聚丙烯酰胺与混合表面活性剂的相互作用

通过粘度和紫外吸收光谱的测定，研究了ＰＡＭ与Ｒ１２ＳＯ３Ｎａ－Ｒ１１ＣＯＯＮａ混合表面活性剂之间的相互作用，结果表明，ＰＡＭ可与混合表面活性剂形成复合物，从而使体系表现出典型聚电解质的粘度行为。可能的机理是，以疏水力形成的Ｒ１２ＳＯ３＾－—Ｒ１１ＣＯＯＨ（Ｎａ）预胶束或二聚体通过ＰＡＭ－Ｒ１１ＣＯＯＨ间的氢键力相结合。进而使大分子链上带有大量负电荷，静电斥力引起大分子链伸展，因而产生电粘效应。     

HEMA-NVP-St三元共聚体系研究Ⅲ.均化剂对共聚物组成均一性的影响

用溴化钾-溴酸钾滴定法测定双键含量,元素分析法测定共聚物组成。讨论了HEMA-NVP-St三元共聚体系在不同反应程度时共聚物组成的变化,以及在此三元共聚体系中引入均化剂后,少量均化剂对共聚体系组成均一性的影响。发现在HEMA-NVP-St三元共聚体系中加入均化剂,对共聚反应的反应动力学影响不大,但对共聚物的组成均一性有较大影响。它的加入使三元共聚物中的链节比分布(即不同反应程度时,产物的累积平均组成)向较均一的方向发展。结合红外光谱、电子显微镜等实验证据,从微观结构上探讨了约化剂的作用。阐明均化剂改善了反应体系的相容性,从而得到组成分布较为均一的共聚产物。     

Coupling of flow injection wetting-film extraction without segmentation and phase separation to flame atomic absorption spectrometry for the determination of trace copper in water samples

A flow injection wetting-film extraction system without segmentor and phase separator has been coupled to flame atomic absorption spectrometry for the determination of trace copper. Isobutyl methyl ketone (MIBK) was selected as coating solvent and 8-hydroxyquinoline (oxine) as the chelating reagent. By switching of a 8-channel valve and alternative initiation of two peristaltic pumps, MIBK, sample solution containing copper chelate of oxine, and air-segment sandwiched eluting solution (1.0 mol l⁻¹ nitric acid) were sequentially aspirated into an extraction coil made of PTFE tubing of 360 cm length and 0.5 mm i.d. The formation of organic film in the wall of the extraction coil, extraction of the copper chelate into the organic film and back-extraction of the analyte into the eluting solution occurred consecutively when these zones aspirated into the extraction coil were propelled down the extraction coil by a carrier solution at a flow rate of 2 ml min⁻¹. After leaving the extraction coil, the concentrated zone was transported to the nebulizer at its free uptake rate for atomization. Under the optimized conditions, an enrichment factor of 43 and a detection limit of 0.2 μg l⁻¹ copper were achieved at a sample throughput rate of 30 h⁻¹. Eleven determinations of a standard copper solution of 60 μg l⁻¹ gave a relative standard deviation of 1.5%. Foreign ions possibly present in tap water and natural water did not interfere with the copper determination. The developed method has been successfully used to the determination of copper content of tap water and river water.     

循环伏安法研究硝基药物的β-环糊精包含络合物

本文用悬汞电极循环伏安法,研究了甲硝唑、氯霉素、对硝基苯酚和对硝基苯甲酸等药物的伏安性质,用“电流法”测定了药物与β-CD生成包络物的K_f值,并讨论其作用及稳定性。     

Cu2(bipy)2V6O17: A new type of layered inorganic–organic hybrid copper(II) vanadate

Hydrothermal reaction of copper(II) acetate, 2,2′-bipyridine (bipy) and NH₄VO₃ at 170 °C lead to a new layered polyoxovanadate with organically covalent-bonded copper(II) complex, Cu₂(bipy)₂V₆O₁₇ (1). Cu₂(bipy)₂V₆O₁₇ (1) is a new copper(II) vanadium(V) oxide featuring a new layered architecture, in which the V₂O₇ dimeric units and the cyclic tetranuclear V₄O₁₂ cluster units are interconnected via corner sharing into a unique one-dimensional {V₆O₁₇}⁴⁻ anionic chain, such chains are further bridged by {Cu(bipy)}²⁺ complex cations into a 010 organic–inorganic hybrid layer.     

Deactivation and regeneration of the B2O3/TiO2-ZrO2 catalyst in the vapor phase Beckmann rearrangement of cyclohexanone oxime

The deactivation and regeneration of B₂O₃/TiO₂-ZrO₂ catalyst for the vapor phase Beckmann rearrangement of cyclohexanone oxime to -caprolactam were studied. The fresh, deactivated and regenerated catalysts were characterized by using adsorption of nitrogen, X-ray diffraction (XRD), thermogravimetry (TG) and NH₃-temperature-programmed desorption (NH₃-TPD) techniques. The crystal structure and pore size distribution of the catalyst were retained after reaction, but the number of acid sites decreased significantly. There was a relationship between the amount of coke deposited on the catalyst and the decline in catalytic activity. These results suggest that the coke deposition on the surface of catalyst is mainly responsible for the catalyst deactivation. The catalytic activity can be recovered completely after calcining the deactivated catalyst in air flow at 600 °C for 8 h.     

DNAzyme amplification of molecular beacon signal

This paper reports an improved catalytic molecular beacon. Addition of the target oligonucleotide activates a DNA enzyme (DNAzyme), which, in turn, activates multiple copies of molecular beacons (MB) and gives rise to a strong fluorescence signal. In a previous design, the activated DNAzyme could oligomerize, especially dimerize, and result in inactivation of the DNAzyme. The current design avoids this problem, upon activated by the target DNA, the DNAzyme will stay constantly active. With the improved method, a detection of 10 pM DNA has been demonstrated, which is 1000 times more sensitive than the method previously reported.     

Preparation and Crystal Structure of PrNb_5O_(14)

ＰｒｅｐａｒａｔｉｏｎａｎｄＣｒｙｓｔａｌＳｔｒｕｃｔｕｒｅｏｆＰｒＮｂ_５Ｏ_（１４）￥ＭａｏＪｉａｎｇ－Ｇａｏ；ＺｈｕａｎｇＨｏｎｇ－Ｈｕｉ；ＨｕａｎｇＪｉｎ－Ｓｈｕｎ（ＳｔａｔｅＫｅｙＬａｂｏｒａｔｏｒｙｏｆＳｔｒｕｃｔｕｒａｌＣｈｅｍｉｓｔｒｙ...