Synthesis,characterization and biodistribution of 99mTc-Bioquin-HMPAO (99mTc-BH) as a novel brain imaging agent

Recently, the development of novel brain imaging agents has aroused much interest thanks to limited number of brain cancer or diseases diagnosis agents. It is aimed to synthesize a novel brain imaging agent including a promise for further studies on AD diagnosis potential and investigate its bioaffinity with biodistribution studies on healthy Balb/c mice. A novel radiolabeled agent was synthesized and characterized. Quality control of ^99mTc-BH was performed utilizing solvent extraction and chromatographic (Radio TLC and Radio HPLC) methods. Bioaffinity of the ^99mTc-BH was investigated on male Balb/c mice at various time points (5, 30, 60, 120 min post-injection). Paper electrophoresis showed that ^99mTc-BH has a neutral structure. Radiochemical purity of ^99mTc-BH was over 95 % with appropriate stability for imaging period. Selected brain regions have uptakes over 4 % ID/g following intravenous injection. Hippocampus has uptake approximately 10 % ID/g. ^99mTc-BH has shown brain uptake, so it may prove to be valuable for brain imaging as a novel technetium-labeled agent. Further investigations with AD animal model are our on going effort to show that this agent has AD diagnosis potential.     

Simultaneous determination of seven phthalic acid esters in beverages using ultrasound and vortex‐assisted dispersive liquid–liquid microextraction followed by high‐performance liquid chromatography

A sensitive, rapid, and simple high‐performance liquid chromatography with UV detection method was developed for the simultaneous determination of seven phthalic acid esters (dimethyl phthalate, dipropyl phthalate, di‐n‐butyl phthalate, benzyl butyl phthalate, dicyclohexyl phthalate, di‐(2‐ethylhexyl) phthalate, and di‐n‐octyl phthalate) in several kinds of beverage samples. Ultrasound and vortex‐assisted dispersive liquid–liquid microextraction method was used. The separation was performed using an Intersil ODS‐3 column (C₁₈, 250 × 4.6 mm, 5.0 μm) and a gradient elution with a mobile phase consisting of MeOH/ACN (50:50) and 0.2 M KH₂PO₄ buffer. Analytes were detected by a UV detector at 230 nm. The developed method was validated in terms of linearity, limit of detection, limit of quantification, repeatability, accuracy, and recovery. Calibration equations and correlation coefficients (> 0.99) were calculated by least squares method with weighting factor. The limit of detection and quantification were in the range of 0.019–0.208 and 0.072–0.483 μg/L. The repeatability and intermediate precision were determined in terms of relative standard deviation to be within 0.03–3.93 and 0.02–4.74%, respectively. The accuracy was found to be in the range of –14.55 to 15.57% in terms of relative error. Seventeen different beverage samples in plastic bottles were successfully analyzed, and ten of them were found to be contaminated by different phthalic acid esters.     

Corrosion prevention of mild steel in acidic medium by 2-Pyrrolidin-1-yl-1,3-thiazole-5-carboxylic acid: Theoretical and experimental approach

The inhibition efficiency of 2-Pyrrolidin-1-yl-1,3-thiazole-5-carboxylic acid (PTCA) against mild steel (MS) corrosion was investigated in acidic solution by using quantum chemical calculations based on Density Functional Theory (DFT) method and electrochemical measurements. The electrochemical impedance spectroscopy (EIS), potentiodynamic, potential zero charge (pzc) analysis and electrochemical noise (EN) measurements at various concentrations (from 0.1 to 10 mM) and immersion times were utilized in experimental part. The surface analysis was achieved scanning electron microscope (SEM) and contact angle measurements in the absence and presence of 10 mM PTCA. According to DFT results, PTCA exhibited 3.737 eV band gap and 8.130 Debye dipole moment which were a signal of potentially convenient corrosion inhibitor properties. PTCA has a remarkable corrosion inhibition capability to mild steel, which inhibited both anodic and cathodic corrosion rates, relying on it's physically adsorption on the metal solution interface and protection ability was increased with increasing PTCA concentration. The obtained adsorption equilibrium constant was 11.11 × 10³ M^-1 and calculated standard free energy of adsorption was ?33.03 kJ mol^?1. The determined activation energy values were 55.58 kJ mol^?1 and 96.86 kJ mol^?1 in 0.5 M HCl in the absence and presence of 10 mM PTCA, respectively. PTCA demonstrated a strong inhibition efficiency of 98.3%, after 168 h immersion, according to the EIS results. As a consequently, we recommend that PTCA is a convenient inhibitor in 0.1 M HCl for mild steel protection against corrosion.     

