Identification of the lamination stack's behavior simulated with a multi-scale homogenization using a progressive contact formulation

The influence of the lamination stack on the mechanical behavior of an electrical motor is significant, especially for lightweight designs. Information about the stack's behavior is relevant for a proper calculation of the whole motor. This behavior is dependent on the contact between the single sheets resulting from the roughness and the behavior of the roughness peaks. The normal behavior is an elasto-plastic and progressive one, which results mainly of the number of roughness peaks in contact. Whereas the tangential micro-slip behavior is dependent on the single contacts and the friction coefficient. Both behaviors can be described by models and thus it is possible to calculate the behavior of a whole stack using an homogenization based on representative volume elements. (© 2014 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim)     

Characterization of the Nonemptiness and Compactness of Solution Sets in Convex and Nonconvex Vector Optimization

As a consequence of an abstract theorem proved elsewhere, a vector Weierstrass theorem for the existence of a weakly efficient solution without any convexity assumption is established. By using the notion (recently introduced in an earlier paper) of semistrict quasiconvexity for vector functions and assuming additional structure on the space, new existence results encompassing many results appearing in the literature are derived. Also, when the cone defining the preference relation satisfies some mild assumptions (but including the polyhedral and icecream cones), various characterizations for the nonemptiness and compactness of the weakly efficient solution set to convex vector optimization problems are given. Similar results for a class of nonconvex problems on the real line are established as well.Research supported in part by Conicyt-Chile through FONDECYT 104-0610 and FONDAP-Matemáticas Aplicadas II.     

The first total synthesis of (-)-tamandarin A

[formula: see text] Tamandarin A (1), a newly isolated natural product similar in structure to didemnin B (2), was shown to be somewhat more active in vitro than 2 against pancreatic carcinoma with an ED50 value 1.5 to 2 ng/mL. We report here the first total synthesis of 1. The key steps include a practical stereoselective synthesis of the Hiv-isostatine unit, high-yielding linear precursor formation, a successful macrocyclization, and coupling of the macrocycle with the side chain to afford tamandarin A (1).     

Validation of a screening method for the simultaneous identification of fat-soluble and water-soluble vitamins (A,E, B<Subscript>1</Subscript>, B<Subscript>2</Subscript> and B<Subscript>6</Subscript>) in an aqueous micellar medium of hexadecyltrimethylammonium chloride

Simultaneous determination of the fat-soluble vitamins A and E and the water-soluble vitamins B₁, B₂ and B₆ has been carried using a screening method from fluorescence contour graphs. These graphs show different colour zones in relation to the fluorescence intensity measured for the pair of excitation/emission wavelengths. The identification of the corresponding excitation/emission wavelength zones allows the detection of different vitamins in an aqueous medium regardless of the fat or water solubility of each vitamin, owing to the presence of a surfactant which forms micelles in water at the used concentration (over the critical micelle concentration). The micelles dissolve very water insoluble compounds, such as fat-soluble vitamins, inside the aggregates. This approach avoids the use of organic solvents in determining these vitamins and offers the possibility of analysing fat- and water-soluble vitamins simultaneously. The method has been validated in terms of detection limit, cut-off limit, sensitivity, number of false positives, number of false negatives and uncertainty range. The detection limit is about g L^–1. The screening method was applied to different samples such as pharmaceuticals, juices and isotonic drinks.     

Ester-additives as inhibitors of the gelification of soybean oil methyl esters in biodiesel

Biodiesel from soybean oil transesterified with methanol (TSO) becomes viscous and gelifies at low storage temperatures which makes it difficult to pump. To inhibit this behaviour bulky esters were added to reduce the crystallization temperature of TSO and to modify the rate of conversion of crystallized mass. This rate was found to follow a JMAK kinetic model. The Avrami’s parameter n was constant for TSO, while two n values were found for TSO-additive solutions, meaning that the additives first slowed down the rate of nucleation and, later on as enough nuclei had been formed, crystal growth rate dominated and the previous crystallization rate was recovered.     

