The hydrophobic effect in aqueous solutions of nonelectrolytes. I. Self-interactions of alkylureas

In order to clarify some aspects of the hydrophobic interactions, the enthalpies of dilution of monoethylurea, 1,3-dimethylurea, and 1,3-diethylurea have been determined calorimetrically at 25°C. The calorimetric data, expressed in terms of excess enthalpy, permit the evaluation of the pair and triplet interaction coefficients. The analyses of these and of the analogous coefficientsg _xx andg _xxx, derived from osmotic data, indicate a driving force favorable to the interactions among the hydrated solute molecules. Nevertheless, the positive values of theh _xx andh _xxx coefficients seem to suggest that the source of the effect is a rearrangement of the water molecules rather than a direct association of the solute molecules. There are evidences of a strict correlation between the enthalpic and the entropic effects. Preliminary data were presented at the International Conferences on Chemical Thermodynamics at Baden (1973) and Montpellier (1975). The experimental part was carried out at the Istituto Chimico of the University of Trieste. To whom correspondence should be addressed.     

Implementation of the finite field perturbation method in the CRYSTAL program for calculating the dielectric constant of periodic systems

The finite field approach has been implemented in the periodic ab initio CRYSTAL program and been used for calculating the dielectric constants of crystalline LiF and MgO (FCC structure) and BeO (wurtzite structure). To maintain the periodicity along the applied field direction, a "sawtooth" potential is used in conjunction with a supercell scheme. Supercells four to five times longer than the primitive cell in the direction of the applied field provide well-converged results. The influence of the computational parameters is discussed. An alternative scheme has also been implemented, for inner check, that consists of applying a static electric field to a slab of increasing thickness in the direction orthogonal to the surface; the dielectric response at the center of the slab is shown to converge rapidly to the bulk value evaluated with the sawtooth field. The method is accurate and permits the determination of nonlinear corrections to the dielectric constant. When used in conjunction with the local density approximation (LDA) scheme, it provides for the dielectric constant of the three above-mentioned compounds values close to those recently obtained with a time-dependent density functional theory approach.     

Total synthesis of (+)-aspidospermidine: a new strategy for the enantiospecific synthesis of aspidosperma alkaloids

A new strategy was developed for the enantiospecific synthesis of aspidosperma alkaloids. The key steps involve a novel ketene-lactonization reaction of a chiral vinyl sulfoxide to efficiently set up the quaternary carbon center, and a tandem Michael addition-alkylation reaction sequence to form the polycyclic core structure. This new strategy was employed in the total synthesis of natural product (+)-aspidospermidine.     

Gas chromatographic/mass spectrometric determination of 3-methoxy-1,2-propanediol and cyclic diglycerols, by-products of technical glycerol, in wine: interlaboratory study

The aim of the present study was to provide the official wine control authorities with an internationally validated method for the determination of 3-methoxy-1,2-propanediol (3-MPD) and cyclic diglycerols (CycDs)-both of which are recognized as impurities of technical glycerol-in different types of wine. Because glycerol gives a sweet flavor to wine and contributes to its full-body taste, an economic incentive is to add glycerol to a wine to mask its poor quality. Furthermore, it is known that glycerol, depending on whether it is produced from triglycerides or petrochemicals, may contain considerable amounts of 3-MPD in the first case or CycDs in the second. However, because these compounds are not natural wine components, it is possible to detect glycerol added to wine illegally by determining the above-mentioned by-products. To this end, one of the published methods was adopted, modified, and tested in a collaborative study. The method is based on gas chromatographic/mass spectrometric analysis of diethyl ether extracts after salting out with potassium carbonate. The interlaboratory study for the determination of 3-MPD and CycDs in wine was performed in 11 laboratories in 4 countries. Wine samples were prepared and sent to participants as 5 blind duplicate test materials and 1 single test material. The concentrations covered ranges of 0.1-0.8 mg/L for 3-MPD and 0.5-1.5 mg/L for CycDs. The precision of the method was within the range predicted by the Horwitz equation. HORRAT values obtained for 3-MPD ranged from 0.8 to 1.7, and those obtained for CycDs ranged from 0.9 to 1.3. Average recoveries were 104 and 109%, respectively.     

Quantum mechanical calculations of conformationally relevant 1H and 13C NMR chemical shifts of calixarene systems

[graphs: see text] QM GIAO calculations of 13C and 1H chemical shift values of the ArCH2Ar group have been performed, using the hybrid DFT functional MPW1PW91 and the 6-31G(d,p) basis set, on some representative calixarenes and on a series of simplified calixarene models allowing derivation of chemical shift surfaces versus phi and chi dihedral angles. A good reproduction of experimental data was obtained. The applicability of chemical shift surfaces in the study of calixarene conformational features is illustrated.     

Determination of humic acid by chemiluminescence

The analytical utility of the chemiluminescence resulting from the reaction of humic acid with permanganate is investigated. The chemiluminescence response curve rises sharply to a peak value at about 0.5 s after mixing and decays somewhat more slowly. The peak signal for a fixed humic acid concentration is shown to pass through a maximum near a permanganate concentration of 17 μmol l^-1 and to increase continuously with potassium hydroxide concentration up to 2.0 mol l^-1. Calibration plots of peak signal vs. humic acid concentration exhibit complex behaviour, being approximately linear up to about 20 mg l^-1, curving slightly toward the concentration axis up to about 40 mg l^-1, and then curving away from the concentration axis above 40 mg l^-1. The detection limit for humic acid is about 0.7 mg l^-1. No interference is observed for thirteen common inorganic species at typical levels in water samples. Substantial differences are observed for humic acid in selected samples determined by the chemiluminescence and visible absorption procedures.     