Synthesis,spectroscopic (FT-IR and NMR), DFT and molecular docking studies of ethyl 1-(3-nitrophenyl)-5-phenyl-3-((4-(trifluoromethyl)phenyl)carbamoyl)-1H-pyrazole-4-carboxylate

Research on Chemical Intermediates - Trifluoromethyl group containing pyrazole-3-carboxamide derivative is synthesized and the structure of the molecule (E3N5PC) has been verified by using FT-IR,...     

Development of a Diamond Nanoparticles-based Nanosensor for Detection and Determination of Antiviral Drug Favipiravir

This study developed a nanosensor for the detection and determination of favipiravir, a presumed drug that has potential therapeutic efficacy in treating COVID-19 patients, from tablets and serum samples. This nanosensor was obtained by adding the optimum amount of diamond nanoparticles into carbon paste. For the determination of favipiravir adsorptive stripping differential pulse (AdSDPV) and adsorptive stripping square wave voltammetry (AdSSWV) were used. Limit of detection values were found as 4.83×10⁻⁹ M and 2.44×10⁻⁷ M for bulk and 5.18×10⁻⁸ M and 4.38×10⁻⁸ M for serum samples using AdSDPV and AdSSWV, respectively. Recovery studies made of the tablet and serum produced satisfactory results.     

Sensitive,Accurate and Selective Determination of Cd(II) Using Anodic Stripping Voltammetry with in-situ Hg-Bi Film Modified Pencil Graphite Electrode After Magnetic Dispersive Solid Phase Microextraction

This paper describes a novel approach to detect Cd(II) using the combination of the differential pulse anodic stripping voltammetry and magnetic nanoparticle based dispersive solid phase microextraction as an efficient, green and accurate method. Currents of Cd(II) increased linearly in the range from 75 to 2000 ng L⁻¹ Cd(II) with a detection limit of 21.6 ng L⁻¹. The RSD values of 2.6 and 6.0 % for 1.00 and 0.10 μg L⁻¹ respectively showed that proposed method has an acceptable repeatability. Recovery values between 92.3 and 98.6 % showed that this approach can be successfully used for determination of Cd(II) in water samples.     

Spectroscopic imaging with volume selection by unpaired adiabatic pi pulses: theory and application

In NMR spectroscopy, volume selection can be advantageously achieved using adiabatic pi pulses, which enable high bandwidth and B(1) insensitivity. In order to avoid the generation of non-linear phase profiles and the subsequent signal loss caused by incoherent averaging, adiabatic pi pulses are usually used in pairs for volume selection in each spatial dimension. Alternatively, when performing spectroscopic imaging (SI), a high enough spatial resolution results in negligible phase dispersion within each pixel. This allows using only one pulse per selected spatial dimension, resulting in a reduced echo-time and reduced power deposition. In this work, the feasibility of such an approach is explored theoretically and numerically, allowing the derivation of explicit conditions to obtain SI images without artifact. Adequate spatial and spectral post-processing procedures are described to compensate for the effect of non-linear phase profiles. These developments are applied to SI in the rat brain at 9.4 T, using a new adiabatic sequence named Pseudo-LASER.     

Fiber-optic beam shaper based on multimode interference

A new method of fiber-optic based beam shaping is investigated both numerically and experimentally. A cylindrically symmetric method of lines (MoLs) is developed to simulate the device. The device is fabricated by fusion splicing a predetermined length of multimode fiber (MMF) to a single-mode fiber. The multimode interference (MMI) effects create ring-shaped field profiles at certain positions inside the MMF. The shaped beam can be used in medical applications requiring particular irradiation patterns.     

