氢化丁苯共聚物结构的核磁共振波谱表征Ⅱ.微观结构的定量计算

在氢化丁苯共聚物¹³C-NMR谱脂肪碳部分谱带归属的基础上,根据各谱带的主要来源,推导出六个二单元浓度的计算公式。计算出二单元、一单元的相对含量,各结构单元的数均序列长度、嵌段含量和其它结构参数。加氢前后的¹H-和¹³C-NMR谱的组成计算结果基本一致。初步探讨了作为粘度指数改进剂的氢化丁苯共聚物微观结构与性能的关系,为合成提供了依据。     

关于一类二次哈密尔顿系统在二次扰动下的极限环个数问题

本文研究了一类具有两个鞍点和一个中心的通用二次哈密尔顿向量场在二次扰动下的三参数开折，证明极限环的最小上界为２。     

玻璃陶瓷材料中Tm3+离子红外到蓝色上转换发光

系统研究了PbF2+GeO2+WO3ⅩⅣTmF3玻璃陶瓷材料中,在近红外光(1.06μm)激发下,Tm3+离子的发光特性.实验中观测到Tm3+离子的两组峰值位置分别在20920cm-1和22173cm-1的蓝色上转换发光,并证实这两组上转换发光分别与吸收三个和四个光子有关,同时建立了上转换发光的模型.为了选择最佳掺杂浓度,详细地测量了Tm3+离子峰值为20920cm-1的蓝色上转换发光强度与TmF3浓度的关系.     

非线性光纤方向耦合器孤子动力特性分析

利用变分方法,导出了双曲正割型光孤子在非线性光纤耦合器中传输时满足的动力学方程组,分析了该方程组的平衡点性态,讨论了光孤子的开关特性.指出参数|β|<2π.是能实现完全的开关操作的必要条件.     

溶胶-凝胶制备技术与新型催化材料Ⅲ.溶胶粒子表面修饰方法制备催化膜

提出用溶胶粒子表面修饰方法，结合溶胶凝胶技术制备无机催化膜．该方法的基本原理是利用合适的金属配合物在胶粒表面的吸附作用，经溶胶凝胶过程，将活性组分结合到无机膜中．实验测定结果表明：（ＮｉＥＤＴＡ）２－，ＶＯ－３，ＭｏＯ２－４，（Ｐｄ（ＮＨ３）４）２＋，ＰｄＣｌ２－４，ＰｔＣｌ２－６和ＲｈＣｌ３－６可用来修饰ＡｌＯＯＨ溶胶．以Ｐｄ／γＡｌ２Ｏ３催化膜的制备为例，经三次溶胶凝胶过程，可制得无裂缺的厚度为９μｍ的Ｐｄ／γＡｌ２Ｏ３催化膜，膜材料的平均孔直径为６ｎｍ，Ｐｄ被均匀地分布在膜的顶层，其平均粒径为２３ｎｍ．     

Comparison of stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry in application to supersonic jet spectrometry

Summary A supersonic jet spectrum of 9,10-dichloroanthracene is measured by stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry. The performance obtained is compared for these spectrometric methods, providing same information concerned with the energy level of the ground state. The former is more preferential for measurement of a high-resolution spectrum, since the spectral resolution is determined by the linewidth of the dumping laser. On the other hand, the latter is more preferential for measurement with better sensitivity at the expense of the spectral resolution, since the fluorescence throughput can be improved by increasing the slit width of the monochromator.Dedicated to Professor Dr. Wilhelm Fresenius on the occasion of his 80th birthday     

因素空间理论与知识表示的数学框架（Ⅷ）─—变权综合原理

本文是文［１－７］的继续，研究变权综合问题，从确定变权的经验公式入手引出了变权原理，给出了变权的公理化定义，讨论了与之有关的均衡函数及其梯度向量。     

An investigation of the Al2O3-CdSe interface in accumulation

The Al₂O₃−CdSe interface of a thin-film transistor is investigated in the frequency range 30 Hz-30 kHz under weak depletion and accumulation. The surface states are, most likely, located in the insulator Al₂O₃ with a concentration varying from 4·10¹⁸ to 10¹⁹ cm⁻³ eV⁻¹. The surface states have a negligible influence on the thin-film transistor operation.     

Recursive partition and amalgamation with the exponential family: Theory and applications

The theory of tree-growing (RECPAM approach) is developed for outcome variables which are distributed as the canonical exponential family. The general RECPAM approach (consisting of three steps: recursive partition, pruning and amalgamation), is reviewed. This is seen as constructing a partition with maximal information content about a parameter to be predicted, followed by simplification by the elimination of ‘negligible’ information. The measure of information is defined for an exponential family outcome as a deviance difference, and appropriate modifications of pruning and amalgamation rules are discussed. It is further shown how the proposed approach makes it possible to develop tree-growing for situations usually treated by generalized linear models (GLIM). In particular, Poisson and logistic regression can be tree-structured. Moreover, censored survival data can be treated, as in GLIM, by observing a formal equivalence of the likelihood under random censoring and an appropriate Poisson model. Three examples are given of application to Poisson, binary and censored survival data.     

k-树的补图的最小填充和树宽

一个图的最小填充问题是寻求边数最少的弦母图,一个图的树宽问题是寻求团数最小的弦母图,这两个问题分别在稀疏矩阵计算及图的算法设计中有非常重要的作用．一个k-树G的补图G称为k-补树．本文给出了k-补树G的最小填充数f(G) 及树宽TW(G)．