Fully developed mixed convection in horizontal and inclined tubes with uniform heat flux using nanofluid

Fully developed laminar mixed convection of a nanofluid consists of water and Al₂O₃ in horizontal and inclined tubes has been studied numerically. Three-dimensional elliptic governing equations have been solved to investigate the flow behaviors over a wide range of the Grashof and Reynolds numbers. Comparisons with previously published experimental and numerical works on mixed convection in a horizontal and inclined tube are performed and good agreements between the results are observed. Effects of nanoparticles concentration and tube inclinations on the hydrodynamics and thermal parameters are presented and discussed. It is shown that the nanoparticles concentration does not have significant effects on the hydrodynamics parameters. Heat transfer coefficient increases by 15% at 4 Vol.% Al₂O₃. Skin friction coefficient continually increases with the tube inclination, but the heat transfer coefficient reaches a maximum at the inclination angle of 45°.     

Application of the wavelet transform for a channel flow in a mixed convection phenomenon

The aim of this paper is to investigate laminar-turbulent transition in a mixed convection phenomenon occurring in a horizontal rectangular duct. Indeed, laminar-turbulent transition is well known in the case of forced convection but the presence of secondary flow induced by natural convection on this transition is not well highlighted. In this study, we will not be concerned by determining a critical threshold value of a Reynolds number of transition but only to estimate the degree of turbulence in the transition regime, i.e. weak turbulence in the case of a mixed convection phenomenon. This is possible thanks to the application of the wavelet transform. The calculation of the Hölder exponent, associated with the maximum value of the singularity spectrum for various experimental conditions allows the degree of turbulence to be measured. The variation of the Hölder exponent versus heat flux and Reynolds number enables us to show that there are two ways to go towards turbulence: thermal by increasing heat flux and hydrodynamic by increasing fluid velocity.     

NMR investigations of hexamethyldisilane confined in controlled pore glasses: Pore size distribution and molecular dynamics studies

In this work, the melting-point depression and molecular dynamics of hexamethyldisilane confined within five controlled pore glasses, with mean diameters ranging from 7.9 to 23.9 nm, are studied by high-field (9.4 T) nuclear magnetic resonance (NMR), and the results are discussed with reference to the bulk substance. The melting-point depression in pores with radiusR follows the simplified Gibbs-Thompson equation ΔT=k _p/(R−s) with ak _p value of 74 K · nm and ans value of 1 nm. To our knowledge, this is the first time thek _p value of hexamethyldisilane is reported. Proton spin-lattice relaxation times (T ₁), spin-spin relaxation times (T ₂), and diffusivities (D) are reported as a function of temperature. The confinement in the pores gives rise to substantial changes in the molecular dynamics and the phase behavior. The line-shape measurements reveal a two-phase system assigned to a relatively mobile component at the pore walls and a crystalline solid at the center of the pores. However, theT ₂ measurements show that the mobile phase also embraces a minor component attributed to nonfrozen liquid in pockets or micropores. The diffusivity of the major narrow-line component is approximately three orders of magnitude larger than that in the plastic bulk phase, reflecting fast diffusion of mobile molecules. Below the melting region,T ₁ of the narrow line is significantly shorter thanT ₁ of the broad line, suggesting that the molecular reorientation is more hindered close to the surface than at the center of the pore.     

Anisotropic and isotropic phases of polymer melts

The melting mechanism of polymer crystals is proposed. It is assumed that the melting happens due to forming supervacancies. This mechanism leads the appearance of anisotropic phase of a melt. It is shown that two phases—anisotropic and isotropic—can exist in polymer melts.     

Combined supercritical-fluid chromatography/mass spectrometry in the analysis of diuron in plasma using on-line phase-system switching

On-line sample pretreatment by means of the phase-system switching approach is an interesting technique for the analysis of aqueous samples, e.g., plasma, by means of supercritical-fluid chromatography. In order to analyse plasma samples the following analytical procedure is used. The plasma sample is injected on to a short precolumn, which is washed with water and subsequently dried with nitrogen. Next, the solutes are desorbed with the supercritical mobile phase, analysed with packed-column supercritical-fluid chromatography and detected with either a UV detector or a mass spectrometer, equipped with a moving-belt interface. The herbicide diuron is selected as a test compound to study the feasibility of this approach. Using a selective detector the procedure is sufficiently sensitive to detect diuron in plasma, but not appropriate to detect the diuron metabolites in a post-mortem plasma sample. These have been identified with liquid chromatography/mass spectrometry. The detection limit of diuron in plasma using the procedure described is about 30 ng/mL.     

Low-frequency internal friction in complex composite strands

Conclusion A method was proposed which makes it possible to study the low-frequency internal friction of complex fibers. This method was used to study the internal friction of complex composite fibers based on PCA and PE. We observed a relaxation process which is typical of the composite and is absent in the pure materials.Translated from Mekhanika Kompozitnykh Materialov, No. 1, pp. 11–15, January–February, 1989.     

Effect of rare-earth oxides on the magnetic properties of anisotropic barium ferrites

The effect of rare-earth oxides on the properties of anisotropic barium ferrites has been studied by x-ray structural and Mössbauer methods. Additions of SrCO₃, as well as SrCO₃ and La₂O₃, SrCO₃ and Pr₆O₁₁, SrCO₃ and Nd₂O₃, SrCO₃ and Sm₂O₃ in amounts of 7.5 mole % Sr and 10 mole % rare-earth element to grade-A barium powder results in the substitution of barium ions by Sr and rare-earth ions; consequently, the energy of magnetic anisotropy changes and the technically important parameters B_r and (BH)_max increase.Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 1, pp. 34–39, January, 1989.     

Alkylation of 2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-trione and its S-oxide

The reactions of 2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-trione with dimethyl sulfate, benzyl chloride, and allyl bromide afforded the corresponding 2-alkyl-2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-triones and 3-(alkoxy)-6,11-dihydroanthra[2,1-d]isothiazole-6,11-diones. The reactions of 2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-trione and its S-oxide with a formaldehyde—secondary amine system yielded 2-[(alkylamino)methyl]-2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-triones and 2-[(alkylamino)methyl]-3,6,11-trioxo-2,3,6,11-tetrahydroanthra[2,1-d]isothiazole 1-oxides, respectively.     

Role of Bulk Vaporization in the Dynamics of Laser-Induced Erosion Plumes of Metals

In different regimes of exposure of metals to pulsed laser radiation, we show the role played by the liquid-drop phase formed from the target material in a laser-induced erosion plume due to bulk vaporization, in the dynamics of this plume. For some metals, the ranges of power densities of the acting laser radiation, at which the condensed-phase particles influence the passage of laser radiation to the target surface, have been determined experimentally. The mechanism of realization of a low-threshold breakdown has been revealed.     

New insights on amorphous silicon-nitride microcavities

All amorphous silicon-nitride planar optical microcavities operating in the visible range have been grown by plasma enhanced chemical vapor deposition. The luminescence intensity of the N-rich silicon-nitride layer from a microcavity with 6 period distributed Bragg reflectors (DBRs) is two order of magnitude higher than that of the luminescent layer without the cavity. Moreover, a strong directionality of the microcavities emission can be observed. Such results can be ascribed to the anisotropic optical density of states induced in the Fabry–Perot structure. The quality factors of the resonators are strictly correlated to the number of periods of the DBRs.