烷和一氧化碳；指出了炼焦后期在焦炉煤气返回之前预热煤气可以减少对炉温的影响，但是煤气的预热温度不能太高，否则甲烷裂解容易堵塞管道；煤气的最佳返回时机是在焦炭中孔隙分布较为均匀之时。     

新型树状大分子核醚-四硅烷的合成

以季戊四醇为原料合成了一种新型树状大分子核--醚-四硅烷,可用于树状大分子构筑.通过季戊四醇(1)与溴丙烯的醚化反应得到四烯丙基醚2,然后在Pt催化作用下,2与硅氯仿通过硅氢化反应生成醚-四(三氯硅烷) 3(可直接与多种官能团反应生成树状大分子),3经过LiAlH4还原后得到目标产物醚-四硅烷4.通过IR, 1H NMR, 13C NMR对中间体和目标产物的结构进行了表征,并对产物的结构进行了讨论和确认.     

有机相中α-氰基-3-苯氧基苄醇乙酯的酶促醇解反应

研究了有机相中脂肪酶催化α-氰基-3-苯氧基苄醇乙酯的醇解化反应。制备α -氰基-3-苯氧基苄醇。考察了酶、溶剂、醇、醇用量、溶剂水含量以及底物浓度等 因素对反应的影响，结果表明Novozym435脂肪酶催化活性最高，经实验确定的最佳 条件为：脱水甲苯为溶剂，正辛醇为酰基受体，正辛醇、酯的摩尔比为1.5:1，酶 量为8 mg/mL时的最佳底物浓度为108.13 mmol/L，在上述条件下反应30 h酯的转化 率 > 96%。     

Small Peptides Catalyzed Direct Aldol Reactions of Aldehydes with Hydroxyacetone with Regiocontrol in Aqueous Media

Very recently, we[1] found that L-proline amides and dipeptides acted as efficient catalysts for the asymmetric direct aldol reaction. We report here that L-proline-based peptides 1～5 can catalyze the aldol reactions of hydroxyacetone with aldehydes 6 in aqueous media, to give 1,4-diols (7), the disfavored products with either aldolase or L-proline. Both peptides 3 and 4 give good results.     

硝酸铽与1，1，1′，1′-四(吡啶-2-羧酸酯基)联三甲基丙烷配合物的合成、表征及荧光性质

Solid complex of terbium nitrate with a novel tetrapodal ligand, 1,1,1′,1′-tetra(2-pyridinecarboxylester)-di(trimethylpropane) was prepared. This new complex with the formula of [TbL(NO₃)](NO₃)₂·2H₂O was charact-erized by elemental analysis, molar conductivity, IR spectroscopy and thermal analysis. At the same time, the luminescent property of the complex was also studied.     

The evolution of morphology of ordered porous TiO2 films fabricated from sol-gel method assisted ZnO nanorod template

Ordered porous TiO₂ films, including TiO₂ nanotube arrays, are fabricated by a sol-gel dip-coating approach via ZnO nanorod templates obtained from aqueous solution approach. The results indicate that the morphologies of ordered porous TiO₂ films have been great affected by the sol-gel dip-coating cycle number. Open-ended TiO₂ nanotube arrays can be obtained in optimum dip-coating cycle numbers. The TiO₂ nanotubes with the inner diameter matching well with the diameters of ZnO nanorods, are well assembled and separate each other. When the cycle number is less than this optimum value, no intact porous TiO₂ film can be obtained. As the cycle number is larger than this optimum value, an ordered porous TiO₂ film with many throughout holes is formed. The evolutive mechanism of ordered porous TiO₂ films is proposed.