Microwave-Assisted Chemical Demulsification of Water-in-Crude-Oil Emulsions

Two case studies are presented that shows the effects of chemical demulsifiers used under conventional heating and in combination with microwave radiation on efficiency of demulsification and light transmittance of the water separated from the emulsions. The data shows that the chemical demulsifiers coupling with microwave radiation does a better job at demulsifying the water-in-crude-oil emulsions than when the chemical demulsifiers are used under conventional heating. The demulsification efficiency of AE-121 could reach 100% under microwave irradiation (300 W) for 50 seconds.     

Studies of Interfacial Activities of Four Kinds of Surfactants at Oil/Water Interface

This article aims to compare the interfacial activities of different kinds of surfactants in the same oil/water system. The anionic surfactants of alkylbenzene sulfonates, the polyoxyethylenated nonionic surfactants, the cationic surfactants of alkyl trimethyl ammonium chlorides, and the zwitterionic surfactants of alkyl hydroxyl sulfobetaines were used, and the interfacial tensions of the surfactant solutions against kerosene at different NaCl concentrations were measured. It is found that the interfacial activities of the alkylbenzene sulfonates are high and ultralow interfacial tensions (<0.01 mN/m) can be obtained at proper salinities. While, the nonionic surfactants have relatively low interfacial activities and the minimum tensions are around 0.01 mN/ms. The salinity scanning curves of the alkylbenzene sulfonates and nonionic surfactants decrease first, then increase, showing their interfacial activities can be changed by the salinity effectively. The cationic and zwitterionic surfactants have very low interfacial activities, of which all the tensions are higher than 0.1 mN/ms and are hard to be changed by the salinity. The experimental results may have important reference values for enhanced oil recovery.     

A形体过量β沸石的晶化过程

以四乙基氢氧化铵(TEAOH)为结构导向剂,在超浓水热条件下合成了手性多形体A(简称A形体)过量的β沸石,对初始凝胶的性质及晶化过程进行了深入研究,测定了相应的晶化曲线.研究结果表明,与晶化出A形体含量低于50%的普通β沸石的合成体系相比,晶化出A形体过量的β沸石的合成体系中含水量极低,凝胶中过量的水必须在晶化之前通过加热去除,但过度去除初始凝胶中的水则会显著延长晶化时间.在晶化初期,产物中己出现A形体过量特征,随着晶化的进行,A形体的过量程度无显著变化.     

纳米金标记抗体增强SPR检测大肠杆菌O157∶H7

将金纳米粒子(AuNPs)标记的大肠杆菌O157∶H7(E.coli O157∶H7)的多克隆抗体(PAb)作为二抗,采用氨基偶联法将PAb固定在传感器表面作为一抗,通过三明治方法用双通道表面等离子体子共振(SPR)传感器对E.coli O157∶H7进行检测,并与SPR直接法检测进行了比较.结果表明,直接法的检出限为103cfu/mL,线性范围为103～109cfu/mL;AuNPs增强三明治法的检出限为10 cfu/mL,线性范围为10～1010cfu/mL,灵敏度比直接法提高了100倍,且具有更宽的检测范围.本方法不仅检测时间短,而且具有良好的选择性和重现性.     

煤中痕量元素在循环流化床锅炉中的迁移行为与富集特性

对天津市某电厂循环流化床(CFB)锅炉燃用的原煤及燃烧产物底灰、飞灰、细飞灰(≤50 μm)进行痕量元素含量的测定,分析了Be、Zn、Hg、V、Cr、Mn、Co、Ni、Cu、As、Se、Cd、Pb 13种痕量元素在燃烧过程中的迁移行为,揭示了痕量元素在CFB锅炉中的分配、富集特性。结果表明,CFB锅炉中,较低的炉温对于痕量元素的迁移富集产生了较大的影响。由相对富集系数得知,Be、V、Co、Se在底灰中耗散,在飞灰中富集,Zn、Mn倾向于在底灰中富集,元素Cd、Pb、Ni、Cu挥发性较强,在底灰和飞灰中均是耗散。As受钙氧化物影响,挥发性表现并不明显。Hg在底灰和飞灰中相对富集系数均很低,表明Hg在整个燃烧过程中以气态形式排放;Hg、As、Se、V、Cr、Mn、Co、Ni、Cu、Zn、Pb均有向小颗粒物中富集的趋势。根据相对富集系数以及研究的13种元素在低温CFB锅炉中的迁移行为,将这些元素分为三类:A类(E_R<0.1),主要是以气态形式排放元素Hg;B类(0.1R≤0.85),较易挥发元素As、Be、Ni、Cu、Se、Cd、Pb、Co、V;C类(E_R>0.85),主要残留在固体产物中元素Zn、Mn、Cr。     