Diffusion changes in patients with systemic lupus erythematosus

BACKGROUND AND PURPOSE: Systemic lupus erythematosus (SLE) is an autoimmune disease in which almost all the organs are involved. Neuropsychiatric SLE is of one of the major concerns in the clinical evaluation of this disease. Routine magnetic resonance imaging (MRI) findings are often nonspecific or negative. In this study, we explored the use of diffusion tensor imaging in assisting with the diagnosis of SLE. METHODS: Data from 34 SLE patients (age range, 18-73 years) and 29 age-matched volunteers (age range, 29-64 years) were analyzed. MRI was performed on a 1.5-T clinical MR scanner with a quadrature head coil. The average diffusion constant (D(av)) and diffusion anisotropy maps [fractional anisotropy (FA)] were determined on a pixel-by-pixel basis. Regional diffusion measurements were made by region of interest in the genu and splenium of the corpus callosum (CC), anterior and posterior limb of the internal capsule (IC) and frontal lobe and thalamus. The diffusion distribution was fitted to a triple-Gaussian model. The mean of the brain tissue distribution was determined as a mean diffusion constant for the whole brain (BD(av)). Student's t test was used to determine the diffusion difference between SLE patients and control subjects. The SLE patients were separated into two groups according to their MRI results. A P value lower than .05 was considered to be statistically significant. RESULTS: Twenty of the 34 SLE patients with abnormal MRI results showed findings dominated by nonspecific white matter disease. The BD(av) and D(av) values of the frontal lobe, splenium CC and anterior IC were significantly higher in all SLE patients as compared with the control subjects. The SLE patients with normal MRI results also showed higher BD(av) and D(av) values in the frontal lobe, splenium and anterior and posterior limbs of the IC as compared with the control subjects. There was no significant difference in the D(av) values of the thalamus between the SLE patients and the control subjects. The BD(av) value in the SLE patient group was robustly correlated with the D(av) values of the frontal lobe, splenium and thalamus. These correlations were found to be similarly significant for the SLE patients with normal MRI findings. The diffusion anisotropy measurements showed that splenium CC had the highest FA value in both the control subjects and SLE patients. Overall, SLE patients had lower FA values in the genu and splenium CC as compared with the control subjects. In the group of patients with normal MRI findings, the FA values of the genu and splenium CC as well as the anterior IC were also lower than those in the control subjects. Pearson's correlation statistics revealed robust correlations between the measurements of D(av) and FA values in the SLE patient group. CONCLUSION: Quantitative diffusion imaging and diffusion anisotropy showed early changes in the brains of the SLE patients. Increased BD(av) and D(av) values of the frontal lobe as well as decreased anisotropy in the genu CC and anterior IC may represent preclinical signs of central nervous system involvement of SLE even when the routine MRI findings are negative or nonspecific. Quantitative diffusion analysis may prove to be useful in detecting the initial brain involvement of SLE and may enable monitoring of early disease progression and treatment efficacy.     

Graphene oxide-octadecylsilane incorporated monolithic nano-columns with 50 μm id and 100 μm id for small molecule and protein separation by nano-liquid chromatography

In this study, graphene oxide-octadecylsilane incorporated monolithic nano-columns were developed for protein analysis by nano liquid chromatography (nano LC). The monolithic column with 100 μm id was first prepared by an in situ polymerization using ethylene dimethacrylate (EDMA), 3-chloro-2-hydroxypropylmethacrylate (HPMA-Cl), and methacryloyl graphene oxide nanoparticles (MGONPs). MGONPs were synthesized by the treatment of 3-(trimethoxysilyl)propylmethacrylate (TMSPM) and GO. Tetrahydrofuran (THF) and dodecanol were used as the porogenic solvent. The resulting column was functionalized by dimethyloctadecylch lorosilane (DODCS) for the enhancement of hydrophobicity. The functionalization greatly improved the baseline separation of hydrophobic compounds such as polyaromatic hydrocarbons (PAHs). The optimized monolith with respect to total polymerization mixture was characterized by using Fourier-transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM) X-ray diffraction (XRD) and chromatographic analyses. The blank monoliths without functionalization exhibited poor separation while a good separation performance of MGONPs functionalized monoliths was achieved. The monolith with 100 μm id was evaluated in protein separation in nano LC using RNase A, Cytochrome C, Lysozyme, Trypsin, and Ca isozyme II as the test proteins. It was shown that protein separation mechanism was based on large π-system of GO and hydrophobicity of the monolithic structure. Theoretical plates number up to 57 600 plates were achieved. The nano-column with 50 μm id was also prepared using the same polymerization mixture under the same chemical conditions. These nano-columns were employed for protein separation by nano LC, and the dependence of both nano-column performance on the internal diameter was also discussed.