BRD96N光调制吸收增强现象的实验研究

通过光谱响应特性实验和记录／读出图像实验，研究了基因变异型细菌视紫红质（BR_D96N）分子膜对单色光的光调制特性.发现BR_D96N分子膜在550nm—600nm范围内对调制光有吸收增强的现象，且对此范围内不同波长的单色光其调制程度有差异.利用曲线拟和方法发现550nm—600nm吸收增强的变化过程分为快过程和慢过程，其对应的时间常数分别为30s和5min.利用强度调制器的吸收强度与图像灰度之间的关系，分析了560nm—600nm范围内出现图像反转的实验现象. 关键词： 细菌视紫红质D96N分子膜 光谱响应 吸收增强现象 图像反转现象     

涡旋柔性弹簧及组件性能实验研究

本文利用TSL系列弹簧刚度实验仪对用于斯特林制冷机中的单片柔性弹簧及柔性弹簧组件进行了实验研究。测试了四种不同尺寸弹簧刚度的动态特性,研究了单片弹簧的轴向刚度、径向刚度以及力矩特性,然后对柔性弹簧组件进行了实验研究,指出了不同组合方法下的刚度及弯矩特性,得到的数据可以作为斯特林制冷机设计的参考。     

Novel UV‐induced photografting process for preparing poly(tetrafluoroethylene)‐based proton‐conducting membranes

A novel process comprising the UV‐induced photografting of styrene into poly(tetrafluoroethylene) (PTFE) films and subsequent sulfonation has been developed for preparing proton‐conducting membranes. Although under UV irradiation the initial radicals were mainly generated on the surface of the PTFE films by the action of photosensitizers such as xanthone and benzoyl peroxide, the graft chains were readily propagated into the PTFE films. The sulfonation of the grafted films was performed in a chlorosulfonic acid solution. Fourier transform infrared and scanning electron microscopy were used to characterize the grafted and sulfonated membranes. With a view to use in fuel cells, the proton conductivity, water uptake, and mechanical properties of the prepared membranes were measured. Even through the degree of grafting was lower than 10%, the proton conductivity in the thickness direction of the newly prepared membranes could reach a value similar to that of a Nafion membrane. In comparison with γ‐ray radiation grafting, UV‐induced photografting is very simple and safe and is less damaging to the membranes because significant degradation of the PTFE main chains can be avoided. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2624–2637, 2007     

关于有界域的逆紧映照

本文对近20年来多复变函数的一个发展迅速的数学热门分支－逆紧映照作了一个回顾和整理。这是作者继续从事此方向研究的先声，也希望本文能为有志于此的研究者提供一些便利。本文从经典的结果开始，通过对逆紧映照在边界上的开拓及分支点的分布的讨论，详细地阐述了这些年来关于逆紧映照何时成为双全纯映照的若干结果。最后，对近年来关于逆紧映照另外的一些工作进行了简单的介绍。     

全固态多波长飞秒脉冲激光系统

利用棱镜对引进频谱空间啁啾来补偿飞秒脉冲激光二次谐波产生中的相位失配,提高了倍频效率建立了一套全固态、多波长(1065nm, 532nm,823.1nm, 402nm)飞秒脉冲激光系统自制的Nd:YVO4激光器输出532nm绿光激光,最高平均功率可达5.6W当用2.5W绿光激光泵浦时,从自制的钛宝石激光器及经BBO倍频可分别输出中心波长为823.1nm和402nm,平均功率300mW和73mW,谱宽32.3nm和5.1nm,脉宽22fs和33.3fs、重复率108MHz的近红外和蓝光激光整个系统具有结构紧凑、倍频效率高、运行稳定的特点.     

Simulation and fabrication of carbon nanotubes field emission pressure sensors

A novel field emission pressure sensor has been achieved utilizing carbon nanotubes (CNTs) as the electron source. The sensor consists of the anode sensing film fabricated by wet etching process and multi-wall carbon nanotubes (MWNTs) cathode in the micro-vacuum chamber. MWNTs on the silicon substrate were grown by thermal CVD. The prototype pressure sensor has a measured sensitivity of about 0.17-0.77 nA/Pa (101-550 KPa). The work shows the potential use of CNTs-based field-emitter in microsensors, such as accelerometers and tactile sensors.