Measuring intracellular calcium fluxes in high throughput mode

The measurement of intracellular calcium fluxes in real time is widely applied within the pharmaceutical industry to measure the activation of G-protein coupled receptors (GPCRhyp;s), either for pharmacological characterisation or to screen for new surrogate ligands. Initially restricted to G(q) coupled GPCRs, the introduction of promiscuous and chimeric G-proteins has further widened the application of these assays. The development of new calcium sensitive dyes and assays has provided sensitive, homogeneous assays which can be readily applied to high throughput screening (HTS). In this paper we describe the full automation of this assay type using a fluorometric imaging plate reader (FLIPR ) integrated into a Beckman/Sagian system to establish a simple robotic system that is well suited for the current medium throughput screening in this area of lead discovery. Using a recently completed HTS we discuss important determinants for FLIPR based screening, highlight some limitations of the current approach, and look at the requirements for future automated systems capable of keeping up with expanding compound files.     

Trinuclear heterobimetallic complexes with binucleating dithioxamides: stereoselective synthesis and solution behavior involving Pd-N bond rupture

Bischelate platinum(II) complexes of the type [Pt(H-R(2)-N(2)C(2)S(2))(2)] (H-R(2)-N(2)C(2)S(2)(-) = dialkyl-dithioxamidate) are ditopic receptors which, after coordination of the first Pd(eta(3)-allyl)(+) moiety, induce the orientation of the second palladium-allyl fragment. Thus, a series of trimetallic complexes of formula bis-[(eta(3)-allyl)-palladium(II)](mu-bis-dialkyl-dithioxamidate-platinum(II) kappa-S,S-kappa-S',S'-Pt-kappa-N,N-Pd-kappa-N',N'-Pd') has been prepared in which the allyl fragments are oriented toward the same side of the molecular plane. We have also prepared the trimetallic complex using a dithioxamide obtained from the racemic phenylethylamine. Only two isomers were produced in equimolar ratio: the racemate that has four homochiral alkyl substituents and the mesoform containing the meso-dithioxamide that has homochiral substituents on the same side of molecular plane. Under the effect of the temperature, the trimetallic Pd-Pt-Pd complexes undergo rapid allyl isomerization; the mechanism of the isomerization, which is similar to that found by us in an analogue Pt-Pd bimetallic complex, is discussed. The crystal and molecular structure of bis-[(eta(3)-allyl)-palladium(II)](mu-bis-[S]-phenylethyl-dithioxamidate-platinum(II) kappa-S,S-kappa-S',S'-Pt-kappa-N,N-Pd-kappa-N',N'-Pd') has been reported.     

Unsymmetrically substituted furoxans. Part 16 . Reaction of benzenesulfonyl substituted furoxans with ethanol and ethanethiol in basic medium

The use of benzenesulfonyl substituted furoxans as flexible intermediates for the synthesis of new functionalized furoxans interesting for their potential biological properties is discussed. Reaction of benzenesul-fonylphenylsulfonylfuroxan isomers 7a and 7b with ethanol and ethanethiol in basic medium affords the expected ethers and sulphides respectively. Reaction of bis(benzenesulfonyl)furoxan ( 1 ) with ethanol in basic medium gives 3-benzenesulfonyl-4-ethoxyfuroxan ( 2 ) or diethoxyfuroxan (3), according to the experimental procedure. In contrast the reaction of 1 with ethanethiol gives a mixture of substitution compounds and the 4-benzenesulfonyl-3-ethylthiofurazan ( 11 ). The structure of the compounds has been assigned by nmr spectroscopy and, in the case of 3-benzenesulfonyl-4-ethylthiofuroxan ( 9b ), confirmed by X-ray analysis.     

Search of ligands for the amyloidogenic protein beta2-microglobulin by capillary electrophoresis and other techniques

Beta2-microglobulin (beta2-m) is a small amyloidogenic protein normally present on the surface of most nucleated cells and responsible for dialysis-related amyloidosis, which represents a severe complication of long-term hemodialysis. A therapeutic approach for this amyloidosis could be based on the stabilization of beta2-m through the binding to a small molecule, and consequent inhibition of protein misfolding and amyloid fibril formation. A few compounds have been described to weakly bind beta2-m, including the drug suramin. The lack of a binding site for nonpolypeptidic ligands on the beta2-m structure makes it difficult for both the identification of functional groups responsible for the binding and the search of hits to be optimized. The characterization of the binding properties of suramin for beta2-m by using three different techniques (surface plasmon resonance, affinity CE (ACE), ultrafiltration) is here described and the results obtained are compared. The common features of the chemical structures of the compounds known to bind the protein led us to select 200 sulfonated/suramin-like molecules from a wider chemical library on the basis of similarity rules, so as to possibly single out some interesting hits and to gain more information on the functional groups involved in the binding. The development of screening methods to test the compounds by using ultrafiltration and ACE is described.