Quantitative analysis of bilobalide and ginkgolides from Ginkgo biloba leaves and Ginkgo products using (1)H-NMR

1H-NMR spectrometry was applied to the quantitative analysis of the bilobalide, ginkgolides A, B, and C in Ginkgo biloba leaves and six kinds of commercial Ginkgo products without any chromatographic purification. The experiment was performed by the analysis of each singlet H-12, which were well separated in the range of delta 6.0-7.0 in the (1)H-NMR spectrum. However, the H-12 protons of bilobalide and ginkgolides may have overlapped with H-6 or H-8 protons of the Ginkgo flavonoids. Therefore, the optimum (1)H-NMR solvent for the analysis of the compound was selected through the evaluation of solvent effects on the resolution of these signals from the compounds. Acetone-d(6)-benzene-d(6) (50 : 50) was found to be the best one among the solvents evaluated. The quantity of the compounds was calculated by the relative ratio of the intensity of each compound to the known amount of internal standard (25 microgram), phloroglucinol. This method allows rapid and simple quantitation of underivatized bilobalide and ginkgolides in 5 min without any pre-purification steps.     

Investigation of efflorescence of inorganic aerosols using fluorescence spectroscopy

The phase transition is one of the most fundamental phenomena affecting the physical and chemical properties of atmospheric aerosols. Efflorescence, in particular, is not well understood, partly because the molecular interactions between the solute and water molecules of saturated or supersaturated solution droplets have not been well characterized. Recently, we developed a technique that combines the use of an electrodynamic balance and a fluorescence dye, 8-hydroxyl-1,3,6-pyrenetrisulfonate (pyranine), to study the distributions of solvated and free water in aqueous droplets (Choi, M. Y.; Chan, C. K.; Zhang, Y. H. J. Phys. Chem. A 2004, 108, 1133). We found that the equality of the amounts of solvated and free water is a necessary but not sufficient condition for efflorescence. For efflorescing compounds such as Na2SO4, (NH4)2SO4, and a mixture of NaCl and Na2SO4, the amount of free water decreases, while that of solvated water is roughly constant in bulk measurements and decreases less dramatically than that of free water in single-particle measurements as the relative humidity (RH) decreases. Efflorescence of the supersaturated droplets of these solutions occurs when the amounts of free and solvated water are equal, which is consistent with our previous observation for NaCl. For nonefflorescing compounds in single-particle levitation experiments such as MgSO4 and Mg(NO3)2, the amounts of free and solvated water are equal at a water-to-solute molar ratio of about 6, at which spectral changes due to the formation of contact ion pairs between magnesium and the anions occur as shown by Raman spectroscopy. Fluorescence imaging shows that the droplets of diluted Mg(NO3)2 (at 80% RH) and MgSO4 are homogeneous but those of NaCl, Na2SO4, (NH4)2SO4, and supersaturated Mg(NO3)2 (at 10% RH) are heterogeneous in terms of the solvated-to-free water distribution. The solvated-to-free water ratios in NaCl, Na2SO4, and (NH4)2SO4 droplets are higher in the outer regions by about half a radius deep than at the center of the droplets.     

NO x Removal Characteristics in Plasma Plus Catalyst Hybrid Process

NO_x removal characteristics and NO conversion trends were investigated for plasma process, catalytic process, and plasma catalytic hybrid process. In the experiments, we studied effects of the flow rate and the carrier gas on the NO conversion in the plasma process, and effects of ammonia concentration and temperature on the NO_x removal in the catalytic process. We also investigated the synergetic effect of a plasma-catalytic hybrid process. Dielectric barrier discharge was combined with V₂O₅–WO₃/TiO₂ catalyst for removing nitrogen oxides. The maximum conversions of nitrogen oxides were approximately 52, 80, and 98% at the temperature of 100, 200, and 300°C, respectively. The optimal energy density, ammonia concentration, and ratio of nitrogen oxides exist for the highest removal of nitrogen oxides in the plasma catalytic hybrid process.     

Studies of tetracene- and pentacene-based organic thin-film transistors fabricated by the neutral cluster beam deposition method

The neutral cluster beam deposition (NCBD) method has been applied to produce and characterize organic thin-film transistors (OTFTs) based upon tetracene and pentacene molecules as active layers. Organic thin films were prepared by the NCBD method on hexamethyldisilazane (HMDS)-untreated and -pretreated silicon dioxide (SiO2) substrates at room temperature. The surface morphology and structures for the tetracene and pentacene thin films were examined by atomic force microscopy (AFM) and X-ray diffraction (XRD). The measurements demonstrate that the weakly bound and highly directional neutral cluster beams are efficient in producing high-quality single-crystalline thin films with uniform, smooth surfaces and that SiO2 surface treatment with HMDS enhances the crystallinity of the pentacene thin-film phase. Tetracene- and pentacene-based OTFTs with the top-contact structure showed typical source-drain current modulation behavior with different gate voltages. Device parameters such as hole carrier mobility, current on/off ratio, threshold voltage, and subthreshold slope have been derived from the current-voltage characteristics together with the effects of surface treatment with HMDS. In particular, the high field-effect room-temperature mobilities for the HMDS-untreated OTFTs are found to be comparable to the most widely reported values for the respective untreated tetracene and pentacene thin-film transistors. The device performance strongly correlates with the surface morphology, and the structural properties of the organic thin films are discussed.     

Si extraction from silica in a basic polychalcogenide flux. Stabilization of Ba4SiSb2Se11, a novel mixed selenosilicate/selenoantimonate with a polar structure

An unusual compound, Ba4SiSb2Se11, was discovered from a reaction of Ba/Th/Sb/Se. It is assumed that Si was extracted from the silica reaction tube. It forms as silver needlelike crystals in the polar space group Cmc2(1) with a = 9.3981(3) A, b = 25.7192(7) A, c = 8.7748(3) A, and Z = 4. A rational synthesis has been devised at 600 degrees C. The compound is composed of Ba2+ ions stabilized between infinite one-dimensional [SiSb2Se11]8- chains running parallel to the a axis. Each chain is composed of a [SbSe2]- infinity backbone with [SiSe4]4- tetrahedra chelating every other Sb atom from the same side of the backbone. The V-shaped triselenide groups, (Se3)2-, are attached to the rest of the Sb atoms in the chain through one of their terminal Se atoms. The compound has a band gap of 1.43 eV. The Raman spectrum shows a broad shift at 247 cm-1 and a shoulder around 234 cm-1, which are related to the Se-Se vibration of the triselenide groups and/or the Si-Se vibrations of the [SiSe4]4- groups. The compound decomposes at 522 degrees C.