Entanglement Evolution of a 2-Qutrit System Interacting with a Fermionic Bath

Based on the algebraic entanglement measure proposed [G. Vidal et al., Phys. Rev. A 65 (2002) 032314],we study the entanglement evolution of both pure quantum states and mixed ones of 2-qutrit system in a symmetrybroken environment consisting of a fermionic bath. Entanglement of states will decrease or remain constant under the influence of environment, and the class of states which remain unchanged has been found out.     

高温超导体Josephson阵列在磁场中的微波响应与磁通涡旋激发

本文从分析相变电阻率 ρP 和磁通蠕动电阻率 ρF 出发 ,指出当T小于某一温度T0 时 ,ρF>ρP,而当T >T0 时 ,ρF 远小于 ρP,并进一步分析了 ρF 与 ρP 随温度的变化率分布图 ,得出磁通蠕动电阻率 ρF 随温度的变化率分布图跟微波响应曲线具有相似的分布特征 ,结果表明 :高温超导体的非平衡微波响应机制可能与磁通涡旋的激发有关 .     

关于Banach空间中凸泛函的广义次梯度不等式

本文在前人^[1,2]的基础之上，以凸泛函的次梯度不等式为工具，将Jensen不等式推广到Banach空间中的凸泛函，导出了Banach空间中的Bochner积分型的广义Jensen不等式，给出其在Banach空间概率论中某些应用，从而推广了文献[3—6]的工作．     

新核素278113的基态特性及其α衰变链的研究

用形变的相对论平均场模型,Skyrme-Hartree-Fock模型及宏观-微观模型研究了新核素²⁷⁸113及其α衰变链的α衰变能和半衰期.计算的α衰变能同实验数据比较符合,相应的半衰期也在合理的范围内.计算进一步表明形变对超重核的基态性质有重要影响.     

Radiative Lifetimes of Doubly Ionized Terbium

Radiative lifetimes of two short-lived levels （i.e. 4f^8 （TF6）6p^1/2 （6, 1/2）11/2,13/2） in Tb Ⅲ are measured by time-resolved laser-induced fluorescence （LIE） technique with a two-step excitation process. Free Tb Ⅲ ions are produced in a laser-induced plasma. Lifetime values are evaluated with a deconvolution procedure of the timeresolved fluorescence signal with the temporal shape of second-step excitation pulse （about 1 ns）. The lifetimes of the 4f^8 （^7F6）6p^1/2 （6, 1/2）11/2 and 4f^8（^7F6）6p^1/2 （6, 1/2）13/2 levels are determined to be 1.9 （2） and 2.0 （2）ns, respectively.     

基于Apollo信号控制台的NQR炸药探测方法

介绍了一种基于Apollo信号控制台的核四极矩共振（NQR）炸药探测方法，描述了系统的结构组成、工作原理和实现方法，并给出了对RDX的测试试验结果. 试验表明该方法可实现对RDX信号的探测.     

Cl/HN3/I2全气相化学激光体系的化学动力学模拟计算

 对Cl/HN₃/I₂产生NCl(a)/I激光的过程进行了化学动力学计算，主要考察了Cl,HN₃和I₂的初始粒子数密度及其配比对小信号增益系数的影响。结果发现,当温度为400K, 初始Cl粒子数密度为1×10¹⁵，1×10¹⁶和1×10¹⁷cm^-3时,小信号增益系数分别达到1.6×10^-4,1.1×10^-3和1.1×10^-2cm^-1，获得最佳小信号增益系数的HN₃和I₂的初始粒子数密度分别为初始Cl粒子数密度的1～2倍和2%～4%。同时，对Cl，HN₃和I₂配比对小信号增益系数和增益持续时间的影响进行了讨论。     

采用空心阴极放电等离子体化学气相沉积方法制备a-CH薄膜

 研究了不同衬底-阴极距离、直流电压和H₂流量对a-CH薄膜沉积速率的影响。结果表明：衬底-阴极距离必须大于0.5cm，随着该距离的增加，薄膜的沉积速率减少；直流电压达550V时沉积速率最大；随着H2含量的增加，CH₄含量相对减少，沉积速率随之降低。用AFM观察了以该方法制得的448.4nm CH薄膜的表面形貌，表面粗糙度约为10nm。最后测出了不同条件下CH薄膜的UV-VIS谱，由此可以计算得到薄膜的禁带宽度及折射率。     

GC-MS技术在舰船胶粘材料毒性评价中的应用

胶粘材料简称胶粘剂、粘合剂、粘结剂、接着剂。因其能把各种材料紧密地粘合在一起,并具有各种良好的性能,因而广泛地应用于海军舰船的制造及维修中。应用GC-MS技术对在使用环境及条件下其释放物及高温热解物的定性分析是对其进行使用过程中毒性评价的重要步骤。1实验部分1.1仪器与材料仪器:JMS-D300(日本JEOL);PIATFORMⅡGC-MS。     

Synthesis of Cationic PEM Emulsion and Application in Waste Water Treatment

Cationic polymer as a kind of flocculant is widely applied in purification treatment of waste water. Because it has positive charge group, it is able to connect strongly the suspended matters, short cellulose and other microparticles. The research on synthesis of cationic polymer and application in treatment of waste water is very universal abroad. But domestic research on those is not general. The technology of synthesis of PEM is simple, and the production cost is low. It is easy to apply in treatment of waste water.Synthesis of PEM Emulsion FlocculantSome distilled water, PVA(poly(vinyl alcohol)), EA(ethyl acrylate), and K2S2O8(potassium persulfate) were put into reaction vessel. Kept stirring up under nitrogen. When heated the solution to 40℃, dropped the water solution of MTA[(2-methacryloxylethyl)trimethyl ammonium].Maintained the temperature at 70℃, reacted about 7-8 hours. Then got the PEM emulsion. Changed the ratio of EA and MTA. Obtained a series of PEM emulsions.Stability and Convertibility of PEM EmulsionThe test results showed that when the EA/MTA was 85/15, the PEM emulsion was most stable.When the total monomer quantity was 35%, the convertibility of PEM emulsion was the highest,i.e.98.6%.The MTA Copolymerization Ratio and Morphology of PEM EmulsionWhen the monomers EA/MTA=85/15 and total monomer quantity was 35%, the MTA copolymerization ratio of PEM emulsion was 95.15%(the highest), and the PEM emulsion was some microspheres with 100-180nm of diameter.The Test Results of PEM Emulsion in Treatment of Waste Water The PEM emulsion flocculant was applied in treatment of waste water of paper mill, and measured the precipitation time(t) and transmittancy(T). The test results were showed in table 1. The optimum value of PEM which was able to make the waste water of paper mill into clear water was 0.008%.