Properties of ITO films prepared by reactive magnetron sputtering

Indium tin oxide (ITO) thin films were deposited by mid frequency pulsed dual magnetron sputtering using a metallic alloy target with 10 wt.% tin in an atmosphere of argon and oxygen. The aim of the work was to study the interdependence of structural, electrical and optical properties of ITO films deposited in the reactive and transition target mode, respectively. The deposition rate in the transition mode exceeds the deposition rate in the reactive mode by a factor of six, a maximum value of 100 nm·m min⁻¹ could be achieved. This corresponds to a static deposition rate of 200 nm min⁻¹. The lowest electrical resistivity of 1.1·10⁻³ Ω cm was measured at samples deposited in the high oxygen flow range in the transition mode. The samples show a good transparency in the visible range corresponding to extinction coefficients being below 10⁻². X-ray diffraction was used to characterise crystalline structure as well as film stress. ITO films prepared in the transition mode show a slightly preferred orientation in (211) direction, whereas films deposited in the reactive mode are strongly (222) oriented. Compared to undoped In₂O₃ all samples have an enlarged lattice. The lattice strain perpendicular to the surface is about 0.8% and 2.0% for films grown in the transition and the reactive mode, respectively. Deposition in the transition mode introduces a biaxial film stress in the range of −300 MPa, while stress in reactive mode samples is −1500 MPa.     

Dilute sulfuric acid pretreatment of corn stover at high solids concentrations

Applied Biochemistry and Biotechnology - The enzymatic digestibility of a pretreated substrate is enhanced by increasing the severity of the pretreatment conditions, apparently because a greater...     

On Aging of Acid-Catalyzed Silica Sols—A Dynamic Light Scattering Study

Dynamic light scattering experiments in acid-catalyzed silica sols are discussed. It is shown that in spite of limited parameter accuracy and limited absolute knowledge of the particle sizes, the scattering data from various experiments are comparable with one another and give information about structural differences. Measurements at various angles indicate changes between non-spherical and nearly spherical particles and allow the estimation of gelling times before gelation.     

Zur Elektronenstruktur metallorganischer Komplexe der f‐Elemente. 64 Äußert sich die zwitterionische Natur des Triphenylphosphanoxid‐Liganden auch in seinen spektrochemischen Eigenschaften?

Electronic Structures of Organometallic Compounds of f Elements. 64 Does the Zwitterionic Nature of the Triphenylphosphine Oxide Ligand Manifest itself in its Spectrochemical Properties? The triphenylphosphine oxide mono adducts of the moiety tris(η⁵‐cyclopentadienyl)lanthanide(III) (Ln(Cp)₃; Ln = Pr ( 1 ), La ( 2 )) were synthesized and structurally characterized. The Ln–O distances of these compounds are noticeably shorter than those of the corresponding THF adducts. A crystal field (CF) analysis of the optical spectra of 1 leads to a low absolute value of the quadratic CF parameter which is comparable with those of [Pr(Cp)₃(L)]^? adducts with anionic bases but not with [Pr(Cp)₃(MeTHF)]. Reasons for the latter finding are presented.     

Synthese und Fluoreszenzeigenschaften von cyansubstituierten 2-Aminopyridinen

The synthesis of several 2-aminopyridines is described. The reaction of tetracyanoethylene with 3-imino-propane-carbonitrile gives 2-amino-3,4,5-tricyano-pyridines with alkyl and aryl-substituents, resp., in position 6. Nucleophilic substitution of 2-amino-6-chloro-3,5-dicyanopyridines and 2-amino-6-chloro-3,4,5-tricyano-pyridines with phenolates leads to a variety of pyridines. Spectroscopical data of absorption and fluorescence are presented and the influence of the cyano groups is discussed. The results are in good agreement with quantum chemical calculations (PPP).

Herrn Univ-Prof. Dr.A. Holasek zum 60. Geburtstag gewidmet.     

The determination of manganese by electrothermal atomic absorption spectrometry with a graphite furnace at constant temperature

Many of the interferences reported earlier for the determination of manganese in a graphite furnace were not found when a modern graphite furnace was used. At high levels of chloride matrix, an interference which was observed in the modern furnace was reduced when manganese was determined under constant temperature conditions. In this work, the sample was introduced on a tungsten wire after the graphite furnace had reached a constant, preset temperature. Drying and ashing were accomplished outside the atomization furnace, reducing contamination from matrix materials.     

Lower bounds for faithful,preinjective modules

Let be the path algebra for some representation-infinite quiver over some field k. There exists a bound such that ^mI is faithful for all indecomposable injective -modules I and all , and such that there exists an indecomposable injective -module J satisfying that J is not faithful, denotes the Auslander-Reiten-translation. Let m() be the maximum of the taken over all possible orientations of the underlying graph . In this article we determine the bounds m() for representation-infinite quivers for which is a tree.