Response surface optimisation applied to a headspace-solid phase microextraction-gas chromatography-mass spectrometry method for the analysis of volatile organic compounds in water matrices

A new method for the simultaneous determination of 12 volatile organic compounds (trans-1,2-dichloroethene, 1,1,1-trichloroethane, benzene, 1,2-dichloroethane, trichloroethene, toluene, 1,1,2-trichloroethane, tetrachloroethene, ethylbenzene, m-, p-, o-xylene) in water samples by headspace solid phase microextraction (HS–SPME)–gas chromatography mass spectrometry (GC–MS) was described, using a 100?µm PDMS (polydimethylsiloxane) coated fibre. The response surface methodology was used to optimise the effect of the extraction time and temperature, as well as the influence of the salt addition in the extraction process. Optimal conditions were extraction time and temperature of 30?min and ?20°C, respectively, and NaCl concentration of 4?mol?L^?1. The detection limits were in the range of 1.1?×?10^?3–2.3?µg?L^?1 for the 12 volatile organic compounds (VOCs). Global uncertainties were in the range of 4–68%, when concentrations decrease from 250?µg?L^?1 down to the limits of quantification. The method proved adequate to detect VOCs in six river samples.     

Evaluation of GSH adducts of adrenaline in biological samples

The sustained high release of catecholamines to circulation is a deleterious condition that may induce toxicity, which seems to be partially related to the products formed by oxidation of catecholamines that can be further conjugated with glutathione (GSH). The aim of the present study was to develop a method for the determination of GSH adducts of adrenaline in biological samples. Two position isomers of the glutathion-S-yl-adrenaline were synthesized and characterized by HPLC using diode array, coulometric and mass detectors. A method for the extraction of these adducts from human plasma was also developed, based on adsorption to activated alumina, which showed adequate recoveries and proved to be crucial in removing interferences from plasma. The selectivity, precision and linearity of the method were all within the accepted values for these parameters. Furthermore, the sensitivity of this method allows the detection of adduct amounts that are within the range of the expected concentrations for these adducts under certain pathophysiological conditions and/or drug treatments. In conclusion, the development of this method allows the direct analysis of GSH adducts of adrenaline in human plasma, providing a valuable tool for the study of the catecholamine oxidation process and its related toxicity.     

Metal oxidation states in biological water splitting

A central question in biological water splitting concerns the oxidation states of the manganese ions that comprise the oxygen-evolving complex of photosystem II. Understanding the nature and order of oxidation events that occur during the catalytic cycle of five S_i states (i = 0–4) is of fundamental importance both for the natural system and for artificial water oxidation catalysts. Despite the widespread adoption of the so-called “high-valent scheme”—where, for example, the Mn oxidation states in the S₂ state are assigned as III, IV, IV, IV—the competing “low-valent scheme” that differs by a total of two metal unpaired electrons (i.e. III, III, III, IV in the S₂ state) is favored by several recent studies for the biological catalyst. The question of the correct oxidation state assignment is addressed here by a detailed computational comparison of the two schemes using a common structural platform and theoretical approach. Models based on crystallographic constraints were constructed for all conceivable oxidation state assignments in the four (semi)stable S states of the oxygen evolving complex, sampling various protonation levels and patterns to ensure comprehensive coverage. The models are evaluated with respect to their geometric, energetic, electronic, and spectroscopic properties against available experimental EXAFS, XFEL-XRD, EPR, ENDOR and Mn K pre-edge XANES data. New 2.5 K ⁵⁵Mn ENDOR data of the S₂ state are also reported. Our results conclusively show that the entire S state phenomenology can only be accommodated within the high-valent scheme by adopting a single motif and protonation pattern that progresses smoothly from S₀ (III, III, III, IV) to S₃ (IV, IV, IV, IV), satisfying all experimental constraints and reproducing all observables. By contrast, it was impossible to construct a consistent cycle based on the low-valent scheme for all S states. Instead, the low-valent models developed here may provide new insight into the over-reduced S states and the states involved in the assembly of the catalytically active water oxidizing cluster.