软X射线激光偏折法测量激光等离子体电子密度分布

利用脉宽约为50ps的类镍银139nm软X射线激光作为探针,探测由脉宽80ps的驱动激光打C8H8靶产生的等离子体在1ns后的电子密度分布信息,获得了清晰的莫尔条纹图像.对结果的处理,给出了峰值电子密度为11×1021cm-3,并对在靶面附近莫尔条纹的消失现象作了初步解释 关键词： 软X射线激光探针 莫尔条纹 等离子体电子密度     

改进型Czerny-Turner成像光谱仪光学系统设计方法

像散是目前影响Czerny-Turner结构成像光谱仪空间分辨率最大的像差。首先引入柱面反射镜,利用光焦度衡量像散大小,推导出易于计算的像散校正公式,有效地校正了像散。给出准直镜到光栅距离的计算方法,有效校正了成像光谱仪边缘视场像差。给出了成像光谱仪像面倾角的计算方法,实现了宽波段的像差校正。最终利用上述方法设计了一套用于115～200nm的改进型Czerny-Turner成像光谱仪,焦距f′=48mm,F数为5.0,全视场、全波段调制传递函数(MTF)在0.7以上。全波段光谱分辨率为0.22nm,像面大小为8mm×7mm。设计方法适用于多种结构要求的成像光谱仪。     

用时间分辨光谱研究红细胞悬液的荧光发射

实验获得了激光照射红细胞悬液的荧光光谱,并分别监测不同荧光峰值波长处强度随时间的衰变过程,测试了其相应的荧光寿命。结果表明,在波长为407nm的激光照射下,红细胞悬液向外发射中心波长分别位于596,628,692nm的荧光光谱,各荧光峰对应衰变过程的平均荧光寿命分别为1.97,13.31,14.58ns。利用荧光强度和吸收率的加和性表示了混合物的总吸收率和总荧光发射强度,通过理论计算获得了红细胞悬液中锌卟啉、原卟啉和其他游离物参与荧光发射的相对含量和相对强度在不同荧光峰位的变化关系,进一步解释了不同峰位处荧光发射强度和平均荧光寿命的变化原因。     

Fabrication and luminescence behavior of phosphate glass ceramics co-doped with Er3+ and Yb3+

Transparent phosphate glass ceramics co-doped with Er³⁺ and Yb³⁺ in the system P₂O₅Li₂OCaF₂TiO₂ were successfully synthesized by melt-quenching and subsequent heating. Formation of the nanocrystals was confirmed by X-ray powder diffraction. Judd–Ofelt analyses of Er³⁺ ions in the precursor glasses and glass ceramics were performed to evaluate the intensity parameters Ω_2,4,6. Under 975 nm excitation, intense upconversion (UC) and infrared emission (1545 nm) were observed in the glass ceramics by efficient energy transfer from Yb³⁺ to Er³⁺. The luminescence processes were explained and the emission cross section was calculated by Fuchtbauer–Ladenburg (F–L) formula. The results confirm the potential applications of Er³⁺/Yb³⁺ co-doped glass ceramics as laser and fiber amplifier media.     

First-principles study of structural stability and elastic property of pre-perovskite PbTiO3

The structural stability and the elastic properties of a novel structure of lead titanate,which is named preperovskite PbTiO₃ （PP-PTO） and is constructed with TiO₆ octahedral columns arranged in a one-dimensional manner,are investigated by using first-principles calculations.PP-PTO is energetically unstable compared with conventional perovskite phases,however it is mechanically stable.The equilibrium transition pressures for changing from preperovskite to cubic and tetragonal phases are 0.5 GPa and 1.4 GPa,respectively,with first-order characteristics.Further,the differences in elastic properties between pre-perovskite and conventional perovskite phases are discussed for the covalent bonding network,which shows a highly anisotropic character in PP-PTO.This study provides a crucial insight into the structural stabilities of PP-PTO and conventional perovskite.     

Doctor-bladed Cu2ZnSnS4 light absorption layer for low-cost solar cell application

The doctor-blade method is investigated for the preparation of Cu2ZnSnS4 films for low-cost solar cell application.Cu2ZnSnS4 precursor powder,the main raw material for the doctor-blade paste,is synthesized by a simple ball-milling process.The doctor-bladed Cu2ZnSnS4 films are annealed in N2 ambient under various conditions and characterized by X-ray diffraction,ultraviolent/vis spectrophotometry,scanning electron microscopy,and current-voltage(J-V) meansurement.Our experimental results indicate that(i) the X-ray diffraction peaks of the Cu2ZnSnS4 precursor powder each show a red shift of about 0.4°;(ii) the high-temperature annealing process can effectively improve the crystallinity of the doctor-bladed Cu 2 ZnSnS 4,whereas an overlong annealing introduces defects;(iii) the band gap value of the doctor-bladed Cu 2 ZnSnS 4 is around 1.41 eV;(iv) the short-circuit current density,the open-circuit voltage,the fill factor,and the efficiency of the best Cu2ZnSnS4 solar cell obtained with the superstrate structure of fluorine-doped tin oxide glass/TiO2/In2S3/Cu2ZnSnS4/Mo are 7.82 mA/cm2,240 mV,0.29,and 0.55%,respectively.     

全光纤脉冲压缩器的理论及实验研究

对色散位移光纤＋普通单模光纤构成的全光纤脉冲压缩器进行了理论分析，分析了压 缩效果与光纤参数及输入脉冲参数的关系；对不同中心波长和脉宽的主动锁模光纤激光器的 输出脉冲进行了压缩实验，均得到了近变换限Sech的压缩脉冲，实验结果与理论分析一致. 关键词： 全光纤脉冲压缩器 压缩因子 基座能量 主动谐波锁模光纤 激光器     

Fe/Si多层膜的层间耦合与界面扩散

对以本征Si及重掺杂ｐ型和ｎ型Si作为中间层的Fe/Si多层膜的层间耦合进行研究，并通过退火，增大Fe，Si之间的扩散，分析界面扩散对层间耦合的影响. 实验结果表明，层状结构良好的制备态的多层膜，Fe，Si之间也存在一定程度的扩散，它是影响层间耦合的 主要因素，远远超过了半导体意义上的重掺杂，使不同种类的Si作为中间层的层间耦合基本 一致.进一步还发现，在一定范围内增大Fe，Si之间的扩散，即使多层膜的层状结构已经有了相当的退化，Fe/Si多层膜的反铁磁耦合强度基本保持不变. 关键词： Fe/Si多层膜 层间耦合 界面扩散