金属-有机骨架材料在样品预处理中的应用

金属-有机骨架材料(Metal-organic frameworks,MOFs)具有超大的比表面积和孔容积、可调的孔径和拓扑结构、良好的热稳定性等优点,因而被广泛用于气体储存、催化、吸附和分离等领域。近年来,以MOFs为吸附剂的样品预处理研究已引起广泛关注。本文综述了近7年来MOFs应用于样品预处理,如采样、固相萃取和固相微萃取等的研究进展,并对这一领域进行了展望。     

表面解吸常压化学电离质谱快速鉴别樟木制品

采用自行研制的表面解吸常压化学电离质谱(SDAPCI-MS),在无需样品预处理的情况下,对樟木制品及普通木材进行检测,在正离子模式及m/z 90～400范围内获得其化学指纹图谱,并通过主成分分析(PCA)方法对所获指纹谱图信息进行分析,进而对不同样品进行鉴别。结果表明,SDAPCI-MS能够对樟木表面多种特征化学成分(樟脑,香叶醇等)进行解吸电离,快速获得樟木的化学指纹谱图,并能够对目标组分做多级串联质谱鉴定。结合PCA方法,可对不同品质、不同种类的木材样品进行区分。结果表明,本方法灵敏度高,分析速度快(单个样品分析时间小于3 min),可望应用于珍贵木材快速无损分析及品质鉴定。     

有机溶剂/缓冲液两相体系中全细胞催化拆分环氧氯丙烷

研究了有机溶剂/缓冲液两相体系中重组大肠杆菌E.coli BL21 (DE3)全细胞水解动力学拆分外消旋环氧氯丙烷制备(R)-环氧氯丙烷的过程.结果表明,最适反应条件为:最适有机溶剂异辛烷与缓冲液的体积比7:3,最适缓冲液pH 8.0,底物浓度574mmol/L,全细胞加入量0.07g湿菌体/ml溶液,温度30℃.在此条件下于1L反应器中反应45min,(R)-环氧氯丙烷的摩尔产率、光学纯度和时空产率分别达到37.5%,99.3%ee和0.286mol/(L·h).与单一水相体系相比,异辛烷/缓冲液两相体系中底物浓度和(R)-环氧氯丙烷时空产率分别提高了55.2%和98.6%.     

Synthesis and Crystal Structure of a B-H Activated Compound Containing a Furan Ring and an ortho-Carborane Cage

A new compound [CpCo（Se2C2BIoH9）CH2C（O）C4H30] has been synthesized and characterized by elemental analysis, IR spectroscopy, NMR, MS and single-crystal X-ray diffraction. The complex crystallizes in the monoclinic system, space group P21/c with a = 10.9481（10）, b = 24.6600（12）, c = 25.7430（14） A, β = 100.863（3）°, C42H57B30Co306Se6＂CH2C12＂0.25H20, Mr = 1722.16, V = 6825.6（8） A3, Dc= 1.676 g/cm3, Z = 1 and F（000） = 3346. The molecular structure shows a 1：1 ratio product of the two reactants of 16e half-sandwich complex CpCo（Se2C2B10H10） and alkyne 1-（2-furyl）-2-propyn-l-one. The hydrogen atom in the B（3） position of CpCo（Se2C2B10HIo） has been activated and migrated to the terminal carbon of 1-（2-furyl）- 2-propyn-l-one to form the B-CH2 unit. The title compound molecules are linked and extended further into a one-dimensional chain through atypical hydrogen bonds.     

Facile synthesis of gemini surface-active ATRP initiator and its use in soap-free AGET ATRP mini-emulsion polymerisation

A novel cationic gemini surfactant has been readily synthesised in 70 % total yield. The functional gemini surfactant can act both as an emulsifier and an atom transfer radical polymerisation (ATRP) initiator in mini-emulsion polymerisation of methyl methacrylate (MMA), in which no other emulsifier was required. 1-(Dimethylamino)dodecane (N,N-dimethyldodecylamine, DMDA) was found to be a good ligand in the activator generated by electron transfer (AGET) ATRP reaction. Kinetic studies indicated that the polymerisation featured controlled/living radical polymerisation.