Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.     

Ground-state properties of LiV2O4 and Li1-xZnx(V1-yTiy)2O4

We present susceptibility, microwave resistivity, NMR and heat-capacity results for Li_1-xZn_x(V_1-yTi_y)₂O₄ with 0 ? x ? 0.3 and 0 ? y ? 0.3. For all doping levels the susceptibility curves can be fitted with a Curie-Weiss law. The paramagnetic Curie-Weiss temperatures remain negative with an average value close to that of the pure compound Θ≈ - 36 K. Spin-glass anomalies are observed in the susceptibility, heat-capacity and NMR measurements for both type of dopants. From the temperature dependence of the spin-lattice relaxation rate we found critical-dynamic behavior in the Zn doped compounds at the freezing temperatures. For the Ti-doped samples two successive freezing transitions into disordered low-temperature states can be detected. The temperature dependence of the heat capacity for Zn-doped compounds does not resemble that of canonical spin glasses and only a small fraction of the total vanadium entropy is frozen at the spin-glass transitions. For pure LiV₂O₄ the spin-glass transition is completely suppressed. The temperature dependence of the heat capacity for LiV₂O₄ can be described using a nuclear Schottky contribution and the non-Fermi liquid model, appropriate for a system close to a spin-glass quantum critical point. Finally an ( x / y , T )-phase diagram for the low-doping regime is presented. Received 16 March 2001 and Received in final form 30 October 2001     

Changes in the kurtosis parameter of super-Gaussian beams passing through a spherically aberrated lens

Based on the Collins formula and irradiance moments definition, the propagation of the kurtosis parameter of super-Gaussian beams through a spherically aberrated lens is studied. Detailed numerical results are given. It is shown that, as compared with aberration-free super-Gaussian beams, the profile of spherically aberrated super-Gaussian beams can be leptokurtic, mesokurtic or platykurtic, depending on the aberration and propagation distance. The results for the spherically aberrated Gaussian beams can be dealt with as a special case treated in this paper. Finally, the advantage of our method is pointed out.     

Electron–hole complexes in self-assembled quantum dots in strong magnetic fields

We present results of calculations and experiments on electron–hole complexes in InGaAs/GaAs self-assembled quantum dots in high magnetic field (B). Due to hidden symmetries, the chemical potential of an N-exciton system at special B fields becomes insensitive to the exciton number as well as the magnetic field. This results in plateau regions of high intensity in measured magneto-PL spectrum. Theoretical calculations using exact diagonalization techniques successfully explain the measured magneto-photoluminescence spectrum with B fields up to 28 T.     

Conformational analysis of dipeptide‐derived polyisocyanides

The conformational properties of polymers derived from isocyanodipeptides have been investigated with a combination of model calculations, X‐ray diffraction, and circular dichroism spectroscopy. Depending on the configuration of the side chains, defined arrays of hydrogen bonds along the polymeric backbone are formed. This leads to a well‐defined conformation as, for example, expressed in the formation of lyotropic liquid‐crystalline phases and increased helical stability. Upon the disruption of the hydrogen bonds by a strong acid, a less well‐defined macromolecular conformation is observed. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 1725–1736, 2003     

Analysis of tunable diode-laser spectra of Q(J,0) lines in CH3F near 1475 cm using a multispectrum fitting technique

We have analyzed the methyl fluoride ^RQ(J,0)Q branch lines located near 1475 cm⁻¹ using a simultaneous multi-spectrum fitting technique. In this analysis we have used previously recorded diode-laser data in which we collected many data points covering only one or two Q branch lines in a particular run. The analysis consists of simultaneously fitting 57 spectra collected with numerous pressure and path length conditions for all absorption lines. The data are concatenated to create one continuous spectrum of the Q branch. We have determined the intensity and self-broadened widths at 296 K for 23 ^RQ(J,0) lines.     

Investigation of organic impurities adsorbed on and incorporated into electroplated copper layers

At room temperature electroplated copper layers exhibit changes in resistivity, residual stress, and microstructure. This process, known as self-annealing, is intimately linked to the release of organic impurities, which stem from the incorporation of organic additives into the Cu layer in the course of the electroplating process. The behavior of these impurities during self-annealing, represented by the carbon content, could be detected by analytical radio frequency glow discharge optical emission spectrometry (GD-OES) and carrier gas hot extraction (CGHE). The precondition of a quantitative determination is a surface cleaning procedure to remove adsorbed organics from the copper surface. It was observed that at first almost all impurities have to leave the Cu metallization before an accelerated abnormal grain growth can start. The small amount of remaining organic species after self-annealing could be quantified by both examination techniques, GD-OES and CGHE.