Soluble,saturated‐red‐light‐emitting poly(p‐phenylenevinylene) containing triphenylamine units and cyano groups

A conjugated poly(p‐CN‐phenylenevinylene) (PCNPV) containing both electron‐donating triphenylamine units and electron‐withdrawing cyano groups was prepared via Knoevenagel condensation in a good yield. Gel permeation chromatography suggested that the soluble polymer had a very high weight‐average molecular weight of 309,000. A bright and saturated red emission was observed under UV excitation in solution and film. Cyclic voltammetry showed that the polymer presented quasi‐reversible oxidation with a relatively low potential because of the triphenylamine unit. A single‐layer indium tin oxide/PCNPV/Mg–Ag device emitted a bright red light (633 nm). © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 3947–3953, 2004     

Concentrations of hazardous heavy metals in environmental samples collected in Xiamen, China, as determined by vapor generation non-dispersive atomic fluorescence spectrometry.

Non-dispersive atomic fluorescence spectrometry (NDAFS) coupled with vapor generation (VG) sample introduction was applied to the determination of the concentrations of hazardous heavy metals, such as arsenic, cadmium, lead and mercury, in seawater, soils and total airborne particulate matter (PM) collected around the Xiamen area in China. Almost 100% sample introduction efficiency was achieved by using thiourea and ascorbic acid for the pre-reduction of As(V) to As(III), K3Fe(CN)6 and tartaric acid for pre-oxidation of Pb(II) to Pb(IV), and masking the interferences arising from the co-existing transition metals to As, Cd, Hg and Pb during their vapor generation process. Moreover, a novel sample pretreatment device was developed to avoid the loss of mercury, lead, cadmium and arsenic during sample pretreatment. With such methods, the detection limit (DL) of arsenic, cadmium, lead and mercury was down to 0.08, 0.03, 0.05, 0.01 ng mL(-1) (3sigma), respectively. The relative standard deviations (RSD, n = 11) for arsenic, cadmium, lead and mercury at 10 ng mL(-1) were 0.9%, 1.6%, 1.3% and 2.0%, respectively. The concentrations of hazardous heavy metals in the environmental samples collected in Xiamen, China are in the range from 0.02 +/- 0.001 ng mL(-1) in seawater to 15.3 +/- 0.2 microg g(-1) in soils. Besides flame/GF-AAS and ICP-AES/MS, VG-NDAFS should be another choice for the determination of hazardous heavy metals in environmental samples.     

利用声波控制超短脉冲的色散

 声光互作用器件声光可编程色散滤波器（AOPDF）是一种实时的色散补偿器件，它可用于飞秒啁啾脉冲放大系统。通过耦合模理论推导，得到了输出脉冲的群延迟与调制声波的频率、啁啾、带宽等参数的关系，并且对用2.5cm长的LiNbO₃作为声光晶体的AOPDF补偿飞秒光脉冲的色散进行了数值模拟，得到了对中心波长为800 mm的钛宝石飞秒激光色散补偿特性及所需声波的频率和啁啾参数。     

Φ520mmF/1.6椭球面反射镜加工

介绍了一块Φ520mm大相对孔径(F/1.6)轻量化椭球面反射镜的加工与检测方法。镜面的有效口径为Φ502mm,顶点曲率半径为1600mm,非球面系数k=-0.9663,面形精度要求优于0.025λ(RMS)。镜子背面有54个大小深浅不一的不通孔,用于减轻镜子的重量。采用WYKO干涉仪检测得到镜面面形误差达RMS0.02λ,λ=632.8nm。     

厚度对非极性聚合物薄膜驻极体电荷储存及电荷动态特性的影响

以Du Pont公司的商用Teflon FEP A型薄膜为例，通过热脉冲技术、等温表面电位衰减测量和开路热刺激放电电流谱分析等实验结果，讨论了经常温和高温电晕充电后样品厚度对薄膜驻极体的沉积电荷密度、薄膜驻极体的内电场、体电导率以及电荷储存稳定性的影响.通过热脉冲技术组合电导率温度曲线的测量，研究了在不同温度条件下样品厚度对沉积电荷层的平均电荷重心移动的影响.结果表明：在充电参数一定的条件下，随着膜厚的降低，储存电荷密度上升，但电荷稳定性有所下降.因此，合理地调控薄膜厚度，可以有效地优化驻极体的电荷储存能 关键词： 厚度 驻极体 电荷储存能力 电荷稳定性     

强流四脉冲电子束源实验研究

 为了进行强流多电子束源研究，对现有2MeV LIA 注入器进行了四脉冲改造，二极管脉冲电压约500kV。实验研究了天鹅绒阴极在四脉冲条件下的发射能力、传导电流负载效应以及阴极等离子体运动对阴极电子发射和束能量的影响。利用空间电荷限制流模型推算出阴极等离子体膨胀速率在1 ~4cm/μs之间。     

Synthesis of Novel Monomeric Dyes with Anthraquinone Residue

Two novel polymerizable dyes with anthraquinone residue have been prepared, and their structures were characterized by FTIR, ^1HNMR and EA.     

Crystal Structures of Two Potential Tumor Imaging Agents and Therapeutic Agents Copper（Ⅱ） Ternary Complexes with Salicylidene-tyrosinato Schiff Base and Nitrogen-donor Chelating Lewis Base

The crystal structures of two potential tumor imaging agents and therapeutic agents -copper(Ⅱ) complexes with salicylidene-tyrosinato Schiff base and nitrogen-donor chelating Lewis base, [Cu(sal-tyr)(bipy)] 1 and [Cu(sal-tyr)(phen)]2CH3OH 2 are presented. Our work is helpful to get deep understanding of novel 64Cu tumor imaging agents and therapeutic agents.     

硅基两维光子晶体的制备和光子带隙特性

利用反应离子束刻蚀设备制备了硅基的两维空气柱光子晶体，并用红外显微镜测试了样品的 反射谱. 理论上用时域有限差分(FDTD)方法计算了样品的光子带隙，从测试结果看光子带隙 和理论计算的光子带隙符合得很好.  关键词： 光子晶体 光子带隙 反射谱 时域有限差方法     

Compression Behaviour of Ni77P23 Amorphous Alloy up to 30.5 GPa

The compression behaviour of Ni77P23 amorphous alloy is investigated at room temperature in a diamond-anvil cell instrument using in-situ high pressure energy dispersive x-ray diffraction with a synchrotron radiation source. The equation of state is determined by fitting the experimental data according to the Birch-Murnaghan equation. It is found that the structure of Ni77P23 amorphous alloy is stable under pressures up to 30.5 GPa. Within the pressure range from zero to the experimental one, the pressure-induced structural relaxation is reversible.